Pulsarlube S user Manal ENG(100302)-1
Contents
1. This means that the grease will be rapidly discharged into the bearing housing if there will be no back pressure on the unit Also If the bearing you are lubricating with the Pulsarlube S spring type lubricator is an open bearing located within an open housing no mechanical seals installed then the lubricator will be discharged very quick You should look at the engineering drawings for the item you are attempting to lubricate and from those drawings identify and decide if there is sufficient resistance to allow the Pulsarlube S units to operate correctly as they were originally designed to do so if doubt remains then install a more positive Pulsarlube product Pulsarlube V and M gt If the Pulsarlube S is already filled 1 Make sure the valve position indicator located at top of dispenser is set to OFF 2 Turn and pull out the piston locking hinges found at the bottom of the lubricator 3 Turn the valve position indicator to 5 to make sure lubricator is dispensing properly and then turn to OFF position 4 Install lubricator on lube point manually and set it to desired dispensing rate from 1 5 gt If the Pulsarlube S is not pre filled 1 Set Control knob to the 3 position 2 Remove Red grease nipple cap and fill lubricator with grease gun until grease exits outlet via the center sleeve of lubricator 3 Set Control Knob to OFF position and fill lubricator until the piston ring reaches level i2. PuLlsanLUGE S WwLe hs Doc No 3210 REV 020310 USER MANUAL Operating Principles Thank you for purchasing the Pulsarlube S the new and unique spring type single point grease dispenser from Pulsarlube USA Inc The Pulsarlube S is a refillable lubricator To ensure the safe operation and proper installation of the Pulsarlube S unit we strongly recommend that you read the following information carefully before use If you require further information please contact your local supplier Specifications Specifications Description Grease Capacity 100cc Normal operating pressure 1 3 kgf cm 15 psi Operating temp range 23 C 121 C 10 F 250 F Outlet thread size 1 4 NPT and BSP Functions on both NPT amp BSP lube points Outlet thread size containing a 8mm 1 4 O D due to re enforced composite plastic tip on the lubricator Weight Filled 320g 11 30z Empty 200g 70z Product dimensions Height 129mm 5 xDiameter 67mm 2 6 Water Proof Can be used under water NLGI Range NLGI 1 2 Remote installation Can be remotely installed up to 0 3m 1ft using a 8mm 1 4 tube Installation Instructions Pulsarlube S spring type lubricator is a demand feed system not a time programmable Bearings get only as much lubricant as they need The natural vacuum created in a bearing Venturi Action gently draws the grease into the bearing When equipment isn t operating there is no grease demand
3. ndicator line that reads Do not fill below this line 4 Place Red Nipple cap back on the grease point for protection Please avoid over filling Overfilling may damage the lubricator Please use manual grease gun Do not refill with high pressure high volume air electrically operated grease gun this may damage the Pulsarlube S unit and warranty will be null and void The Pulsarlube S is not a time programmable unit The flow control valve is simply to allow you Warning i I much more control over the dispensing rate O Pulsarlube USA Inc http www pulsarlubeusa com
Download Pdf Manuals
Related Search