RUBY Handheld Video Magnifier User`s Guide
Contents
1. there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Increase the separation between the equipment and receiver m Connect the equipment into an outlet on a circuit different from that to which the receiver is connected m Reorient or relocate the receiving antenna m Consult the dealer or an experienced radio or television technician for help m This Class B digital apparatus complies with Canadian ICES 003 Cet appareil num rique de la classe B est conforme a la norme NMB 003 du Canada 23 Regulatory Compliance m Safety IEC 60950 1 ed2 0 UL 60950 1 2007 CSA C22 2 60950 1 2007 EN 60950 1 2006 A11 2009 A1 2010 EN 60825 1 2001 m EMC FCC CFR 47 part 15 Class B ICES 003 EN 55022 Class B EN 55024 Wavelengths 400 nm to 750 nm LED RADIATION Power lt 1mW CW DO NOT STARE INTO BEAM CLASS 2 LED 24 Safety and Maintenance Do not attempt to repair RUBY or open its case This product contains no user serviceable parts Any unauthorized attempt to service or replace internal components will void the product warranty Keep RUBY away from wet areas rain and other sources of liquids Do not submerge RUBY Always operate RUBY in2. a place where the temperature is between 10 and 35 C 50 and 95 F Do not store in places subject to temperature extremes such as a parked car Do not force any connector into RUBY s power port The power connector fits easily into the port Use only the power adapter that came with RUBY to charge the NiMH 1000 mAh batteries Other adapters may damage the unit 25 m Some batteries have low charge rates and specify a MAX Charging Current DO NOT USE batteries that specify their MAX Charging Current as being below 250 mA m Dispose of NiMH and alkaline batteries properly Check with your local government for disposal and recycling procedures m Do not mix NiMH batteries and alkaline batteries in RUBY Replace all batteries of the same chemistry at the same time Do not mix new batteries with old batteries Failure to follow this precaution can lead to battery failure or leakage Risk of explosion is possible if batteries are replaced with an incorrect type Cleaning Procedures LCD Screen m Turn off and unplug RUBY before cleaning the LCD screen m Always use a clean microfiber cloth 26 m Very gently wipe the cloth across the screen Do not press hard on the cloth or screen m f you use a cleaning liquid use an appropriate LCD cleaning liquid You can also use distilled water isopropyl alcohol or vinegar mixed with water at a concentration of no more than 10 percent vinegar Note that tap or mineral water
3. RUBY Handheld Video Magnifier User s Guide 440530 001 Rev B Freedom Scientific Inc 11800 31 Court North St Petersburg Florida 33716 1805 USA www FreedomScientific com Copyright 2011 Freedom Scientific Inc All Rights Reserved RUBY is a trademark of Freedom Scientific Inc in the United States and other countries Information in this document is subject to change without notice No part of this publication may be reproduced or transmitted in any form or any means electronic or mechanical for any purpose without the express written permission of Freedom Scientific Technical Support To contact Technical Support by telephone U S customers can call 727 803 8600 Monday through Friday 8 30 AM to 7 00 PM Eastern Time To contact by e mail send questions to Support FreedomScientific com To search the knowledge base visit www FreedomScientific com and choose the Support link Read Me First Before using RUBY for the first time you must charge the four AAA NiMH 1000 mAh batteries These batteries are included A full charge takes approximately 2 hours Refer to Battery LED Descriptions on page 2 for battery status explanations You can also use four AAA disposable alkaline batteries to operate the unit Do not mix NiMH batteries with alkaline batteries Replace all batteries of the same chemistry at the same time Do not mix new batteries with old batteries Replace NiMH batteries with 1000 mAh NiMH batte
