5-Button Control Keypad with Temperature Display for VSC
Contents
1. 5 Button Control Keypad with Temperature Display for VSC BSC Model L1004B KP V2 Understanding the Unit 1 Display SCREEN ON Unit is displaying temperature speed time remaining or error information When on the screen displays temperature value in F Speed level When on the screen displays speed level from 1 to 10 When on the screen displays the time remaining in minutes Power button 1 press Pump ON Light ON LED ON 2 press Pump OFF Light OFF LED OFF Display Idle Speed goes down screen displays speed Min speed level is 1 Pulse mode button 1 press Pulse mode ON LED ON D 2 press Pulse mode OFF LED OFF Light button 1 press Light ON LED ON Features 1 Pulsating Mode In this mode the pump speed varies automatically with a cycle period of approximately 10 seconds 2 By default the pump speed level is set to 10 When the pump is turned OFF the speed level during the time of turning OFF is saved 3 When the pump is turned ON the pump speed is softly ramped up to maximum speed in about 5 seconds and then the pump speed goes back to saved speed level default level During the 5 second soft ramp up the Speed Speed and Pulse mode button are disabled 4 The unit has 20 minute in built timer So the unit will shut down after 20 minutes of operation and save the speed level for next cycle use 6 Speed button Speed goes up screen displays speed Max speed level i2. TLET Connect one end to the back of keypad and the other end to the button 1 RJ25 Cable port of VSC BSC 2 Temperature Probe Connect the square female end of the probe to the male end of the keypad Drop the probe on water Steps to Follow Connect keypad to VSC BSC using RJ25 cable Connect the temperature probe on the back of keypad Connect water level sensor jumper on the sensor port of VSC BSC Connect Pump to the Pump outlet and Light to the Light outlet of the VSC BSC Connect power cable to the power outlet and turn on the unit using power button on keypad OE te 2D Drawing 54 A R 88 L o ad R88 Backside view of keypad All dimensions in inch THANK YOU FOR BUYING LURACO TECHNOLOGIES PRODUCTS LURACO TECHNOLOGIES INC 1132 107 STREET ARLINGTON TX 76011 TEL 1 817 633 1080 FAX 1 817 633 1085 WWW LURACO COM Cup
3. s 10 Note Make sure that the water level sensor or a jumper is connected to VSC box Otherwise the unit will not turn on Error Codes The display screen has special error codes to determine and debug possible error conditions They are as follows There is a connection problem between VSC BSC to keypad The power button LED also blinks fast to indicate the connection error Try reconnecting the cable and reset the power on VSC BSC The temperature probe on the back of keypad is not connected Try re connecting probe again E 1 C LO Temperature value is Below 50 F Temperature value is Above 140 F 2 No H20 The power button LED also blinks slowly to indicate this error The unit will not turn on because the water level sensor is detecting no water in tub If water level sensor 1s not used a jumper should be connected at water sensor port of VSC BSC The unit shuts down due to over heating Check the fan connection in the VSC unit Understanding the Setup KEYPAD TEMPERATURE SENSOR TEMPERATURE To measure tub water SENSOR CONNECTOR temp pill VSC CONTROLLER WATER SENSOR PROBES LIGHT TRANSFORMER JUMPER a OR WATER SENSOR co gi LIGHT 1A MAX SLAVE PORT RJ 25 CABLE BUTTON PORT WHITE NEUTRAL ELECTRICAL FEEDER OUTLET BLACK LINE 120V 20A GREENIGROUND p WALL OU
Download Pdf Manuals
Related Search