Home

User Manual / Parts List

image

Contents

1. the heating elements have high surface temperatures That is why com bustible materials must be kept at a safe distance from the heater and care must be taken that no combustible particles enter the heater with the air sucked in by the fan Keep the heater clean of dust at any time Dust may cause fire when heated Make sure that the fan blades may rotate unobstructed at all times Do not block air intakes or exhaust in any manner LIMITED WARRANTY PATRON heater products are professional construction heaters They are warranted for twenty four 24 months from original date of purchase The warranty does not cover products modified outside our factory damage or failure caused by acts of God abuse misuse use on other than rated voltage abnormal usage faulty or improper installation failure to provide recommended maintenance or any repairs other than those provided by an authorized PATRON service THERE ARE NO OBLIGATIONS OR LIABILITIES ON THE PART OF PATRON PRODUCTS INC FOR CON SEQUENTIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THE PRODUCT OR OTHER INDIRECT DAMAGES WITH RESPECT TO LOSS OF PROPERTY REVENUES OR PROFIT OR COST OF REMOVAL INSTALLATION OR REINSTALLATION THIS WARRANTY CONSTITUTES THE EXCLUSIVE REMEDY OF ANY PURCHASER OF EQUIPMENT SOLD BY THE MANUFACTURER AND ITS DEALERS AND DISTRIBUTORS AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED During the warranty period Patron Produc
2. EAKER See paragraph Technical specifications in this manual for cor rect amperage rating NOTE Check your heater to make sure it is wired for either one or three phase use 3 Set the room thermostat to a temperature above the ambient room temperature by turning the knob Note The heater will start heating only if the thermostat calls for heat meaning that it is set to higher than pre vailing ambient temperature 4 Turn the main switch into position 2 Output 13 000 W for partial heating output or into position Output 19 000 W for full heating output THE HEATER WILL NOW OPERATE AUTOMATICALLY CON TROLLED BY THE THERMOSTATS 5 When no heating is needed turn the main switch into position 1 Ventilation only for air circulating pur poses TO STOP HEATING 1 Turn the main switch into position 0 standby 2 Letthe fan cooldown heater for 2 3 minutes 3 Disconnect the power supply plug NOTE THE HEATER IS EQUIPPED WITH AN OVERHEAT LIMIT SWITCH WHICH MAY CAUSE THE HEATER TO STOP CHECK AND REMOVE THE CAUSE FOR OVERHEATING BEFORE RESTARTING RENTQUIP USA INC 1 800 818 1199 WWW PATRONPRODUCTS COM patron 18E PRODUCT MANUAL MAINTENANCE WARNING NEVER SERVICE THE HEATER WHILE IT IS PLUGGED IN RUNNING OR HOT SEVERE BODILY INJURE OR ELECTRIC SHOCK MAY OCCUR ONLY QUALIFIED PERSONS ARE ALLOWED TO OPEN HEATER FOR SERVICE NO USER SERVICE ABLE PARTS INSIDE e Keep heater clean Use pressurized a
3. M n 18E PRODUCT MANUAL WIRING DIAGRAM 240V 60 Hz 1 NO SINGLE PHASE MODEL ONLY Ambient Thermostat 1 2020 C1 Contactors amp Coils 22663 ue T H RE E HAS E TC Cooldown Thermostat 21100 Fan Mot 14201 M O DEL O NLY Overheat Limit Switch 21200 RA RO Heating Element 42320 Rs A ala Overheat Limit Switch discharge 21200 Main Switch 76505 1 Terminal Block 36704 RENTQUIP USAINC 1 800 818 1199 WWW PATRONPRODUCTS COM PATRON PRODUCTS A DIVISION OF RENTQUIP 1 800 818 1199 www patronproducts com
4. ir to blow fan blades clean Note Use moderate pressure to avoid damage to fan blades e Inspect heater before and after each use e The fan motor is sealed and has permanently lubricated bearings STORAGE When not in use the heater must be disconnected from power source cleaned of dust and stored in a dry place The power supply cord should be loosely wound around the handle of the heater TECHNICAL SPECIFICATIONS 2 STAGE SELECTOR 19 000 or 13 000 CFM 32 100 F 0 40 C ibs RENTQUIP USAINC 1 800 818 1199 WWW PATRONPRODUCTS COM patron 18E PRODUCT MANUAL SPARE PARTS DIAGRAM PATRON 18E 1 SINGLE PHASE MODEL ONLY 401607 Bottom Plate 401606 Front Panel 9 Inner Mantle incl Air Cone 7 22663 Contactor 3 Heater 26605 Main Switch Asembly 21200 Overheat Limit Switch 21100 Cooldown Thermostat 20212 Thermostat Knob 36615 Terminal Block 18E 1 37910 Plastic Bracket 40016 Locking Clamp 20210 Ambient Thermostat 1 402213 Bracket for Inner Mantle 42320 Heating Element Heaten 42320 Heating Element 9 Heater RENTQUIP USA INC 1 800 818 1199 WWW PATRONPRODUCTS COM patron 18E PRODUCT MANUAL SPARE PARTS DIAGRAM PATRON 18E 3 THREE PHASE MODEL ONLY 6 401609 Inner Manti ne Ar Gone 5 539 Rear Gal o s3200 Front Grit Overheat Limit Switch JA Sa RENTQUIP USAINC 1 800 818 1199 WWW PATRONPRODUCTS CO
