Chair-Check® II User Manual - Medical Technologies International
Contents
1. 100 pounds 3 Is the cord between the Sensormat and control unit snapped in properly Problem Unit Alarms Constantly Check 1 If it is constant series of short beeps it is an indication that the battery is low and should be replaced LIMITED WARRANTY BED CHECK CONTROL UNITS 1 WARRANTOR This Limited Warranty is given by Bed Check 1620 N 20th Cir Lincoln NE 68503 2 DURATION This Limited Warranty begins on the date the product is delivered to the purchaser and continues for a period of two years new units or one year refurbished units 3 TO WHOM THIS LIMITED WARRANTY IS GIVEN This Limited Warranty is given to the original purchaser of Bed Check s products only 4 PRODUCTS COVERED This Limited Warranty covers all Bed Check Control Units i e Model Vr Classic Check Chair Check II and Basic Check 5 WHAT IS COVERED UNDER THIS LIMITED WARRANTY Defects in material and workmanship which occur within the defined duration of this limited warranty Warrantor makes no other warranties expressed or implied including without limitation warrantor makes no warranty as to merchantability or fitness for a particular purpose 6 WHAT IS NOT COVERED UNDER THIS LIMITED WARRANTY a ANY INCIDENTAL INDIRECT OR CONSEQUENTIAL LOSS DAMAGE OR EXPENSE THAT MAY RESULT FROM ANY DEFECT FAILURE OR MALFUNCTION OF THE CONTROL UNITS b ANY INCIDENTAL INDIRECT OR CONSEQUENTIAL LOSS DAMAGE OR EXPENSE THAT MAY RESU2. Chair Check Il User Manual 0163 437 H P Bed Check E Reducing the Risk of Falls Through Innovative Technology Since 1978 1 800 523 7956 www bedcheck com 2008 The Stanley Works All Rights Reserved Bed Check Chair Check Sensormat and Access are registered trademarks of Stanley Logistics Inc How the Chair Check Il System Can Work for You Chair Check II is a system utilized to aid the monitoring of fall risk patients allowing the nursing and aide staff of either long term or short term care facilities to determine if a patient is still seated in a chair wheelchair or on a toilet seat The Chair Check II system consists of a con trol unit and a disposable pressure sensitive Sensormat When the patient s weight on the Sensormat is removed for a pre selected number of seconds the control unit emits an alarm tone to let the staff know that the patient is no longer on the Sensormat and is in an unsafe position How to Use the Chair Check Il System A WARNING Use of mats not manufactured by will impair the effectiveness of the Chair Check unit 1 Plug the Chair Check II Sensormat cord connec tor into the bottom of the Chair Check II control unit 2 Attach the control unit to the back of the chair out of patient s sight and reach but where it is readily accessible to nursing personnel 3 Place Sensormat in the seat of the chair so that it will be beneath the pa
3. LT FROM USE OF THE CONTROL UNITS WITH ANOTHER MANUFACTURER S PRESSURE SENSITIVE MAT SENS ING DEVICE OR OTHER FALL PREVENTION PRODUCT NOTE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMI TATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU c Any defects or damage to the Control Units that may result from use of the Control Units with another manufacturer s parts pressure sensitive mat sensing device or other fall prevention product d Any failure that results from an accident purchaser s abuse neglect or failure to operate the Control Units in accordance with the instructions provided in the owner s manual s supplied with the Control Units e Any Control Units which have the serial numbers altered defaced or removed f Any Control Units which have been altered or modified in any way without the express written consent of Bed Check g Any Control Units which have been repaired other than by Bed Check 7 RESPONSIBILITIES OF WARRANTOR UNDER THIS LIMITED WARRAN TY a In the event of a defect malfunction or other failure of the product not caused by any misuse or damage to the product while in the possession of purchaser the war rantor will remedy the failure or defect without charge to the purchaser within a reason able time The remedy will consist of repair or replacement of the product or refund of the purchase price at the warrantor s option If the produ
4. ct is no longer available war rantor will supply purchaser with a comparable product or refund the purchase price at warrantor s option However the warrantor will not elect refund unless it is unable to provide replacement and repair is not commercially practicable and cannot be made within a reasonable time or unless the purchaser is willing to accept such refund b If this product or one of its component parts contains a defect or malfunction after a reasonable number of attempts by the warrantor to remedy the defects or malfunctions the purchaser will be entitled to either a refund or replacement of the product or its component part or parts Replacement of a component part includes its free installation 8 RESPONSIBILITIES OF THE PURCHASER UNDER THIS LIMITED WAR RANTY a Disinfect the Control Unit if necessary so that it is reasonably free from infectious matter b Package the Control Unit with a minimum of two inches of shock absorbent packag ing material Deliver or ship the Control Unit to Bed Check Freight costs if any must be borne by the purchaser c Use the Control Unit with reasonable care and in accordance with the supplied owner s manual THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO LIMITED WARRANTY BED CHECK SENSORMATS 1 WARRANTOR This limited Warranty is given by Bed Check 1620 N 20th Cir Lincoln NE 68503 2 DURATION This Li
