Home

Step2

1. 4Claying Interactive Electronics Clay User Manual IROBOT DRYS THS TV TRS Phoebe DF Robot www DFRobot com Before You Start 1 Fully knead before use 2 Sealed for preservation avoid direct sunlight 3 Spring some water to continue kneading if the surface is dry 4 Let it dry naturally in the air 5 Prohibit children from eating the clay or choking 6 Fully dry the electronic component if it got wet Electronic Parts 1 LEDs with Cable 2 3xAA Battery Holder 3 Cable for PIR Motion Sensor 4 PIR Motion Sensor 5 Power Breakout 6 Ultra Light Clay 0000 060 7 Clay Tool Set Three primary colors from which all colors are created are included in the kit You can mix them into your desired colors Tips The color theory on the box is for your reference 4 Separate the Yellow Green clay into two clots bigger clot for body and smaller clot for eyes Make two Eyes with two red LEDs as shown in picture Wrap the LED cables around the gt Yellow Green clay Set about 3 cm the LED aside ose EX 4 Pinch out of the body and bend the upper of the LEDs into 90 degrees Wrap the LEDs with the clay and gt expose a little bit of the LED Tips Exposure of the LED lights achieves better effects 4 Take a small piece of white ultra light clay and make a strip Wrap the eyes with white clay as the p slug s eyelids 4 Roll out a piece of
2. nfrared signals from human body or other animals and triggered by movement When somebody is moving in front of the slug Its eyes will light on 4Claying electronic DIY kit is a kit that combines the fun of scuplting with super lightweight clay and building interactive circuits It is a great way of helping kids to learn the basics of electronics and to play with sensors in an easy and intuitive way The kit contains not only vibrant colored toxic free lightweight modeling clay but also high quality color LEDs and motion sensors to make your sculptures alive With up to 6 colors of clay and 4 colors of LEDs you will be able to create a full color spectrum and make your creation look fabulous You can make use of these LEDs as eyes stars or whatever you want and use the motion sensor as a trigger For example a cat that blinks eyes when you come close or walk by This PIR Motion Sensor can detect the infrared signals from the person or animals which are moving and can output the switching signal ROBOT www DFRobot com DRIVE THE FUTURE
3. the red clay and form it into a doughnut shape Attach the doughnut on the slug p gt body in the position of the mouth Here you ve created a funny slug out of clay There is a hole at the bottom of gt the small box Take out the battery holder by pushing it with your fingers through the hole 4 Take out the battery holder sheath Put 3xAA battery into the gt holder sheath 4 Set the battery holder back to the battery holder sheath Connect the battery cable to the gt power supply board 4 The 3pin cable included in the package of LEDs is for connecting the sensor to the power board Connect the other side of the 3pin gt cable to the PIR motion sensor 4 The connection diagram is shown in figure 4 4 Four small holes on the box cover are for threading Thread the LED cable p gt through the hole 4 Connect the two LEDs to the power board Put the PIR motion sensor gt in the box You can expose more of the probe to the power board is to connect 2 LEDs at most in the same time Please pull out the cable slowly when changing the LEDs Wrap all boards and cables into the gt box lt 4 Here is the power switch Press it to power on or power off The blue LED on the board is to p be lit up when the board ts powered on Keep the sensor probe close to the entrance to improve the effect of interaction Tips The PIR Motion Sensor detects the i

Step2

Contents

Download Pdf Manuals

Related Search

Related Contents