90554337 PIUSB 5 watt charger
Contents
1. BLACKS DECKER 5 WATT USB PERSONAL ELECTRONICS CHARGER INSTRUCTION MANUAL Catalog x i Number J PIUSB BEFORE RETURNING THIS PRODUCT FOR ANY REASON PLEASE CALL 1 877 571 2391 BEFORE YOU CALL HAVE THE CATALOG No AVAILABLE IN MOST CASES A REPRESENTATIVE CAN RESOLVE THE PROBLEM OVER THE PHONE PLEASE READ BEFORE RETURNING THIS PRODUCT FOR ANY REASON If you have a question or experience a oo with your Black amp Decker purchase go to HTTP WWW BLACKANDDECKER COM INSTANTANSWERS for instant answers 24 hours a day If you can t find the answer or do not have access to the internet call 1 800 544 6986 from 8 a m to 5 p m EST Mon Fri to speak with an agent Please have the catalog number available when you call A GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES READ ALL INSTRUCTIONS A WARNING Read all instructions before operating product Failure to follow all instructions listed below may result in electric shock fire and or serious injury e AVOID DANGEROUS ENVIRONMENTS Don t use appliances in damp or wet locations Don t use appliances in the rain e KEEP CHILDREN AWAY All visitors should be kept at a distance from work area STORE IDLE APPLIANCES INDOORS When not in use appliances should be stored indoors in dry and high or locked up place out of reach of children e DON T FORCE APPLIANCE It will do the job better and with less likelihood of a ris2. in appliance with finger on switch Be sure switch is off when plugging in PROPER COOLING is essential when operating the charger Do not place the unit near the vehicle s heat vent or in direct sunlight ELECTRICAL FAULT CIRCUIT INTERRUPTER protection should be provided on the circuits or outlets to be used Receptacles are available having built in electrical fault circuit INTERRUPTER protection and may be used for this measure of safety e USE OF ACCESSORIES AND ATTACHMENTS The use of any accessory or attachment not recommended for use with this appliance could be hazardous Note Refer to the accessory section of this manual for further details e STAY ALERT Watch what you are doing Use common sense Do not operate tool when you are tired DO NOT OPERATE charger if it has received a sharp blow been dropped or otherwise damaged e CHECK DAMAGED PARTS Before further use of the tool a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function Check for alignment of moving parts binding of moving parts breakage of parts mounting and any other conditions that may affect its operation A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this instruction manual Have defective switches replaced by authorized service center Do not use tool if
3. switch does not turn it on and off e DO NOT OPERATE portable electric tools near flammable liquids or in gaseous or explosive anne pees Motors in ee tools normally spark and the sparks might ignite umes DANGER Indicates an imminently hazardous situation which if not avoided will result in death or serious injury A WARNING Indicates a potentially hazardous situation which if not avoided could result in death or serious injury CAUTION Indicates a potentially hazardous situation which if not avoided may result in minor or moderate injury CAUTION Used without the safety alert symbol indicates a potentially hazardous situation which if not avoided may result in property damage RISK OF UNSAFE OPERATION When using tools or equipment basic safety precautions should always be followed to reduce the risk of personal injury Improper operation maintenance or modification of tools or equipment could result in serious injury and property damage There are certain applicanon for which tools and equipment are designed Black amp Decker strongly recommends that this product NOT be modified and or used for any application other than for which it was designed Read and understand all warnings and operating instructions before using any tool or equipment A WARNING TO REDUCE THE RISK OF ELECTRIC SHOCK Do not make any electrical connections or disconnections in areas designated as IGNITION PROTECTED This includ
4. this Instruction Manual and Common Power Output Problems in the following section Common Power Output Problems Possible Causes Recommendations Battery voltage Recharge battery or check below 10 5 volts DC power supply Equipment being operated Reduce load to maximum draws too much power 5 watts Although this unit has two outlets some phones and PDAS can take 5 watts 17 Chager in thermal shutdown condition from a single outlet Connecting another device to the second outlet in this case will cause the charger to shut down Allow charger to cool down Ensure there is adequate ventilation around the unit and the load is no more than 5 watts for continuous operation Replacing the fuse in the DC plug Remove the cap by turning it counter clockwise Remove the cap and pin Remove the fuse Fit a new fuse of the same type and size 1 6A Refit the cap and pin Tighten the cap by turning clockwise onto the plug 18