5. ctions the purchaser will be entitled to either a refund or replacement of the product or its component part or parts Replacement of a component part includes its free installation 8 RESPONSIBILITIES OF THE PURCHASER UNDER THIS LIMITED WAR RANTY a Disinfect the Sensormat if necessary so that it is reasonably free from infectious matter b Package the Sensormat unfolded and in a flat position Deliver or ship the Sensormat to Bed Check Freight costs if any must be borne by the purchaser c Use the Sensormat with reasonable care and in accordance with the supplied owner s manual THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE LA WARNING This monitor may not be compatible with mats man ufactured by companies other than Bed Check Use of incompatible mats may result in injury or death and voids the product warranty Chair Check II Control Units are designed and manufactured to be used with Bed Check Sensormats Please call Bed Check immediately if you experience problems B Bed Check For the location and phone number of your area Bed Check distributor or for technical assistance contact Bed Check at 1 800 523 7956 Mailing Address PO Box 80238 Lincoln NE 68501 0238 Shipping Address 1620 N 20th Cir Lincoln NE 68503 1103 www bedcheck com
6. he mat the battery is low and should be replaced To replace the battery remove the four Phillips head bolts 4 40 x 1 and separate the two halves of the case Next remove the battery connector from the 9V battery being careful not to damage the wires or the connector Pull the battery away from the double sided adhesive strip replace with a fresh 9V alkaline battery reconnect the battery connector and reassemble the case When reassembling the case be careful not to overtighten the bottom two bolts Test the system daily for effectiveness Note The Chair Check II control unit includes an alkaline battery DO NOT ATTEMPT TO CHARGE AN ALKALINE BATTERY Charging an alkaline battery will damage the control unit and void the warranty The charging jack available on the control unit is to be used for charging Nickel metal Hydride batteries only The Nickel metal Hydride battery and recharger are optional items and must be special ordered Nickel Cadmium batteries are not recommended Troubleshooting Guide Problem No alarm Patient Out of Chair Check 1 Is the mat a Bed Check Sensormat 2 Is the cord between the Sensormat and control unit connected properly 3 Is the Sensormat bent because of misplacement or slipping out of position 4 Is there power to the unit Problem Alarm Triggered Patient In Chair Check 1 Is the Sensormat placed beneath the patient s buttocks 2 Is the patient s weight below
7. ing information is to be utilized when changing the operating configuration of the unit Configuration is changed by setting one or more of the four inline switches located on the rear of the unit under the serial number label It is nec essary to use the point of a pen or some other sharp object to change switch positions Switches are numbered from left to right Off is down and On is up IMPORTANT Unit must be RESET before new switch positions are activated mm au Ni m m SWITCH TAB UP ON LOUD BEEP amp INSTANT ALARM Default setting LOUD BEEP amp 1 SECOND DELAY LOUD BEEP amp 3 SECOND DELAY LOUD BEEP amp 5 SECOND DELAY SOFT BEEP amp INSTANT ALARM SOFT BEEP amp 1 SECOND DELAY SOFT BEEP amp 3 SECOND DELAY SOFT BEEP amp 5 SECOND DELAY WARBLE amp INSTANT ALARM WARBLE amp 1 SECOND DELAY WARBLE amp 3 SECOND DELAY WARBLE amp 5 SECOND DELAY FAST BEEP amp INSTANT ALARM FAST BEEP amp 1 SECOND DELAY FAST BEEP amp 3 SECOND DELAY FAST BEEP amp 5 SECOND DELAY Batter y The Chair Check II utilizes a standard alkaline 9 volt battery or optional rechargeable battery The more the alarm actually sounds the less service you will get from a battery If a low vol ume constant series of short beeps similar to the low battery tones of a smoke alarm occurs even when the patient is seated on t
