USER`S MANUAL
Contents
1. any more fuel Close the fuel filler bolt and proceed in accordance with section B 3 the blue indicators flashes you can refuel see section B 2 and turn on the device see section B 3 or close the fuel filler bolt and activate the device by following the point B 3 F Information and warning alert In order to increase safety the Wall Fire is equipped with an electronic system to keep the operation safe In the case of a dangerous situation the device immediately triggers alarms LEGEND G Q bes is The indicator is off ae The indicator flashes The indicator is blinking af Copyright Planika Sp z 0 0 www planikafires com 6 Information and warning alerts SOUND SIGNALS Control Panel Pr 5 Indicators 5 E procedure 2 E S 8 3 AS If the fire is not visible NO Make sure the device is properly connected to the power POWER supply 1 If fire the device i yoy Da a tire the device S Do not leave the device unattended by an adult in operation 2 The cevice is ready for You can run the device in accordance with section B 3 operation 3 No fuel in the tank Fill the fuel in accordance with B 2 paragraph Initial start up of the device 4 Wait for the appearance of fire the light goes off Work tect inst t a S prot cteo agains Allow the device to cool down After cooling the device rapid restart of the hot device ied paras y 5 the red indicator will tur2. act and within a radius of 1 m 3 28 ft around the device Do not place near curtains net curtains etc Itis obligatory to have a carbon dioxide or dry chemical extinguisher placed nearby the device The enabled device must not be moved Wait for complete fuel burn out disconnect the power supply and cool down the elements before moving the device The device should not be left without adult supervision Prevent handling of the device by persons not trained Do not attempt to make changes or repairs to the construction of the device on your own Repairs can be made only by a person trained to service the device Do not pour FANOLA liquid to a furnace as it may cause damage of the device and cause fire Pouring FANOLA liquid to a burning furnace may cause a sudden ignition and can cause fire burns and a risk to life Do not heat the FANOLA liquid before starting up the device Do not start up the device ifthe FANOLA liquid spilled out from the container Do not cover the working device as it may cause fire Keep the device and fuel away from children pets and unauthorized persons FANOLA liquid is not suitable for consumption Avoid contact with skin and eyes Do not operate by the filler when the device is running Do not tamper with the elements inside the furnace body at the risk of burns damage to the device or fire Some elements of the device heat up to high temperatures Do not touch the area of the furnace of the device as it may
3. an the recommended FANOLA VI Disposal and recycling The product is equipped with parts made of aluminium steel plastics and electronics If you need to dispose of the device follow the terms of disposal and recycling in force in your country Moreover dispose of the empty Fanola containers should be dumped to plastic waste baskets Most of the materials used in Planika appliances can be recycled FANOLA fuel recommended for this product has received following certifications SIED PRo O S If you have any technical problems or other questions that need clarification contact your dealer Copyright Planika Sp z 0 0 www planikafires com 8
4. ard flame size The device has the adjustable flame size during operation In order to reduce the height of the flame press the ECO button You will hear two beeps and the ECO button will be highlighted The unit is now operating in ECO mode To return to the normal height of the flame press the ECO button you will hear one beep and the ECO button backlight turns off The device is now in normal mode ATTENTION It might take a few moments for the flame to adjust ATTENTION The device switches to ECO mode by itself when there is a danger of over temperature of the device D Device extinguishing Press the START STOP button on the control panel You will hear two beeps and the red indicator will start to blink The flashing red indicator means that the device is too hot to be restarted When the device cools the message will disappear and depending on the amount of the fuel in the tank either the green indicator will flash and indicate the readiness for operation or the blue indicator will indicate the lack of the fuel E Subsequent start up If on the control panel flashes the blue FUEL indicator start to run the product from the point B 2 If on the control panel flashes the green READY indicator you can e start to run the product from the point B 3 e open the fuel filler bolt the green READY indicator will go off If the blue indicator blinks and a beep sounds intermittently the tank is full and it is not allowed to pour
5. ay lead to malfunction or damage of the device or even cause fire and health hazards The manufacturer does not take responsibility for the damages resulting from using liquids other than the recommended FANOLA lll Safety The Wall Fire produces a real open fire so in order to use the device properly and safely and in order to keep the warranty the following safety rules should be observed Do not expose the device to weather conditions The product is for internal use only Please read the device installation manual to avoid placing the device in rooms with a capacity of less than required While working the device emits heat water vapour and carbon dioxide therefore it is necessary to provide proper ventilation of the interior so that the total air exchange is 1 h During the device s starting sequence the characteristic smell of the liquid used in the device or the recommended FANOLA liquid Do not install the device in areas of large drafts of air near fans vents etc Do not place in areas where there might be a potentially explosive atmosphere of paint vapours industrial dusts etc Do not use the device at the ambient temperature below 10 C 50 Fahrenheit or higher than 30 C 86 Fahrenheit Assemble the device only on a flat surface with a correct levelling Improper installation may results in the malfunction and damage of the product or causes a fire No flammable items should be placed in direct cont