5. anual 5 If the charger does not work make sure the ignition accessory outlet is powering the accessory outlet Some vehicles require the ignition switch to be turned on 6 Lift the USB cover 2 to allow access to one or both of the USB ports 1 7 Plug the USB powered device into the USB Charging Port and operate normally Note You can operate two USB devices simultaneously Notes This charger does not Support data communication It only provides 5 volts 500mA DC power to an external USB powered device Remember to disconnect the unit from any power source when it is not in use 14 Protective Features The charger monitors the following conditions Low Battery Voltage This condition is not harmful to the charger but could damage the power source so the inverter will automatically shut down when input voltage drops below 10 5 0 5 volts DC The charger will automatically reset when the voltage improves to 11 5V Overload Short Circuit Protection The charger will automatically shut down when a short circuit occurs A reverse polarity or short circuit condition may cause external or internal fuses to open and may cause irreversible damage to the appliance Notes The Power Fault LED Indicator will light red to indicate a Fault condition before automatic shutdown occurs If unit shuts down to restart it you must remove it from the power source wait for a few seconds and then re in
6. are no user serviceable parts inside Do not use this charger with medical devices It is not tested for medical applications e Keep away from children This is not a toy Install and operate unit only as described in this Instruction Manual Do not use this charger on a watercraft It is not qualified for marine applications e Read And Understand This Instruction Manual Before Using This Unit THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR THE 5 WATT USB PERSONAL ELECTRONIC CHARGER MODEL PIUSB N WARNING TO REDUCE THE RISK OF INJURY Follow these instructions and those eee by battery manufacturer and the manufacturer of any equipment you intend to use with this unit Review cautionary markings on these products and on engine INTRODUCTION Thank you for purchasing the PIUSB 5 watt USB Personal Electronics Charger This charger can be used to operate personal electronics and mobile office mn such as MP3 players cell phones PDAs and more Please read this Instruction Manual carefully before use to ensure optimum performance and to avoid damage to this product FEATURES 5 watts continuous output Two 5 volt DC USB Charging Ports Bi color Power Fault LED Indicator Compact efficient and quiet Protective Outlet Cover Electronic circuit protection prevents damage due to overload insufficient ventilation overheat condition Low battery shutdown Refer to t
7. es DC cigarette lighter type plug connection This unit is NOT approved for ignition protected areas e NEVER immerse the unit in water or any other liquid or use when wet Do not insert foreign objects into the USB outlets N WARNING TO REDUCE THE RISK OF FIRE Do not operate near flammable materials fumes or gases DO NOT expose to extreme heat or flames CAUTION TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE e Remove plug from 12V DC accessory outlet before working on the charger DO NOT attempt to connect or set up the unit or its components while operating your vehicle Not paying attention to the road may result in a serious accident 7 e Always use the charger where there is adequate ventilation Do not block ventilation slots e ALWAYS turn the charger OFF by disconnecting it from the DC accessory outlet when not in use Make sure the nominal powering voltage is 12 volts DC center connection positive e When using this unit in a vehicle check the vehicle owner s manual for maximum power rating and recommended output Do not install in engine compartment install in a well ventilated area Do not use with positive ground electrical systems Reverse polarity connection will result in a blown fuse and may cause permanent damage to the charger and will void warranty The majority of modern automobiles RVs and trucks are negative ground Do not open the charger there
