HARMONY - Universal Hospital Services
Contents
1. Fluid Immersion Simulation System O Dolphin 4 t Auto Comfort Control Feedback Firm Fault Comfort Adjust Batter On y fd Locked Soft i aA Immersion Profile m e ae bar On Standby Bed Chair Stretcher Auto Vector _ Battery Low Je Additional Features To deflate surface for CPR Turn the CPR valve on the surface to the open position by aligning the arrows on the valve marked with a CPR flag Once aligned surface will rapidly deflate Storage Switch Located by the power cord turn the Storage switch to Battery On when the control unit is in use to enable battery power in the event of power loss Note The Storage Switch must be in the Battery On position to recharge POWER turns system from Standby to On A green light will indicate unit is on MODE toggles the system between Bed and Chair Stretcher mode Use Bed mode when connected to a mattress Use Chair Stretcher mode when connected to a seat cushion or stretcher pad IMMERSION PROFILE indicates system response to patient position change Green indicates optimal setting Yellow and red indicate that the system is in transition AUTO FEEDBACK will disolay amber when operating within normal parameters Should the system operate outside normal parameters the LED scale will change from amber to red It is normal for the Auto Feedback LED to move to red when the patient is transitioning on the therapy mattress Allow the Dolp2. g under battery power Battery Low illuminates when battery power is low ALARM sounds in the event of a fault condition Alarm can be disabled for up to 30 minutes by pressing the Alarm button To resolve the fault condition press the power button to engage standby mode and press the power button again to turn the system back on If the fault condition is not resolved call UHS to replace the unit LOCK locks out all controls The associated LED will illuminate when the lock is engaged
3. hin System to optimize If the LED lights remain consistently red after the system has had the chance to optimize manual adjustment with the Comfort Adjust arrows is needed Dolphin O Auto Comfort Control Feedback ne Fault Battery a roe Comfort Adjust o 2 O o Battery Soft E Q Immersion Profile O O i MID On Standby Bed Chair Stretcher Auto Vector GD Please see user manual for further operating instructions and www oncaremedical com for additional product information For further questions please call your local UHS office or call 1 800 847 7368 For use with OnCare Dolphin controller prefix TQM OnCare Dolphin is a proud offering of Universal Hospital Services Inc Fluid Immersion Simulation is a registered trademark of Joerns Healthcare LLC ONCARE DOLPHIN 0813 2013 Universal Hospital Services Inc All rights reserved Fluid Immersion Simulation System COMFORT ADJUST controls the firmness and softness of the mattress as indicated by the LED If patient is over 250 Ibs moving the Comfort Adjust one LED above the Auto Feedback LED may improve comfort If patient is less than 100 Ibs moving the Comfort Adjust one LED below Auto Feedback LED may improve comfort AUTO FIRM max inflates the surface to aid caregivers in boosts and transfers but will automatically turn off after approximately 15 minutes if not manually disengaged BATTERY ON illuminates when system is operatin
Download Pdf Manuals
Related Search