K4350 - Kroy Europe
Contents
1. Quick Installation Guide Printer Overview Label roll mount Ribbon supply spindle Ribbon rewind spindle Printer cover Ribbon mechanism Fixing tab Print head Label supply spindle Label stripper Carriage release lever Backing paper outlet Setting up the Printer 1 Connect the printer to the 2 Plug the power cord into the 3 Plug the power cord into a computer mainframe power jacket at the rear of the properly ground receptacle printer Note Please switch OFF printer power switch prior to plug in the power cord to printer power jack Loading the Ribbon gt 1 Place an empty paper core onto 2 Insert the left side first Mount Please be noted that the bigger the ribbon rewind spindle the ribbon rewind paper core on hub side with 4 ribs must be the front hubs installed toward the right side of ribbon mechanism 4 Install a ribbon on the ribbon 5 Insert the left side first Please 6 Disengage the printer carriage supply spindle Mount the ribbon be noted that the bigger hub by pulling the carriage release supply spindle on the rear hubs side with 4 ribs must be installed lever upwards toward the right side of ribbon mechanism 7 Following the direction of the 8 Attach the ribbon leader to the 9 Rotate the ribbon rewind spindle empty paper core on the ribbon until the ribbon overlaps the RIBBON label pull the rewind spindle with a tape ribbon leader and stretch2. es transparent ribbon leader to the front from under the ribbon mechanism tight Page 1 of 2 Loading the Label 1 Insert a label spindle into a paper 2 Place the label onto the roll Insert fixing tabs into the external label roll mount 3 Install the label so that it goes when using an external label spindle roll mount through the label feed slot in the direction of the 4 LABEL label and under the ribbon mechanism to lay upon the platen 4 Adjust the label guide to fit the 5 Engage the printer carriage 6 Close the printer cover width of the label Note When switched on the printer will automatically detect whether ribbon is installed to set printer to direct thermal or thermal transfer mode As such to use thermal transfer mode be sure to install the ribbon the label and engage the ribbon mechanism before you switch on the printer To use direct thermal mode install the label and engage the ribbon mechanism before switching on the printer Power on Utilities E Self Test Power off the printer install the ribbon and the label first Press the FEED button and then turn on the printer power Do not release the FEED button until the printer feeds labels The printer performs the following items 1 Calibrate label pitch 2 Print out thermal print head check pattern 3 Print the internal settings 4 Enter into dump mode Gap Sensor Calibration This utility is used t
3. o calibrate the sensitivity of the gap sensor Users may have to calibrate the gap sensor for two reasons 1 Using a new type of label 2 Initializing the printer Note The ERROR LED may flash if the gap sensor is not calibrated properly Please follow the steps below to calibrate the gap sensor 1 Turn off printer power and install blank i e without any logos or characters label roll on the printer power 2 Hold down the PAUSE button while turning on printer power 3 Release PAUSE button when the printer feeds labels Do not turn off printer power until the printer stops and the two green LEDs light on E Printer Initialization Printer initialization sets printer parameters to default values Please follow the steps below to initialize the printer 1 Turn off the printer power 2 Hold down the PAUSE and FEED buttons while turning on the printer power 3 Do not release the buttons until the three LEDs flash in turn Note When printer initialization is done please calibrate the gap sensor again For further information on printer operation please refer to the user s manual in driver CD disc Specifications accessories parts and programs are subject to change without notice P N 39 0000089 40LF
Download Pdf Manuals
Related Search