MF65M Quick Start Guide
Contents
1. any unauthorized accessories may affect the performance of the device and violate the related national regulations about telecom terminals 16 Warning and Notice Avoid using the device near or inside metallic con structions or establishments that can emit electro magnetic waves because signal reception may be affected The device is not waterproof Keep the device dry and store it in a shady and cool place Do not use the device immediately after a sudden temperature change because dew may be generated inside and outside the device Do not use it until it be comes dry Handle the device carefully Do not drop bend or strike it Otherwise the device may be damaged Only gualified personnel can dismantle and repair the device An operating temperature between 10 C and 45 C and humidity between 5 and 95 are recommended Using Battery Do not change the battery in your device by yourself The battery can only be changed by ZTE or ZTE authorized service provider 17 Warning and Notice Limited Warranty This warranty does not apply to defects or errors in the product caused by vi vii Reasonable abrasion End users failure to follow ZTE s installation operation or maintenance instructions or proce dures End users mishandling misuse negligence or improper installation disassembly storage ser vicing or operation of the product Modifications or repairs not provided by ZTE or a ZTE certi2. instruments such as hearing aids and pacemakers Always keep the device more than 20 centimeters away from such medical instruments when your de vice is powered on Power off the device if necessary Consult a physician or the manufacturers of medical instruments before using the device if necessary Be aware of the usage limitation when using the device at places such as oil warehouses or chemical factories where there are explosive gases or explosive products being processed Power off the device if necessary Do not use electronic transmission devices in air crafts at petrol stations or in hospitals Observe and obey all warning signs and power off the device in these conditions 15 Warning and Notice Do not touch the inner antenna area unless neces sary Otherwise the performance of the device may be affected Do not use the device in an enclosed environment or where heat dissipation is poor Prolonged work in such space may cause excessive heat and raise ambient temperature which may lead to automatic shutdown of the device for your safety In the case of such event cool the device in a well ventilated place before turning on for normal use Keep the device out of the reach of small children The device may cause an injury if used as a toy When the device is operating do not touch the metal lic parts Failing to do so may cause burns To the Users Use original accessories or accessories that are au thorized Using
3. wireless networks If you use a computer you need to set your computer to obtain an IP address automatically 3 Select the Wi Fi name SSID of your device and click Connect 4 Enterthe Wi Fi password if necessary and click OK NOTE Refer to the chapter Getting to Know the Wi Fi SSID and Password to get the default Wi Fi SSID and pass word 5 Wait until the client device is connected to your de vice successfully Connecting to Your Device Using a USB Cable 1 Connecta computer to your device with a USB cable 2 Power on your device The operating system detects and identifies new hardware and automatically in stalls the hardware NOTE If the system does not automatically launch installation you can click the device installation icon in My Computer to install the software 3 Wait until the computer is connected to your device successfully Getting to Know the Wi Fi SSID and Password You can view the label on the device to get the default Wi Fi SSID and password 10 Logging in to the 3G Mobile Hotspot Configuration Page 1 Make sure the connection between your device and the client device is correct 2 Launch the Internet browser and enter http 192 168 0 1 or http virgin wifi in the address bar NOTE It is recommended that you use IE 7 0 or later Firefox 15 0 or later Opera 10 0 or later Safari 4 0 or later or Google Chrome 10 0 or later 3 Enterthe password to log in t
4. MF65M Quick Start Guide ZTE CORPORATION NO 55 Hi tech Road South ShenZhen P R China Postcode 518057 Getting to Know Your Device Appearance The following figure is for your reference only 1 LED Indicators 2 PowerKey 3 WPS Key 4 Charging micro USB Jack 5 U SIM Card Slot 6 microSDHC Card Slot NOTE The microSDHC logo MSS is a trademark of SD 3C LLG Getting to Know Your Device Indicators When the device is powered on the following icons may be lighting For a description of the icons refer to the fol lowing table Indicator Status Description Error status Not registered to the mobile network no U SIM card Red solid inserted or no network service Network available alll Green Registered to the mobile net solid work Green Connected to the mobile network blinking and data is being transferred Blue solid Wi Fi is active wi ri Ble wes is active blinking off Wi Fi is off or your device is in sleep mode Getting to Know Your Device Blue solid You have unread messages SMS Blue DX blinking You have new messages off No unread messages Red solid The battery is low Please charge blinking the battery Green The battery is being charged or Battery blinking in standby mode Green The battery level is middle or solid high off Your device is not being charged or the battery i
5. ervice provider and confirm your APN settings The client cannot access the In ternet in Internet Wi Fi mode Ensure that the WLAN device has already been connected to the Internet Ensure that your device and the WLAN device are in different subnets 22 Troubleshooting Hotspot configu ration page can not be visited Problem Recommended Action Enter the correct address The default address is The 3G Mobile http 192 168 0 1 or http virgin wifi Use only one network adapter in your PC Do not use any proxy server C 1588 23
