Road Runner Installation Guide
Contents
1. original fuses 250V 2A 5 6 Installing the Voltage Cable Voltage battery Mute Ignition GND The following chart covers the manner by which the voltage cable should be connected to the car s electrical system Wire Color Function Must be connected to Ensure Red Includes fuse case To provide the handsfree Phone with fixed voltage 12V fixed voltage An additional fuse case is provided which must be connected to a fixed voltage source Ensure a 250V 2A fuse is used Includes fuse case phone after switching the ignition on and turn it off after car ignition is switched off Black To provide a fixed Car body minus Ensure the connection minus point is on the car body only Use a cable shoe tin screw and springy disc Green To turn on the cellular IGN voltage Determine the correct point with a voltmeter Ensure a 250V 2A fuse is used 5 7 Installing the Antenna 5 7 1 Where to Locate the Antenna e The preferred location for the antenna is on the right side of the windshield e If a cell phone or other communication system is installed in the car please locate the antenna as far away as possible from the other Phone s antenna Remember come car models such as Renault Megan and Renault Kangoo feature a radiation filter on the windshield Therefore it is necessary to install the antenna on a side or back wi2. Car Phone installation guide Table of Content 1 Carphone kit sasssa aska a ask a sr i ent 2 Installatiom Dlagram ass ss ss sidan a ra svik rara pr silki NSANS 3 Carphone layout siss suis a se sedeteesectteaessasee deavcasescsaddecanseseschawsssedosaddeisess 4 Preplanned Accessory Positioning cccccssssscecsssssceccsssscecssssceccessssessessssessessseeees 4 1 Plan Phone and Cradle Positions 4 2 Plan the Microphone s Position 4 3 Plan the Speaker s Position 5 Installing the Cradle and PHONG sssssscccsssssceccssssceccsssscecsssscsscssssssssessscssssssseeees 5 1 Where to Position Reminder 5 2 Installing the Cradle and Phone 5 3 Installing the Microphone 5 4 Installing the Speaker 5 5 Installing the Electrical Connections 5 6 Installing the Voltage Cable 5 7 Installing the Antenna 5 8 Installing the SIM card 6 Tro ble SNO tINB s na asna Da a RD Apps snar E E I BR 1 Carphone kit Car phone unit Car phone unit cables Speaker Microphone Power supply and fuse Cables Cradle with screws Optional Parts Description RF antenna External Auxiliary RF Antenna is not supplied part of the car kit It s an optional accessories and can be provided separately Recommended antenna eFrequency range 880 960 MHz for EGSM 900 and 1 71 1 88 GHz for GSM 1800 systems Impedance 500 Radiation H plane 360 Omni directional Polarization linear vertical Gai
3. e s location does not interfere with the vehicle or its accessories operation it should not interfere with opening the glove compartment or ashtray should not prevent access to the lighter moving the gear stick operating the hand break etc Do not install the Phone in front of the vehicle s air bag This restriction must be adhered to as in the case of an emergency the air bag blows up Warning and can fail to work properly Ensure the surface on which this Phone is installed is sufficiently strong to carry the weight and pressure which would be exerted on it When selecting the Phone s location please ensure the control cable connected to it does not interfere with the vehicle or its accessories operation Ensure it is safe and convenient to operate the Phone and read the display from the driver s seat Ensure the Phone would be protected from direct sunlight and humidity air conditioner openings Ensure the Phone would be protected from mechanical damage by the car s accessories 4 2 Plan the Microphone s Position e Install the handsfree Phone s microphone 30 40 cm away from where the driver speaks when he she is in their normal driving position e It is recommended to install the microphone inbetween car roof and windscreen glass and away from external sources of noise e Install the microphone in a different direction than the speaker so as to avoid echo 4 3 Plan the Speaker s Positi
4. fere with the vehicle or its accessories operation e Ensure it is safe and convenient to operate the Phone and read the display from the driver s seat e Ensure the Phone would be protected from direct sunlight and humidity air conditioner openings e Ensure the Phone would be protected from mechanical damage by the car s accessories 5 2 Installing the Cradle and Phone 1 Disassemble the cradle into its two parts 2 Install one of the cradle parts in the determined location in the car with 4 tin screws 4 If you are not able to locate the cradle properly please use a adjustable bracket from the station inventory Note 3 Install the second cradle part on the handsfree Phone using the 4 philips screws provided with this kit Only use the original screws provided with this kit Note 4 Connect the two cradle parts 5 Direct the control cable coming out of the Phone behind the car panel 5 3 Installing the Microphone The microphone is provided with a clip which makes it possible to install it inbetween the car roof and windscreen glass 5 3 1 Where to Locate the Microphone Reminder e Install the handsfree Phone s microphone 30 40 cm away from where the driver speaks when he she is in their normal driving position e It is recommended to install the microphone inbetween car roof and windscreen glass and away from external sources of noise e Install the microph