6. cause burns Do not place any decorative elements on the burner s surface Copyright Planika Sp z 0 0 www planikafires com 3 e Warning The glowing coil temperature heats up to 1300 C Touching the device while it is turned on may cause burns e Warning The furnace heats up to high temperatures during operation e WARNING The first run can be made only after proper installation of the device and reading the manual instructions e WARNING Prior to moving the appliance burn the fuel out and move the appliance slowly in the horizontal position avoiding shaking There is always some fuel left inside the device and if spilled the sensors might get wet If that happens the appliance will not work until the liquid evaporates IV Operation This manual contains all the information necessary for the proper operation of the Wall Fire It is obligatory to read and keep this instruction manual Operation of the device is permitted only after the device is properly installed according to the instructions and the manual A Operating elements Tempered glass Fanola filler bolt Fire grate Control panel l Control Panel Switches to ECO mode Service USB input hidden under a cap Starts the device from standby mode or switches to the standby Planika NEW SENS OF FIRE ECO _ START V i STOP HOT READY ERROR The red indicator The blue indicator The gre
7. critical device obtains the indoor temperature Hold down the operation error ECO button for about 5 seconds If the message reappears contact your service provider Shut the filler bolt Press the START STOP button to turn ff th hold the ECO button for about 5 11 X Filler bolt protection error 7 esouno ana mo lp tne Buran for abou seconds If the message reappears contact your service provider Copyright Planika Sp z 0 0 www planikafires com V Cleaning and maintenance Switch off the device before cleaning Wait until the temperature of the device gets close to the ambient temperature To maintain appropriate technical condition of the device please observe the following rules e Clean the furnace with a soft cloth and water to avoid causing cracks and scratches e To clean stainless steel surfaces use only gentle cleaners which do not cause cracks or scratches or use other means specifically designed for cleaning stainless steel When purchasing and dozing cleaners be sure to protect the environment and comply with the recommendations of manufacturers It is forbidden to clean the inside of the device by unauthorized persons The manufacturer does not foresee a situation where it will be necessary to clean elements not normally available The manufacturer is not liable for damage resulting from E improper operation non manual E self dismantling m attempts to modify E using fluids other th
8. en indicator Copyright Planika Sp z 0 0 www planikafires com 4 B Initial start up of the device 1 On the control panel the blue light flashes ck of fuel in the tank Please refuel 2 Refueling 2 1 Open the Fanola filler bolt 2 2 Insert the funnel 2 3 Pour the fuel into the funnel following these precautions e During pouring be careful not to spill fuel out of the filler If the fuel is spilled error message is displayed 5 go to step F and follow the guidance provided in the table e If 5L containers are used to fill up twist on the cap with the tap onto the container and pour using the funnel To fill up use only accessories provided by the manufacturer 2 4 Pour the fuel to the point where the blue indicator blinks and the intermittent beep will sound Stop pouring Remove the funnel 3 1 Press the START STOP button on the control panel and hold for 2 seconds You will hear a single beep Copyright Planika Sp z 0 0 www planikafires com 5 3 2 The green indicator will blink to indicate start up of the device it takes a few moments for the appliance to ignite the flame 3 3 While the appliance is in work mode the green indicator goes off and the flame starts to appear The device works automatically until they run out of fuel or disable the device by the user C Flame size regulation The Wall Fire can operate in two modes Normal and ECO The device always starts with a stand
9. n off and the green indicator will or the allowable temperature start to flash has been exceeded The devi t ticall rio Maa Allow the device to cool down After cooling the device 6 turns off due to lack of fuel in a the red indicator will turn off the tank It is not allowed to pour any more fuel Close the Fanola 7 x The fuel tank is full filler bolt The blue indicator will turn off the green one will start to flash Immediately stop pouring the fuel Remove the funnel dry a visible moisture Press the START STOP button to turn off the sound Wait at least 1 hour to evaporate the There wass tuetsoiilor remaining moisture and then close the fuel filler bolt p Hold the ECO button for about 5 seconds If the alarm 8 message reappears wait a little bit longer until the rest x of the moisture evaporates If the message reappears contact your service provider If the alarm message appears during the start of the th table d 5 pe an E has device press the START STOP button to turn off the p p sound and hold the ECO button for about 5 seconds been exceeded If the message reappears contact your service provider Press the START STOP button to turn off the sound and 9 x Operation error hold the ECO button for about 5 seconds If the message reappears contact your service provider Press the START STOP button to turn off the sound The device temperature Provide higher ambient temperature Wait until the 10 X below 10 C or
10. planika EW SENSE OF FIRE USER S MANUAL WallFire 4 li T ls ha u Manufactured by Planika Sp z o o ul Bydgoska 38 86 061 Brzoza Poland Edition 10731 01 as of 20 02 2014 IT IS OBLIGATORY TO READ AND KEEP THIS INSTRUCTION MANUAL TABLE OF CONTENTS l General information 0 00 0 000 cee eee ee eee eee e ee eeee 3 Il Consumables 0 0 ccc eee ee eee eee eee ee eee eee e eens 3 Ml Safe era a Lal cr th NS A Ee Dt de Lala ed tl des La Do dee 3 IV Operation Operating elements Keb ne gia be de eee Mae aad ed wheels 4 Initial start up of the device eee e tenn ne nen 5 Flame size regulation td e Ge ed ee eed a 6 Device extinguishing 0 0 ce en nananana araneae 6 Subsequent start UDs cornea pase dd oii eae ea cee aud Saeed whee he 6 Information and warning alert 0 n teen n eens 6 V Cleaning and maintenance 0 0 cc eee tent n ene n eens 8 VI Disposal and recycling 0 0 ccc ene en ene n ene e nena 8 Copyright Planika Sp z 0 0 www planikafires com 2 l General information The Wall Fire is a decorative appliance with real flames Due to the innovative technology applied the Wall Fire is simple and safe to use tl Consumables The FANOLA liquid is recommended to be used for proper operation of the Wall Fire due to its special composition that enables proper functioning of the device The use of fluids other than the recommended FANOLA fluid m
Download Pdf Manuals
Related Search