User Manual - CRS Medical
Contents
1. e clean and disinfect the device Please dispose of following local laws and regulations for recycling environmental protection please sort the packaging before disposing Dispose and recycle all packaging according to your local laws and regulations Packing is raw material and therefore recyclable On behalf ms For more detailed information on proper disposal please contact manufacturer Rev 3 1 page 14 POWERCHARGER iB SERVICE MANUFACTURER CRS medical GmbH WW Loherstrasse 6 BB E CRS medical D 35614 Asslar IB T 49 0 6441 38331 0 F 49 0 6441 38331 232 info crs medical com www crs medical com Rev 3 1 page 152. e of charging times Charging 2103733001 M M Series CCT ZOLL SurePower 8019 0535 01 E RSeries AED Pro ZOLL Lead Acid 8000 0299 08 EL M M Series CCT ca 30h AED Pro ZOLL Smart 8004 0103 08 3 0h ZOLL Smart Ready 8004 0104 08 FIM MSeries CCT ZOLL Smart XL 8000 0687 08 45h ZOLL Smart Ready XL 8000 0500 Exp senes ZOLL Propaq MD 8000 0580 01 Propaq MD the times listed are valid for new batteries discharged in a ZOLL defibrillator After a full charging cycle not all five LEDs of the battery level indicator may light up when pressing the battery capacity test button A possible reason is that the PowerCharger performs no recalibration restoring battery level indicator accuracy and uses a charging technology that extends the lifetime of the battery This charging algorithm also uses a charging voltage lower than the highest possible voltage of the battery Specifications subject to change without notice iB ACCESSORIES Currently not available Rev 3 1 page 7 8 OPERATION Connecting PowerCharger Connect the round plug on the AC DC power adapter with the round socket on the rear of the PowerCharger and the main plug into an AC socket e g with 120 VAC Automatic Self Diagnostic Once the PowerCharger has been connected to a power supply it will automatically conduct a self diagnostic This should take approximately three seconds in which time all 4 LEDs should light
3. er successfully completing this cycle the battery will automatically fully recharged indicated by the orange LED CRG charge being lit As a result of these three steps it may take up to 24 hrs for a complete cycle to finish owitching from the discharging to charging function is possible by removing and reinserting the battery Rev 3 1 page 9 POWERCHARGER LED LIGHTS ON green PowerCharger connected to power CRG orange PowerCharger is charging battery LED flashing indicates if battery is empty or charging LED is lit when battery fully charged ERR red error see below DISCRG orange discharging of battery LED flashing Rev 3 1 page 10 i TROUBLESHOOTING Error Indication Error Type Possible Solution LED ON does not light No power supply Check the power supply connection Check if the green LED on the power adapter is lit If yes PowerCharger is defective If no Power adapter is defective LED ERR is flashing Device failure e g Hemove power supply overheating and let device cool LED still flashing battery voltage is too high Discharge the battery by using a ZOLL Defibrillator Monitor If device is plugged in again and LED is still flashing PowerCharger is defective LED ERR is on Charging error Hemove and re insert battery Rev 3 1 page 11 Error Indication Error Type Possible Solution LED CRG is not on Battery error Remove and re in
4. i User Manual PowerCharger ZOLL Lead Acid batteries ZOLL SurePower batteries ZOLL Propaq MD batteries and PowerDrive batteries 3 DE 8 CRS medical CE POWERCHARGER 8 TABLE OF CONTENTS MC ICON aid A aaa 3 Safety WISUUCHONS EE 4 saec 5 SG OOS ODIN 5 5 TECHNO Dal ras da a 6 hlee ccsj V Secus M 8 LED QRO sas crie RN TR 10 PROUD NONO emera ra torah AERE NETE wa yen electors 11 Cleaning and DISIRIODHOEYL us cose Ets pasa ha oie duties E d ava DS Sbt 12 VID Ol HT E 13 Reie T 14 Service Manutfacthurer cesses nnns 15 Rev 3 1 06 02 2012 page 2 POWERCHARGER Welcome Thank you for choosing PowerCharger To ensure safe operation we advise you to familiarize yourself with this user manual please read this manual carefully before use The manufacturer does not assume liability for damage and or failure due to incorrect use or installation Keep this manual in a safe place for future reference We advise you to pay particular attention to the safety instructions Rev 3 1 page 3 POWERCHARGER EB SAFETY INSTRUCTIONS Please also reference the user manual of your battery Always check that the battery is securely inserted and it is properly connected to the PowerCharger Take note of what the LEDs on the top side of the PowerCharge