5. ling the Speaker 1 So dl Install the speaker at the right side of the main console at the front of the console Disassemble the screws connecting the a speaker to the hanger SII Install the hanger using the 2 tin screws Direct the speaker cable behind the mat located at the bottom of the car Ensure the cable does not interfere with the vehicle or its accessories operation Ensure the speaker cable is not exposed to damage by the passengers 5 5 Installing the Electrical Connections The electrical cable is provided separately from the control cable Before installation begins connect the four leads which include the 2A fuses using a red or blue crimp sleeve as appropriate Please note sharp edges or moving parts which may damage the wires Warning The value for the fuses provided with the kits must not be changed The kit is appropriate only for a 12V vehicle In case of converting any other kit model into this kit please change the power cable The electrical cables should be directed as follows e So as not to disturb the driver or passengers e So as not to pass near the car s sharp or moving parts The external voltage connection is located under the dash board or close to the fuse box depending on the car model Note In new vehicles a cellular phone connection can be found near the fuse box See the car s user s manual under Info Only use the kit s
6. mes occurs in transition between coverage areas Ask whether noise occurs when window is open Explain that the Phone is an amplifying system that receives all environmental noise and therefore it is preferable to speak with a closed window Check whether microphone and antenna are installed on the same side If they are install microphone as per the instructions Check whether eye contact exists between speaker and microphone If it does change location accordingly Check for improper voltage connection check whether voltages are connected as per instructions Change voltage source in accordance with instructions Phone switches on and off by itself Check minus connection Black wire connect minus to car body Check voltage contacts Tighten loose contacts Phone switches on and off by itself Check fuse Check connection to voltage source green cable Replace fuse Tighten connection to voltage source Ensure a 250V 2A fuse is used Phone does not switch off after switching off car Phone does not switch off after switching off car Check connection to power source green cable Check connection to power source Check fuse red cable Tighten connection to power source Replace fuse Tighten connection to power source 7 Appendix Finding IMEI code 1 Type code 06 2 Find locking code 5625
7. n 3 dBi 900 MHz 2 dBi 1800 MHz SWR in bandwidth TX band RX band GSM 900 lt 1 8 lt 2 0 GSM 1800 lt 1 4 lt 1 8 Max Power CW 30 C 10 Watts Connector FME male Additional Information RF cable RG58U PVC coated 5 Meters Operating Temperature 30 to 85 Degree C Heat and UV stabilized So Auxiliary is not supplied part of the car kit It s an optional accessories and can be provided separately 2 Installation Diagram om Privacy Handset se Holder Optional rr Active GPS Antenna Roadrunner GPS Only Antenna Speaker Q 2A Fuse icroph uous aN9 INN AZI 3 Carphone layout Display OK key in SIM E SIM card slot Left soft button Right soft button Reset PIN Send button for dialing answering End button a call Navigation button Power ON OFF USB connector 4 Preplanned Accessory Positioning Positioning of all accessories must be planned in advance before installation begins e Ensure that no wire braids go through locations where Phone accessories are to be installed e Ensure that any parts of the handsfree Phone will not interfere with the vehicle or its accessories operation 4 1 Plan Phone and Cradle Positions The best way to determine the Phone s position to the customer s full satisfaction is to locate it when the customer is beside you and obtain Note his her approval e Please ensure the Phon
