MD-334R Wireless light & sound siren User Manual
Contents
1. h i g back case at the four screw enter coding mode then trigger onthewall then presslightly the remote detectors etc It will sound when code successfully Delet coding when need to deletthe coding press Clr1 Clr2 key atthe sametime itwill give a long sound dee Then long sound again Release Clr1 Clr2 key then you have deletall code address Code to control panel set the panel at coding mode first then press key and then press the REC key on the sirenin 3 seconds Clr Out power line Mounting hole onthe wall 4 2 LED Bose MeeneED 5 Others When wireless device code with siren directly the siren Alarm LED will work as below after arm by remote the alarmLED jk will flash every one minute And only arm by remote the siren will sound when detector is triggered When arm on remote the alarm LED will flash two times and flash one time when disarm And if do notdisarm the siren will sound two minutes then stop automatically When connect out power no needto distinguish positive Coding status Power LED and negative poles LED2. ML 334S Wireless light amp sound siren User Manual 1 Introduction Wireless sirenis akind of alarm device with strong popularity It power from the adaptor or in set lead Appearance Internal wiring batteries Via wireless signal it communicate with alarm panel detector remote etc Which work with the same frequency as the siren and achieve flash light and alarm Pe sound when alarm happen And italso give promote sound when the remote which have code with the sire armor disarm Thissiren has anti tamper function to avoid fe fro er yro intentional damage ordismantle Whenalarm happens it make high alarm sound 2 Technical specifics Wireless communication distance 200m Trigger mode when arm by remote the detector and open airarea magnetic contact etc which had code with the siren will Voltage DC15 18V sound when they are triggered Orthe panel send signal Backup battery 12V to the siren andit make alarm Quiescent current lt 220 u A It can code with Max 16 wireless device Electric current lt 1 2A 3 Installation 4 Function 4 1 Code and delet coding voc ematea ves Drive outthe screwin the back T 3 1 Install cover andremove the face case Connect out power andthe power Install the back cover on the ii A Mark the hole pointon the green LEDON sai ees Coding press Rec and keep it will sound dee dee this tells it ountina Hole onihe wall B Aims the fourhole of the
Download Pdf Manuals
Related Search