EXAMPLE OF A USER`S MANUAL
Contents
1. e The regulator must not be in contact with the wall or floor PORCELANOSA Grupo noken PORCELANOSA The electronic regulator must be installed to 230V systems only For devices without a plug observe the following colours WIRE COLOUR _ CONNECTION POINT Blue class 1 Grey class Il Neutral Yellow green Earth class only An omni pole cut out exclusively for the appliance is obligatory All contacts must be at least 3 mm apart lt is obligatory for the power supply system to which the regulator is connected to have extra sensitive differential protection The regulator may be in class or Il In the bathroom it can be installed in zone 3 see figure 1 so long as the control device is out of the reach of people using the shower or bath tub The power lead must be connected to a socket or connection block which must be at least 25 cm from the floor without an intermediate plug for devices sold without plugs Ea aa oe a an eee i ie a i gt E Seb eae wan e a ZONE W t ZONE2 BOSS ZONE 3 Figure 1 Bathroom zone classification PORCELANOSA Tupo noken PORCELANOSA Installation of towel warmer radiator The towel warmer must be attached to the wall with the brackets provided The regulator must be installed at a distance from the wall of 40 mm minimum to 80 mm2. ATTENTION To avoid hazards for children this appliance should be installed so that the lowest heated grille is at least 600 mm from the floor P Omn PORCELANOSA Grupo noken PORCELANOSA Instructions for use The device is an illuminated switch used to power a towel warmer When the switch is illuminated the towel warmer is on Take care not to damage the transparent protection on the switch PORCELANOSA Grupo noken n D r i C 4 k if as C A A w I rv IN J AN Technical characteristics Operating voltage 230V 10 AC 50 Hz Maximum power of heating element 2000W Insulation class Class or Il Water protection class PX4 Mechanical protection for connection IKO5 block Operating temperature 0 50 C Storage temperature 20 80 C Humidity rating 0 85 without condensation WARRANTY The product is guaranteed against manufacturing defects for two years from the date of purchase In the event of replacements parts are guaranteed for one year labour and installation excluded The warranty will be taken into consideration on presentation of a receipt showing the date of purchase to the after sales service engineer who carries out the repairs Installation must be carried out in a workmanlike way and comply with the current standards in the country where the product is installed PORCELANOSA Grupo
3. exclusively to sockets or connector blocks with earthed contacts to current standards Avoid contact with any chemical product or alcohol including the liquid in the radiator The appliance is not for use by people including children with reduced physical sensorial or mental capacities or with no experience or knowledge of the appliance unless they are accompanied by a person or guardian responsible for their safety or have been able to read the instructions for its use Always be in attendance to make sure children do not play with the appliance Install the towel warmer so that the bottom part is at least 60 cm from the floor Do not insert metal objects or fingers even temporarily into the area where the radiator or towel warmer is connected PORCELANOSA Grupo noken PORCELANOSA INSTALLATION e Do not install the towel warmer with the regulator on top e Do not install the towel warmer under or in front of a power socket or connector box Q
4. noken PORCELANOSA EXAMPLE OF A USER S MANUAL Uli IMPORTANT Read the instructions carefully before installing or using the regulator and keep the manual to hand for future consultation PORCELANOSA Grupo noken i VO FCE ARI EC A J r 7 sy J N i 1 Regulator for the control of electric towel warmers used for drying items of clothing washed in water and room heating Any other use is forbidden Always check that the master switch has been turned off before starting any installation or maintenance operations Do not use the device before it has been properly and completely installed Do not turn on before attaching the heating element recommended by the manufacturer and checking that the O ring is intact and properly Do not cut the power lead to stop regulation Do not use the regulator with heating elements if there is no safety device lf the power lead is damaged the device must be replaced Nominal voltage for the regulator must be the same as that on the mains 230V AC 10 The socket only for devices with plugs and electricity supply must be adequate to support the required power The socket must be compatible with the regulator plug only for devices with plugs Check that the electricity supply system is provided with a differential omni pole safety cut out connected directly to the socket or connection box involved Class devices yellow green wire or earthed plug must be connected
Download Pdf Manuals
Related Search