Model: APT-2000 - RF-Link
Contents
1. p gt TM 1 Package Content N STAL L ATIO N G U D E 2 Panel Control and Function 3 Setup Guide M O d e z A PT 2 0 0 0 4 Important Safety Information PC to TV CONVERTER Note Please power off both your PC and APT 2000 prior to setup General Specification Power Input Voltage DC 5V 0 1V Operation temperature amp humidity 0C 50 C less than 85 Storage temperature amp humidity 20C 70C_ less than 90 Supported display graphics RF Link Araneus USA Inc Tel 510 413 5885 44845 Industrial Drive Fax 510 651 5995 Fremont CA 94538 U S A www rflinkusa com 1 Package Content 7 Accessories 1 Please make sure all accessories shown as below are enclosed please contact your dealer for any missing part USA Standard 1 APT 2000 Unit x 1 2 Audio Adapter Cable x 1 1 Power Adapter 120V x 1 2 3 5mm Stereo Jack to 2 5mm Stereo Plug x 1 3 USB to DC Plug Cable x 1 4 Video RCA Cable x 1 European Standard 1 Power Adapter 230V x 1 2 3 5mm Stereo Jack To 2 5mm Stereo Plug x 1 5 S Video Cable x 1 6 VGA Cable x 1 2 Panel Control and Function 1 DC IN DC power input 2 VGA OUT D SUB Jack output to PC monitor 3 VGA IN D SUB Jack input from source PC 4 S VIDEO S Video Jack output to AV Equipment 5 VIDEO OUT Video Jack output to AV Equipment 6 SIZE Automatically fine tune the image and locate it at central point 7 UP U2. ke apart this product provided as an accessory This product should be operated only under power supply Do not overload wall outlets and 4 HSIZE extension outlets as this can result in the risk of fire or electric shock 1 VSIZE gt 4 BRIGHINESS5S gt CONTRAST gt o NOTE This equipment has been tested and found to comply with the limits regulated by FCC and CE These limits are designed to provide reasonable protection 4 SATURATION against harmful interference in a residential installation This equipment FLICK gt SHARPNESS gt fie OSD BACKGROUND generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction may cause harmful interference to radio communications The change or modifications no expressly approved by the party responsible for compliance could void the user s authority to operate the equipment To comply with the FCC RF exposure compliance 7 1 OSD FUNCTION MENU INSTRUCTION requirements no change to the antenna or the device is permitted Any HSIZE To adjust the width of screen change to the antenna or the device could result in the device exceeding the VSIZE To adjust the height of screen RF exposure requirements and void user s authority to operate the device BRIGHTNESS To adjust the brightness of screen CONTRAST To adjust the contrast of screen HUE To adjust the hue of screen STURATION To adjust
3. p position control or increment function 8 ZOOM ZOOM and UN ZOOM 9 LEFT Left position control 10 MENU ON OFF OSD menu 11 DOWN Down position or decrement function 12 RIGHT Right position control 3 Setup Guide PCMONITER PC 1 4 AV Equipment 1 Please power off both PC and APT 2000 prior to set up 2 Connect either RCA cable to Video IN port yellow or S Video Cable to S Video port on TV and connect the other end of either cable to APT 2000 APT 2000 not only support from PC to TV directly but also work with RF Link s AVS 5811 to send AV signal wirelessly to any TV at home 3 Connect VGA cable to VGA OUT port on PC and the other end to VGA IN port on APT 2000 4 Connect PC monitor to VGA OUT on APT 2000 5 Plug in power adapter to DC IN port on APT 2000 and the other end into a power outlet The second power source can also be obtained by connecting an USB to 4 Important Safety Information DC Plug Cable to DC IN port on APT 2000 and the USB port on PC To prevent fire or shock hazard do not expose this product to rain and Turn on PC power moisture For example do not use near a bathtub washbowl kitchen sink or Push MENU button on top of APT 2000 the screen will show the OSD laundry tub in a wet basement or nearby a swimming pool To avoid electric FUNCTION MENU below If adjusting the image quality is desired shock do not ta
4. the saturation of screen FLICK To adjust the twinkle of screen SHARPNESS To adjust the sharpness of screen OSD BACKGROUND To change the color of OSD background
Download Pdf Manuals
Related Search