USI-7795 Operational Summary - English
Contents
1. erconnected CO alarm has sensed CO Get to fresh Stays Off Stays Off oe pause repeat 20 seconds air immediately and stay there until the alarm stops sounding Horn has stopped Off and Blinks on every On and Blinks off every Latching smoke LED indicator The unit has previously detected smoke and had sounding 5 seconds until reset 20 seconds alarmed Please follow the reset instructions to remove the latching LED Horn has stopped On and Blinks off every Latching CO LED indicator The unit has previously detected CO and had alarmed Off sounding second until reset Follow the reset instructions to remove the latching LED Smoke alarm is in silence mode To initiate silence mode press the test silence On and Blinks off every ey melee Stays Lit button when unit is in alarm The unit will go back into normal mode after 3 9 20 seconds aes 27 seconds Stavs Lit CO alarm is in silence mode To initiate silence mode press the test silence button y when unit is in alarm The unit will go back into normal mode after 3 9 minutes On and Blinks off every Low Battery Turn off AC Power and replace the 9V battery see user s manual for 50 seconds recommended type of battery Also check to make sure the polarity is correct for the battery terminals seconds 20 seconds 40 seconds seconds 20 seconds 40 seconds Please take all precautions if an alarm sounds by calling an Emergency Service and move into fresh air If there is no hazard pre2. me 11 ELECTRIC USI 7795 AC DC CO amp SMOKE ALARM OPERATIONAL SUMMARY ALARM AUDIBLE amp VISUAL SIGNALS CONDITION SOLUTION RED LED GREEN LED YELLOW LED Off and Blinks on every On and Blinks off every Me Power enoreseni 40 seconds 20 seconds p l Off and Blinks on every Off and Blinks on every Alarm is powered by battery backup AC Power is not present Check the breaker or fuse box for power If the breaker or fuse box looks normal call a licensed electrician 40 seconds 40 seconds POEP 3 Long Beeps 2 second Flashes on during the first pause 3 Long Beeps 2 cycle of 3 long beeps and The test silence button has been pressed The test sequence lasts for approximately Turns off when the 4 Turns on when the 4 second pause 4 Short turns off Flashes on in short beeps start short beeps start Beeps 2 second pause sync with two cycles of 4 4 Short Beeps short beeps 3 Long Beeps 2 second Flashes Once every On and Blinks off every Originating smoke alarm the unit has sensed smoke pause repeat second 20 seconds SA a eee Stays Off Om anie iis OIOV Non originating smoke alarm an interconnected smoke alarm has sensed smoke pause repeat 20 seconds 4 Short Beeps 2 second Flashes On in sync with off Originating CO alarm the unit has sensed CO Get to fresh air immediately and stay pause repeat horn there until the alarm stops sounding 4 Short Beeps 2 second On and Blinks off every Non originating CO alarm an int
3. sent press the test silence to see if it is Horn sounds when no functioning properly Clean the alarm follow the instruction in the user s manual hazard present Check that the alarm is mounted in the correct location refer to user s manual Check to see if other chemical solvents are present such as paint paint thinner etc These solvents can set off the alarm if a heavy presence is detected Single Chirp every 40 seconds Horn does not sound when other alarms are active or horn does not sound when inter connected alarms Press and hold the test reset button longer Verify the remote smoke amp CO alarms are receiving power and are functioning properly Turn off AC Power at the circuit breaker or fuse box and disconnect the alarm from the mounting bracket and make sure the connector plug is securely attached Have the wiring checked by a licensed test reset button is pressed electrician to make sure all the interconnect points are connected NOTE If you have any additional questions about your USI 7795 please contact our Customer Service Department at 1 800 390 4321 and we will gladly assist you 2009 USI ELECTRIC INC
Download Pdf Manuals
Related Search