4. color settings When viewing a saved image you can change the magnification level 10 Storage Mode Icons S OLIN Save Press the blue button Ld to check the check box The image is saved when you exit Storage mode Delete Press the blue button Ld to clear the check box The image is deleted when you exit Storage mode Advance Press the red button 0 to move to the next image When you reach the last image RUBY cycles back to the first image Memory Full Indicates that the maximum of 15 images have been saved on RUBY You must mark one or more images for deletion L_ before you can save the current image 11 Saving and Deleting an Image After freezing an image on the screen you can save it by doing the following Press and HOLD the red button 3 for six seconds to enter Storage mode In the lower left corner the Save Image check box IY is automatically checked This indicates that the image will be saved after exiting Storage mode The Advance icon displays in the lower right corner on the screen Press the red button Key to step to the next image Pressing the button repeatedly will cycle through all images on RUBY 12 To delete an image press the blue button Ld to clear the check box L When you exit Storage mode the image is deleted Press and HOLD the red button for three seconds to exit Storage mode To review saved images press and HOLD the red button T for six seconds to
5. d of the power adapter is firmly plugged into RUBY s power port Ensure that the outlet has power and is not malfunctioning If the outlet is connected to a wall switch make sure the switch is on Some batteries have low charge rates and specify a MAX Charging Current DO NOT USE batteries that specify their MAX Charging Current as being below 250 mA There are smudges or blemishes on the screen m Clean the LCD screen as described in Cleaning Procedures on page 26 21 Text is too small or too large to read Press the yellow Magnification button to cycle through different magnification levels LED lights produce glare against a reflective surface Press and HOLD the yellow green Power button and then press the red Freeze Frame button to turn off the LED lights RUBY turns off after reading for 30 minutes This is expected behavior RUBY turns off after 30 minutes if no buttons are pressed This extends battery life 22 Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However
6. em you want to magnify is positioned correctly under the camera window 18 Press the yellow Magnification button to step through the magnifications levels Press the blue Color Select button to step through the color modes The battery indicator LED is flashing red Charge the NiMH batteries or replace the AAA alkaline batteries Do not mix battery chemistries If you replace the rechargeable batteries be sure to use 1000 mAh NiMH batteries The battery LED is solid red while the power adapter is connected to RUBY A battery error has occurred Unplug the power adapter from RUBY and plug it in again 19 Charge the NiMH batteries for at least 2 hours or replace with AAA alkaline batteries Do not charge alkaline batteries If the problem continues disconnect the power adapter and call Freedom Scientific Technical Support as mentioned earlier in this document The battery indicator LED does not flash green even though the power adapter is connected and plugged into a wall socket Ensure that the small end of the power adapter is firmly plugged into RUBY s power port Ensure that the outlet has power and is not malfunctioning If the outlet is connected to a wall switch make sure the switch is on 20 The NiMH batteries are not charging Make sure the batteries are inserted correctly See page 3 Do not replace batteries while the power adapter is connected Make sure the small en
7. enter Storage mode You can then advance and step through the images as previously described in this section 13 Saving an Image when Memory is Full RUBY can store a maximum of 15 images If you try to save another image the Memory Full icon displays in the lower left corner of the screen To add another image you must remove one or more saved images from memory Press the red button 0 to step to an image that you want to delete and then press the blue button Ld to clear the check box LI Press and HOLD the red button 0 for three seconds to exit Storage mode The new image is saved and all unchecked images are deleted 14 Hardware Description Dal 6 Q gt a Q 1 Power button green and 3 Magnification button yellow yellow 2 Color Select button blue 4 Freeze Frame red 5 LCD display 15 6 Power connector 7 Battery LED 8 Handle and battery compartment in closed position 16 9 Handle and battery compartment in opened position 10 LED lights 11 Camera window 12 Wrist strap post 17 Troubleshooting The unit does not turn on Press the green yellow Power button If RUBY does not turn on charge or replace batteries Make sure the batteries are inserted correctly See page 3 Do not replace batteries while the power adapter is connected The screen is blank m Turn RUBY off and then on again m Turn on the LED lights Verify that the it