8. mited Warranty begins on the date the product is delivered to the purchaser and continues for a period of one year or for the duration of the warranty stated on the Sensormat label from the date first installed whichever comes first 3 TO WHOM THIS LIMITED WARRANTY IS GIVEN This Limited Warranty is given to the original purchaser of Bed Check s products only 4 PRODUCTS COVERED This Limited Warranty covers all Bed Check Sensormats 5 WHAT IS COVERED UNDER THIS LIMITED WARRANTY Defects in material and workmanship which occur within the period described in para graph 2 Warrantor makes no other warranties expressed or implied including without limitation warrantor makes no warranty as to merchantability or fitness for a particular purpose 6 WHAT IS NOT COVERED UNDER THIS LIMITED WARRANTY a ANY INCIDENTAL INDIRECT OR CONSEQUENTIAL LOSS DAMAGE OR EXPENSE THAT MAY RESULT FROM ANY DEFECT FAILURE OR MALFUNC TION OF THE SENSORMAT ANY INCIDENTAL INDIRECT OR CONSEQUEN TIAL LOSS DAMAGE OR EXPENSE THAT MAY RESULT FROM USE OF THE SENSORMAT WITH ANOTHER MANUFACTURER S CONTROL UNIT OR OTHER FALL PREVENTION PRODUCT NOTE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMI TATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU b Any defects or damage to the Sensormat that may result from use of the Sensormat with another manufacturer s parts control unit or other fall pre
9. on the Sensormat If the system does not perform properly a different Sensormat may resolve the problem 8 If the patient gets out of the chair the Chair Check II will alarm for approximately ten minutes or until the RESET button is pressed Car e and Maintenance The control unit can be wiped with a damp cloth or sponge using mild detergents or sanitizing solution and water Never use alcohol strong detergents or harsh chemical cleaners Never immerse the con trol unit in any liquid Avoid unit placement in any area where it might come in contact with bodily fluids Damage caused by any fluid is not under warranty J Chair Check II control unit may not be effective with another manufacturer s sensing device Use of another sensing device may cause damage to the Chair Check II control unit and will void the Chair Check II warranty J Bending or folding the Chair Check II Sensormat may cause loss of effective operation J Internal maintenance should only be performed in a static controlled environment by qualified personnel The Sensormat can be cleaned in a similar manner and with similar solutions used to clean vinyl mattress covers To eliminate the possibility of cross contamination the Sensormat should only be used for one patient and then discarded Use beyond the warranty period can cause breakdown of the internal conductive ink and render the Sensormat inoperative Configur ation The follow
10. tient s buttocks Cover the Sensormat with a foam cushion or incontinence pad if desired a For Potty Check Sensormat see the in service flyer 937 4 Seat patient in chair The control unit will arm itself as indicated by a beep and flashing red light next to the Reset button 5 While Chair Check II is monitoring the red light will flash at intervals 6 To remove the patient from the chair or to repo sition the patient without sounding the alarm press the RESET button The unit will go into standby mode a If the patient s weight is removed from the Sensormat the unit will immediately begin to monitor again when the weight returns b If weight hasn t been removed press the RESET button a second time to re start monitoring c If the patient has not been removed within approximately one minute the Chair Check II will automatically resume monitoring of the patient The monitoring mode will be indicated by a beep and the red flashing light Do not position either component of the system in such a manner that causes one to pull against the other causing stress to the Sensormat cord or its connecting plug 7 Nursing personnel should test the system daily for proper functioning If the patient weighs 100 pounds or more the nurse may test the system using just hand pressure on the Sensormat If the patient weighs less than 100 pounds system func tion should be checked using the actual patient s presence
11. vention product c Any failure that results from an accident purchaser s abuse neglect or failure to operate the Sensormat in accordance with the instructions provided on the Sensormat label d Any Sensormat which has the serial numbers altered defaced or removed Any Sensormat which has been altered or modified in any way without the express written consent of Bed Check f Any Sensormat which has been repaired other than by Bed Check 7 RESPONSIBILITIES OF WARRANTOR UNDER THIS LIMITED WARRAN a In the event of a defect malfunction or other failure of the product not caused by any misuse or damage to the product while in the possession of purchaser the warran tor will remedy the failure or defect without charge to the purchaser within a reasonable time The remedy will consist of repair or replacement of the product or refund of the purchase price at the warrantor s option If the product is no longer available warran tor will supply purchaser with a comparable product or refund the purchase price at warrantor s option However the warrantor will not elect refund unless it is unable to provide replacement and repair is not commercially practicable and cannot be made within a reasonable time or unless the purchaser is willing to accept such refund b If this product or one of its component parts contains a defect or malfunction after a reasonable number of attempts by the warrantor to remedy the defects or malfun
Download Pdf Manuals
Related Search