BS-F2 Standalone Fingerprint or Card Access Control User Manual
Contents
1. Press 1 fingerprint1 fingerprint1 or read card1 or press fingerprint2 fingerprint2 or press fingerprint3 fingerprint3 H next userl and H to exit Note One User can have at most 3 fingerprints and 1 card Press once finishing adding a user and before adding another user Press to exit registration menu once finishing adding all users 2 2 To add user with ID number Press 1 ID Number H fingerprint1 fingerprint1 or read card1 or press fingerprint3 fingerprint3 H Next ID Number H Next Useri H H For example add ID numbers 2 and 11 fingerprint2 fingerprint2 to exit Press 1 2 H fingerprint1 fingerprint1 or read card1 or press fingerprint2 fingerprint2 or press fingerprint3 fingerprint3 H 11H fingerprint1 fingerprint1 or press fingerprint2 fingerprint2 fingerprint3 fingerprint3 H H to exit Note The ID number is within 1 999 and the ID number should not be registered twice Please make a record of ID number like John 1 Sam 5 In case someone lost2. BS F2 Standalone Fingerprint or Card Access Control User Manual Important To use the remote control open the rubber cover on the bottom of the fingerprint machine The remote control has to be shorter than 1 inch close to the bottom of the machine I Administrator Operation Note To add delete or change the users or make any settings always turn on the Remote Program Device 1 Turn On the Remote Program Device Press ID number H 8 digit password and the steady red light will be on Note 1 Initial ID number is 0 and password is 8888 8888 so you enter 0 8888 8888 2 How to add Administrator Press 1 ID Number enter 8 digit password or fingerprint1 ifingerprint1 H H 3 How to delete Administrator Press 2 fingerprint or Press 2 ID Number H H Note 1 If a new administrator is added the initial ID and password will be invalid 2 In case administrator password is lost open hanging panel behind access control machine and turn on anti tamper switch so the initial ID and password will be valid again 3 After operation press to get back to standby mode The system automatically goes back to standby mode in case of nonoperation within 30 seconds II Add User 2 1 To add user without ID number
3. their card or quit You can use this ID number to delete it Delete Users 1 Delete without entering ID number Press 2 fingerprint or read card H Note If a user has 2 or 3 fingerprints or one card deleting any one of them will delete all 2 Delete with ID number Press IV ID Number tal H Delete all Press 2 OOOO V Set Unlocking time 5S as Factory default Press 4 1 255 seconds H H VI User Operation Press Fingerprint to open the door or swipe the card to open the door Recommended only ID number needed to delete user or press or press After this all passwords including the administrator fingerprint will be deleted VII Light and Beep Status Light Fingerprint indicator Buzzer Administrator Mode Red light turns on off Beep continuously Standby Red light blinks slowly on VIII How to set it back to factory default Open the backside cover of F2 it will has beep to alarm press 0 device is not making beep sound press 88888888 press 81 finish If you still have questions Please feel free to contact our technical support at 626 280 7788 or Send email to info lockchoice com
Download Pdf Manuals
Related Search