8. may cause spotting on the screen Do not leave any liquid on the screen Repeat this procedure for hard to remove smudges m Do not spray any cleaning solutions directly on the LCD screen Do not use a cleanser that contains acetone ethyl alcohol ethyl acid ammonia or methyl chloride m Do not use a paper towel to clean the LCD screen Cleaning the Rest of RUBY m Make sure RUBY is unplugged Use a lightly dampened soft clean cloth with water or mild detergent Do not use alcohol solvents abrasives or aerosol sprays 27
9. nuous use When the batteries are low the battery indicator LED flashes red Connect the power adapter and plug it in to recharge the NiMH batteries Note If you decide to replace the supplied NiMH batteries replace all four at the same time with 1000 mAh NiMH batteries Turning On RUBY 1 Press the green yellow button 0 to turn on RUBY After a few seconds the battery status icon displays on the screen 2 Press the button again to turn off RUBY Note If RUBY is left on and no buttons are pressed it automatically turns off after 30 minutes to avoid draining the batteries Button Descriptions D Ld Als 5 Power Green Yellow Press to turn power on Press it again to turn power off Color Select Blue Press to cycle through Normal color Black on White White on Black Yellow on Blue and Yellow on Black color displays Magnification Yellow Press to cycle through three different magnification levels Magnification varies depending on how far you hold RUBY from an object Freeze Frame Red Press to freeze the current image Press it again to turn off Freeze Frame mode Magnifying with RUBY How far you hold RUBY from an object determines the level of magnification Placing RUBY with Handle Closed on a Document _ The starting magnification is 5X when you place RUBY directly ona document with the handle folded closed Press the yellow button once to increase to 7 5X magnification P
10. ress again to increase to 10X magnification Press a third time to return to 5X magnification Holding RUBY with Handle Extended Unfold and extend the handle holding it like a magnifying glass Move RUBY closer to an item to view a smaller area or farther away to view a larger area a From the starting magnification press the yellow button once to increase magnification Press again to increase to the next magnification level Press a third time to return to the first magnification level Changing Color Modes Press the blue button ld to change the current color combination on the LCD screen Continue pressing it to cycle through Normal full color Black on White enhanced positive White on Black enhanced negative Yellow on Blue and Yellow on Black color combinations Freezing an Image Press the red button Key to freeze the image If you like press the yellow button to change magnification Press the red button 0 again to turn off Freeze Frame mode Turning LED Lights Off To avoid glare when viewing reflective surfaces you can turn off the LED lights Press and HOLD the green yellow button 0 and then press the red button Oo The LED lights turn off To turn the lights on again press and HOLD the green yellow button 0 and then press the red button Storage Mode Storage mode allows you to save up to 15 images on RUBY When you first store an image it is saved with the current
11. ries Failure to follow this precaution can lead to battery failure or leakage The risk of explosion is possible if batteries are replaced with an incorrect type Do not use batteries that specify a MAX Charging Current below 250 mA For a basic overview of RUBY review the information in this guide first Battery LED Descriptions Green Solid Battery charged power adapter connected Green Flashing Battery charging power adapter connected Red Flashing Battery low Red Solid Error unplug power adapter wait a few seconds and plug in again If this condition persists change the batteries No LED Battery charge ok power adapter not connected or RUBY is off Inserting Batteries 1 Fully extend the handle and remove the battery cover by sliding it in the direction of the imprinted arrow 2 Insert the batteries replace the battery cover and close the handle Make sure that batteries are inserted using the correct polarity Charging NiMH Batteries 1 Plug one end of the power adapter into RUBY and the other end into a wall outlet 2 The battery indicator LED blinks green to show that the batteries are charging For more see Battery LED Descriptions on page 2 O 3 The LED stops blinking and glows a steady green once the batteries are charged Unplug the power adapter from RUBY The battery indicator LED turns off 4 You can now use your RUBY for approximately two hours of conti
Download Pdf Manuals
Related Search