5. not cover cord with throw rugs runners or the like Arrange cord away from traffic area and where it will not be tripped over 8 To disconnect heater turn controls to off then remove plug from outlet 9 Connect to properly grounded outlets only 10 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an elec tric shock or fire or damage the heater 11 To prevent a possible fire do not block air intakes or exhaust in any manner Do not use on soft surfaces where openings may become blocked 12 A heater has hot and arcing or sparking parts inside Do not use in areas where gasoline paint or flammable liquids are used or stored 13 Do not point to flammable materials 14 Use heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons 15 Always plug heaters directly into a wall outlet receptacle Never use with an extension cord or relocatable power tap outlet power strip 16 SAVE THESE INSTRUCTIONS RENTQUIP USA INC 1 800 818 1199 WWW PATRONPRODUCTS COM patron 18E PRODUCT MANUAL GENERAL INFORMATION FOR USER Patron electric heaters are designed for professional use The heat is generated in sealed heating elements inside the inner mantle of the heater Heated air is then dis tributed by an electric motor driven fan blowing air through the heater Although effectively cooled by the fan
6. palcon 18E ELECTRIC FAN HEATER MODEL 18E 1 Single Phase MODEL 18E 3 Three Phase PRODUCT MANUAL Ld paon IMPORTANT READ AND UNDERSTAND THIS MANUAL BEFORE ASSEM BLING STARTING OR SERVICING THE HEATER IMPROPER USE OF HEATER CAN CAUSE SERIOUS INJURY KEEP THIS MANUAL FOR FUTURE REFERENCE FOR PROFESSIONAL USE ONLY OCTOBER 2014 REVISION RENTQUIP USA INC 1 800 818 1199 WWW PATRONPRODUCTS COM Pa n 18E PRODUCT MANUAL IMPORTANT INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS HEATER 1 This heater is hot when in use To avoid burns do not let bare skin touch hot surfaces Use handle when moving this heater Keep combustible materials at least 6 feet 2 meter from the front of the heater and keep them away from sides and rear 2 Extreme caution is necessary when the heater is used near children or invalids and whenever the heater is left unattended 3 Always unplug the heater when not in use 4 Do not operate any heater with a damaged cord or plug or after the heater malfunctions has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair 5 Do not expose to rain water spray or dripping water 6 This heater is not intended for use in bathrooms laundry areas and similar indoor locations Never locate the heater where it may fall into a bathtub or other liquid container 7 Do not run cord under carpeting Do
7. ts will at its sole option repair or replace any defective parts or prod ucts returned freight prepaid to Patron Products or such other location as Patron Products may designate Returned products must be packaged carefully and Patron Products shall not be responsible for damage in transit When returning parts the owner must provide the model number of the product and the nature of dif ficulty being experienced This warranty does not oblige Patron Products to bear the cost of labour in replac ing any assembly unit or component or part thereof nor does the company assume any liability for secondary charges expenses of removal or installing freight or damages There will be charges rendered for product repair after our warranty period has expired Proof of purchase including date must accompany request for in warranty service RENTQUIP USAINC 1 800 818 1199 WWW PATRONPRODUCTS COM patron 18E PRODUCT MANUAL OPERATION REVIEW AND UNDERSTAND ALL WARNINGS IN THIS MANUAL THEY ARE ESSENTIAL FOR SAFE USE OF THE HEATER FOLLOW ALL LOCAL CODES TO START HEATING 1 Place the heater on a stable and level surface Make sure that no explosive or combustible fumes or dust are present MINIMUM CLEARANCES FROM COMBUSTABLE MATERIALS OUTLET 6 feet SIDES 1 foot TOP 2 feet REAR 2 feet FLOOR COMBUSTABLE 2 Connect power cord of heater into 240 V 60 Hz power source THE POWER SOURCE MUST BE EQUIPPED WITH A CIRCUIT BR

Download Pdf Manuals

image

Related Search

Related Contents

Téléphone mains libres à de ux lignes Mémoire de 12 numéros  Link-Belt 350 X2    Sistema de administración FRIL - manual usuario  ZyXEL Communications 2602HWL-D3A Network Router User Manual  Weekly Report: 4/10/14  HQ Power VDL400RF  Trust GXT 280  PKZIP 6.0 for the X Window System Getting Started  Manual de Instruções  

Copyright © All rights reserved.
Failed to retrieve file