DMX-Relaisinterface 8 SSR
Contents
1. ii a Se a j 46 1 ses 2 K ale a lt OUT1 OUT8 Switching output 1 8 max 2A 250V DM ALL DMX Relaisinterface 8 SSR Connecting the consumer z B 230V DMX2008 Addressing The starting address is adjustable via the switches 1 to 9 Switch 1 has the valency 2 1 switch 2 the valency 2 2 and so finally switch 9 has the valency 2 256 The sum of the switches standing on ON correspond with the start address loi DM wm ALL DMX Relaisinterface 8 SSR 5 CE conformity CE This assembly board is controlled by a microprocessor and uses high frequency 8 2 To get the characteristics of the assembly in relation to the CE conformity an installation in a compact metal casing is necessary Risk Notes You purchased a technical product Conformable to the best available technology the following risks should not excluded Failure risk The device can drop out partially or completely at any time without warning To reduce the probability of a failure a redundant system structure is necessary Initiation risk For the installation of the board the board must be connected and adjusted to foreign components according to the device paperwork This work can only be done by qualified personnel which read the full device paperwork and understand it Ope2. DMX Relaisinterface 8 SSR User Manual DM ww ALL DMX Relaisinterface 8 SSR 2 Description The DMX Relaisinterface 8 SSR has 8 floating outputs make contact controllable via DMX Energy Saving Design Based on modern switching mode technology less warmth is generated and therefore the energy consumption will be reduced Technical Data Voltage supply 7 24V DC 100 DMX Channels 8 Outputs 8 SSR switching outputs make contact 2 250V SolidState Relais SSR 5202512 Board Dimensions 99mm x 82mm LED Display Codes The integrated green LED is a multifunction display In the normal operation mode the LED flashes permanent In this case the device is working If the LED is permanently dark no DMX512 signal is detected Furthermore the events are signalled about the green LED In this case the LED lights up in short pitches and then is dark for a longer time The number of the flashing impulses corresponds with the event number Event Description number Addressing error Please check the adjusted DMX address 3 DMX signal error An invalid DMX input signal was noticed Exchange the signal lines on pin 2 amp 3 or use a twisted pair wire DMX LL DMX Relaisinterface 8 SSR WWW DMX4ALL DE Connecting the Interface O gt wz N GND NC DMX DMX GND i f 4 un Le 4 a 5 z TEJA ee
3. rating risk The Change or the operation under special conditions of the installed systems components could as well as hidden defects cause to breakdown within the running time Misusage risk Any nonstandard use could cause incalculable risks and is not allowed Warning It is not allowed to use the device in an operation where the safety of persons depend on this device ALL WWW DMX4ALL DE DM DMX4ALL GmbH Reiterweg 2A D 44869 Bochum Germany Copyright 2013 DMX4ALL GmbH All rights reserve No part of this manual may be reproduced in any form photocopy pressure microfilm or in another procedure without written permission or processed multiplied or spread using electronic systems All information contained in this manual was arranged with largest care and after best knowledge Nevertheless errors are to be excluded not completely For this reason see myself compelled to point out that can take over neither a warranty nor the legal responsibility or any adhesion for consequences which decrease go back to incorrect data This document does not contain assured characteristics The guidance and the characteristics can be changed at any time and without previous announcement
Download Pdf Manuals
Related Search