5. r indicate Should the PowerCharger have been damaged through a blow or fall or should liquids have entered the case it should not be used again until all functions have been properly checked The PowerCharger cannot be used with an autoclave Do not allow liquids to enter the PowerCharger Do not insert any objects into the PowerCharger case Please only use the recommended accessories Rev 3 1 page 4 POWERCHARGER iB APPLICATION The PowerCharger is exclusively for use with the following rechargeable batteries ZOLL lead acid batteries ZOLL SurePower Lilon batteries ZOLL Propaq MD batteries PowerDrive Lilon batteries The PowerCharger can be used with a DC power supply from 11 to 30 VDC An alternating current power supply from 100 to 230 VAC 50 60Hz can also be used however only with the original power adapter P N 6309933029 iB SCOPE OF DELIVERY m 1 PowerCharger P N 2103733002 1 AC DC power adapter for PowerCharger P N 6309933029 with different plug adapters for AC DC power supply E i User s manual Rev 3 1 page 5 POWERCHARGER TECHNICAL DATA Dimensions L 22 5 cm x H 9 0 cm x B 10 0 cm Weight 765 g 27 Oz Input Voltage 11 30 VDC Power consumption 15W Charging current 1 0 A max Operating Temp 0 C to 50 C 32 F to 120 F Optimal Charging Temp 15 C to 35 C 60 F to 95 F Storage Temp 40 C to 70 C 40 F to 160 F Rev 3 1 page 6 Tabl
6. sert with battery inserted battery If LED still does not light battery is defective LED DISCRG does not Battery error Remove and re insert light with battery is battery inserted and DISCRG button has been pressed If LED still does not light battery is defective For further information please contact the manufacturer CLEANING and DISINFECTION For cleaning or disinfection please remove the battery from the PowerCharger and disconnect the power supply The surface of the PowerCharger can be cleaned with a mild surface cleaner and a moistened cloth For disinfection please use standard disinfectants and make sure they do not damage plastic surfaces A The PowerCharger is not for use with an autoclave Do not allow liquids to enter the device Rev 3 1 page 12 POWERCHARGER B SYMBOLS A See accompanying documents user manual C CE Declaration of conformity according to EU directive 2004 108 EG X Operating Temperature 5 C to 455 C L 4 Optimal Charging 15 C to 35 C Storage Temperature Humidity 30 C to 60 C Humidity 5 to 95 relative non condensing P N Part Number S N Serial Number s Keep Dry j Top Recyclable Fragile goods eS gd Manufacturer e1 Declaration of conformity according to EU directive 72 245 EWG EEC as last amended by 2009 19 EG Rev 3 1 page 13 POWERCHARGER DISPOSAL Before disposing of the PowerCharger pleas
7. up Should one of the LEDs not light up this indicates that the PowerCharger is faulty and must be sent in for repair If the self diagnostic is successfully concluded the green ON LED will remain lit Inserting the battery into the PowerCharger Place the battery into the PowerCharger so that after insertion an audible click is heard and the battery is secured in the docking station The battery has been made to fit the docking station in a predefined way to ensure that the charging pins always connect Never force the battery into place With every insertion make sure the battery is secured and properly connected to the PowerCharger If correctly inserted the orange LED CRG Charge will be lit Rev 3 1 page 8 Removal of the battery from the PowerCharger Push the release tab towards the battery and pull the battery out of the PowerCharger AN The casing of the PowerCharger as well as the battery may feel warm after unusually long charging times Charging and Discharging Charging begins as soon as the battery is connected to the PowerCharger and is indicated by the orange CRG Charge LED flashing When the charging cycle is completed the orange CRG LED will remain lit Pressing the DISCRG discharge button will start the discharging cycle during this sequence the battery will initially be fully recharged then completely discharged This cycle will be indicated by the orange LED DISCRG flashing Aft
Download Pdf Manuals
Related Search