6. fied individual Power failures surges fire flood accidents and actions of third parties or other events outside ZTE s reasonable control Usage of third party products or usage in con junction with third party products if such defects are due to the combined usage Any other cause beyond the range of normal us age intended for the product 18 Warning and Notice End users have no right to reject or return the product or receive a refund for the product from ZTE under the above mentioned situations This warranty is end users sole remedy and ZTE s sole liability for defective or nonconforming items and is in lieu of all other warranties expressed implied or statutory including but not limited to the implied warranties of mer chantability and fitness for a particular purpose unless otherwise reguired under the mandatory provisions of the law Limitation of Liability ZTE shall not be liable for any loss of profits or indirect special incidental or conseguential damages resulting from or arising out of or in connection with using of this product no matter whether or not ZTE had been advised knew or should have known of the possibility of such damages including but not limited to lost profits interrup tion of business cost of capital cost of substitute facilities or product or any downtime cost 19 LEGAL INFORMATION Copyright O 2014 ZTE CORPORATION All rights reserved No part of this publication ma
7. nect to the Wi Fi hotspot The following two methods are for your reference gt Select a Wi Fi hotspot listed in the Wi Fi Hotspot area enter a pass phrase in the Pass Phrase text box and click Apply gt Click Add enter the Wi Fi hotspot information in the Add Wi Fi Hotspot area and click Apply 13 Accessing the Internet Add Wi Fi Hotspot Network Name SSID Securty Mode wPA PSKAWPA2 PSK 1 WPAAlgorthms TKIP CAES AUTO Pass Phrase Display Password c ZTE AP 3508 a WPR2 PSK After the client device is connected to the Wi Fi hotspot successfully you can access the Internet Configuring Your PC The following procedure describes how to configure the Internet Protocol in the Windows 7 operating system for your Wi Fi connection 1 2 3 Right click Network and select Properties Select Change adapter settings Right click Wireless Network Connection and select Properties Select Internet Protocol Version 4 TCP IPv4 and click Properties Select Obtain an IP address automatically and Ob tain DNS server address automatically and click OK 14 Warning and Notice To the Owner If inadeguately shielded some electronic devices for example the electronic system of vehicles may be affected by the electromagnetic interference caused by the device Consult the manufacturers of such de vices before using the device if necessary Operating the device may interfere with medical
8. o the 3G Mobile Hotspot configuration page NOTE The default password is admin Changing the Wi Fi SSID or Password 1 Log in to the 3G Mobile Hotspot configuration page Select Settings gt Wi Fi Settings gt Basic Settings 3 Change the Network Name SSID or the Pass Phrase Password 4 Click Apply 11 Accessing the Internet 3G Mode After a client device is successfully connected to your device you can access the Internet in Automatic or Manual mode The default mode is Automatic Mode Operation Your device is automatically connected to Automatic the Internet and you can surf on the Inter net through the client 1 Log in to the 3G Mobile Hotspot con figuration page 2 Select Settings gt Network Settings gt Manual Dial up Settings gt WAN Connection Mode gt Manual and then click Apply 3 Select Home and click Connect or Disconnect NOTE To modify the parameters of your device log in to the 3G Mobile Hotspot configuration page 12 Accessing the Internet Internet Wi Fi Mode 1 Log in to the 3G Mobile Hotspot configuration page 2 Select Settings gt Internet Wi Fi 3 Set the Internet Wi Fi Switch and Preferred Net work and click Apply 4 You need to set Internet Wi Fi Switch to Enable and Preferred Network to Wi Fi Internet Wi Fi Internet Wi Fi Switch Enable O Disable Preferred Network Wi Fi WWAN Current Status WAN connected 5 Con
9. s not inserted Getting to Know Your Device Connection Scenarios The device can access the Internet in two ways and it allows multiple clients to surf on the Internet at the same time The following figures are for your reference only 3G Mode A U SIM card can be used to access the Internet o A amp Ap Internet Wi Fi Mode Your device can be connected to a WLAN device such as a hotspot device or wire less router through Wi Fi to access the Internet The WLAN device must be already connected to the Inter net NOTE Your device and the WLAN device must be in different subnets ri Getting to Know Your Device U 5 1 2 P op See e Installing Your Device 1 Slide the back cover and remove it NOTE Do not remove the cover rudely 2 Install a U SIM card to the U SIM card slot O WARNING Your device does not support the micro SIM and nano SIM card or any other non standard SIM cards To avoid damag ing the device do not use those cards or any card holders 6 Installing Your Device 3 Installing Your Device 4 Install the battery 5 Close the back cover Connecting to Your Device Using Wi Fi 1 Power on your device 2 Make sure your computer or other client devices have enabled Wi Fi and search for available wireless net works NOTE Refer to your Wi Fi enabled client device manual for further details on how to search for
10. y be excerpted reproduced translated or utilized in any form or by any means elec tronic or mechanical including photocopying and micro film without the prior written permission of ZTE Corpora tion The manual is published by ZTE Corporation We reserve the right to make modifications on print errors or update specifications without prior notice Version No R1 0 Edition Time October 28 2014 20 Troubleshooting Problem Recommended Action The connection between your device and a PC through a USB cable cannot be established Install the software and run the installation program in the path of My Computer If the driver of your device is abnormal reinstall the software You need to uninstall the soft ware first The connection between your device and a cli ent through Wi Fi cannot be estab lished Ensure that the Wi Fi function is enabled Refresh the network list and se lect the correct SSID Check the IP address and en sure that your client can auto matically obtain an IP address Enter the correct network key Wi Fi password when you con nect the client to your device 21 Troubleshooting Problem Recommended Action The client con nected to the device cannot ac cess the Internet Ensure that your U SIM card is available Change the location and find a place with good signal Check the settings of the WAN connection mode Contact your s
Download Pdf Manuals
Related Search