8. he Specifications section HOW THIS CHARGER WORKS Your Black amp Decker USB charger is designed to convert 12 Vdc to 5 Vdc It allows the 12 Vdc in an automobile to supply 5 Vdc power to operate equipment that is normally supplied from a USB power source The charging cable specifically designed for the electronic device being charged is required May not work for all electronic devices This product is intended for consumer use only Note Some mobile phone leads do not allow chargin from a standard USB port check with the mobile phone manufacturer 10 Controls and Functions 1 USB Charging Port x 2 2 USB cover 3 Power Fault LED Indicator 4 12 Volt DC Vehicle Adapter Plug SSE A CAUTION Rechargeable Devices If there is any sign that your appliance is behaving differently to that when connected to the normal power source then unplug and seek advice from your appliance manufacturer 11 OPERATING INSTRUCTIONS Power source requirements The power source must provide 12 Vdc and must po ee supply the necessary current to operate the load A WARNING The charger must be connected only to batteries with a nominal output voltage of 12 Volts The appliance will not operate from a 6 Volt battery and will sustain permanent damage if connected to a 24 Volt bat tery The Power Fault LED Indicator lights green when the charger is properly connected to a functioning DC power source The USB ou
9. k of injury at the rate for which it was designed USE RIGHT APPLIANCE Do not use the appliance for any job except that for which it is intended DRESS PROPERLY Do not wear loose clothing or jewelry They can be caught in moving parts Rubber gloves and substantial non skid footwear are recommended when pear outdoors Wear protective hair covering to contain ong hair e USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT Use safety goggles or safety glasses with side shields complying with applicable safety standards and when needed a face shield Also use face or dust mask if operation is dusty This applies to all persons in the work area Also use a hard hat hearing protection gloves safety shoes and dust collection systems when specified or required Safety glasses or the like are available at extra cost at your local dealer or Black amp Decker Service Center e DON T ABUSE CORD Never carry prian by cord or yank it to disconnect from receptacle Keep cord from heat oil and sharp edges TO REDUCE RISK OF DAMAGE to the product pull by the connector rather than a cord when disconnecting charger DO NOT OPERATE charger with damaged cord or cigarette lighter connector replace it immediately DISCONNECT APPLIANCES Disconnect the appliance from the power supply when not in use before servicing and when changing accessories such as blades and the like e AVOID UNINTENTIONAL STARTING Don t carry plugged
10. sert the unit into the power source Operating Tips The charger should only be operated in locations that are DRY Do not allow water or other liquids to come into contact with the charger COOL Surrounding air temperature should ideally be 10 20 C 50 68 F Keep the charger away from direct sunlight when possible WELL VENTILATED Keep the area surrounding the charger clear to ensure free air circulation around the unit Do not place items on or over the charger during operation The unit will shut down if the internal temperature gets too hot CARE AND MAINTENANCE Storage 1 Ideal storage temperature range is 0 40 C 32 104 F 2 Store and use the charger in a cool dry place with adequate ventilation for all around air circulation 3 Avoid locations that are exposed to heating units radiators direct sunlight or excessive humidity or dampness TROUBLESHOOTING Power Fault LED Indicator Lights Green If the green LED indicator 3 is not lit check that all the DC connections are connected correctly check the tightness of the DC connection NOTE Make sure that your accessory outlet is live You may need to turn the ignition key to the accessory position Power Fault LED Indicator Lights Red When the Power Fault LED Indicator turns from green indicating the unit is powered to red a fault condition is prenem and the unit will automatically shut down See the rotective Features Section of
11. tlets are ready to use If the Power Fault LED Indicator lights red refer to the Troubleshooting Section of this Instruction Manual To turn the unit off disconnect it from the 12 volt DC power source Always connect the charger to the 12 volt DC power source before plugging any devices into the unit The USB outlets allow simultaneous operation of two devices Simply plug the equipment into the unit and operate normally 12 Note Do not attach a USB extender to this unit to allow additional items to be added To prevent damage the unit will shut down if it is over loaded To restart the unit you must remove it from the power Source wait for a few seconds and then re insert he unit into the power source Operation of the USB Charging Ports The tip of the plug is positive and the side CABINCKE contact is negative Unfold the 12 Vdc accessory h plug 4 from the body of the stick to one of the preset positions figure A 2 Connect the unit to a vehicle s accessory outlet or other 12 volt DC power gt source Make sure there is adequate space for proper ventilation of the charger 3 Rotate the unit slightly to make sure there is good contact 4 The Power Fault LED Indicator 3 will light green indi cating a proper connection If the Power Fault LED Indicator lights red a Fault condition exists Refer to the Troubleshooting Section of this Instruction M
Download Pdf Manuals
Related Search