8. ndow 4 In vehicles with air bags on the beam where the antenna cable passes the antenna cable should be directed behind or beside the airbag Note 5 7 2 Installing the Antenna 5 7 2 1 Installing the External Adapter and Antenna Rod 1 Thoroughly clean the location intended for installation on both sides of window using a cloth and detergent Allow the spot to dry before you continue 2 Carefully remove the clear plastic cover protecting the external adapter the antenna base 3 Locate the adapter on the cleaned location Ensure the adapter is stably placed in a horizontal position parallel to the window border 4 Carefully press the antenna base toward the window Ensure all corners of the adapter are attached to the window and the antenna rod is in a vertical position 5 7 2 2 Installing the Internal Adapter and Coaxial Cable 5 Carefully remove the clear plastic cover protecting the internal adapter 6 Move the adapter on the inside of the window toward the antenna base the external adapter and direct the adapter so as to fully overlap the base 7 Carefully press the antenna adapter to the window Ensure all adapter corners are attached to the window 8 Direct the antenna s coaxial cable along the car beam Ensure the antenna cable does not get damaged Do not direct the microphone cable and antenna cable together on the same beam lintel Note 9 When completing the cable s ins
9. on The speaker and microphone installed inbetween car roof and windscreen glass above the driver must face different directions Note Do not hide the speaker inside the dash board If you cover it sound quality will be lowered Note e Locate the speaker at the right side of the main console at the front of the console in a location where it would not bother the driver or passengers but would sound best 5 Installing the Cradle and Phone FF Handsfree Phone Cradle Adjustable bracket 5 1 Where to Position Reminder The best way to determine the Phone s position to the customers full satisfaction is to locate it when the customer is beside you and obtain Note his her agreement e Please ensure the Phone s location does not interfere with the vehicle or its accessories operation it should not interfere with opening the glove compartment or ashtray should not prevent access to the lighter moving the gear stick operating the hand break etc Do not install the Phone in front of the vehicle s air bag This restriction must be adhered to as in the case of an emergency the air bag blows up Warning and can fail to work properly e Ensure the surface on which this Phone is installed is sufficiently strong to carry the weight and pressure which would be exerted on it e When selecting the Phone s location please ensure the control cable connected to it does not inter
10. one in a different direction than the speaker so as to avoid echo and ensure there is a distance of at least 1 5 meters between them 5 3 2 Installing the Microphone 1 Using the clip install the microphone inbetween the car roof and windscreen glass Direct the microphone cable along the roof behind it so as not to be seen Continue directing the microphone cable along the left beam on the driver side Direct the cable under the dash board to the connection point of the cable with the control cable connected to the Phone Ensure the microphone cable and antenna cable are kept away from each other Note Ensure the microphone cable is not in contact and does not interfere with the car pedals and steering wheel stick 5 Connect the microphone cable plug to the correct port on the control cable 5 4 Installing the Speaker x tt 5 4 1 Where to Locate the Speaker Reminder Note The speaker and microphone installed inbetween the car roof and windscreen glass above the driver must face different directions If the speaker and microphone face each other this will cause echo Note Do not hide the speaker inside the dash board If you cover it sound quality will be lowered e Locate the speaker at the right side of the main console at the front of the console in a location where it would not bother the driver or passengers but would sound best 5 4 2 Instal
11. tallation and reaching close to the control cable connected to the Phone please leave approximately 30 cm of additional wire and cut off the unnecessary extra cable 10 Press a connector at the end of the cable Use the original plug and pressers only 11 Examine the antenna and cable s proper working order with an efficiency meter 5 8 Installing the SIM card See SIM card installation position Note Insert the SIM card when the phone is off 6 Trouble Shooting Symptom No reception What to Check Check whether connector is correctly connected to the cable use an efficiency meter What to Do Replace connector Check if internal and external antenna base is correctly attached Attach antenna base Check proper working order of antenna cable Replace antenna cable Other party cannot be properly heard User is not heard by the other party Check speaker s proper working order Replace speaker A Phone problem may exist Check speaker location Check microphone and contacts Replace Phone Change location Tighten microphone connector to the Phone Check routing of microphone cable Change routing of microphone cable Check microphone s proper working order Replace microphone A Phone problem may exist Replace Phone Noise is heard Ask whether noise always occurs in specific geographical areas Explain that reception trouble someti
Download Pdf Manuals
Related Search