2.4GHz Wireless Surveillance System--- VC-S101
Contents
1. 2 4 GHz WIRELESS SYSTEM USER S MANUAL 1 INTRODUCTION mE I 2 PACKAGE CONTENTS nn 3 3 CONTROLS o 4 SYSTEMINSTALLATION 5 5 OPERATION EUER 6 TROUBLESHOOTING z 7 GENERAL SAFETY SUMMARY RISK OF ELECTRONIC SHOCK DO NOTOPEN CAUTION DO NOT REMOVETHE COVER FORREDUCING THE RISKOF ELECTRIC SHOCK NO USER SERVICEABLE PARTS INSIDE REFERSERVICING TOQUALIFIED SERVICE PERSONNEL WARNING Toprevent fire orshock hazard do not exposethe unit torain or moisture IMPORTANT SAFETY INSTRUCTIONS 1 All the safety and operating instructions should be read before the product is operated 2 The safety and operating instructions should be retained for future reference 3 All warnings on the product and in the operating instructions should be adhered to 4 All operating and use instructions should be followed 5 Unplug this products from the wall outlet before cleaning Do not use liquid cleaners or aerosol cleaners Use a damp cloth for the cleaning 6 Do not use attachments not recommended by the products manufacturer if they may cause hazards 7 Do not use this product near water for example near a bath tub wash bowl kitchen sink or laundry tub in a wet basement or near a swimming pool and the like 8 Any mounting of the product should follow the manufacturer s instructions and should use a mounting accessory recommended by the manufacturer 9 This product should be operated only from2. 10 C 50 C Lens Optional F3 6 mm F2 0 Fix Board Lens Audio Input 1 0Vpp 600 load for Mono Weight Approximate 160g Size 116Lx 45W x52 5H mm Model Wireless Camera CCD Characteristic Specification Scanning System 2 1 Interlace 2 1 Interlace NTSC PAL Image Sensor 1 4 CCD Image Sensor Efficiency Pixels 512 H X492 V 512 H X582 V Horizontal Scan Frequency 15750 Hz 15625 Hz Vertical Scan Frequency 60 Hz 50 Hz Synchronize Internal Resolution More Than 420TV Lines Min Illumination 0 3LUX F1 2 S N Ratio More Than 48dB AGC OFF Video Input 1 0Vpp 75Q composite Video Signal Auto Electronic Exposure 1 60 1 10000 seconds 1 50 1 10000 seconds Auto White Balance Auto Supply Voltage 9V Power Consumption 200 Operation Environment 10 C 50 C Lens Optional F3 6 mm F2 0 Fix Board Lens Audio Input 1 0Vpp 600 2 load for Mono Weight Approximate 160g Size 116Lx 45W x52 5H mm Toprovide the latesttechnolog reserve the rightto change the ies product toour customer is our responsibility therefore we specifications without priornotice 2 PACKAGE CONTENTS One unit of Wireless Camera The Wireless Cameraemits Audioand Video signals over 2 4GHzradio frequency carrier One unit of Receiver The Receiver receives 2 4GHz wireless Audio and Video signals from the Wireless Ca
3. igh Resolution Color CMOS CCD Camera Optional High Performance Audio Video Receiver Built In Microphone forAudio Monitoring Operating frequency oflSM band 2 4 2 4835 GHz Video camerarecording purpose connectedto VCR Outdoor and homesurveillance system Building and office surveillance system Specifications Model Receiver Characteristic Specification Frequency 2400 MHz 2483 MHz Receiver Sensitivity 90 dBm min Channel Number 4 2414 2432 2450 2468 MHz L O Stability 100 KHz typ Video Output Level 1Vpp 750 Audio Output Level 1 Vpp 6000 Supply Voltage 9V Power Consumption 200 mA typ Antenna Embedded Operation Environment 10 C 50 C Dimension 83W x 70H x 42L mm Wireless Camera CMOS Characteristic Specification Scanning System 2 1 Interlace 2 1 Interlace NTSC PAL Image Sensor 1 3 CMOS Image Sensor Efficiency Pixels 510 H X492 V 628 H X582 V Horizontal Scan Frequency 15750 Hz 15625 Hz Vertical ScanFrequency 60 Hz 50 Hz Synchronize Internal Resolution More Than 300 TVLines Min Illumination 3 LUX F1 2 SIN Ratio More Than 45dB AGC OFF Video Input 1 0Vpp 75Q composite Video Signal Auto Electronic Exposure 1 60 1 2000 seconds 1 50 1 2000 seconds Auto White Balance Auto Supply Voltage 9V Power Consumption 120mA Operation Environment
4. ing the channel of Wireless Camera is necessary please referto page 8 How to adjustthe Channel Selectorof Wireless Camera 5 Wireless Surveillance Systemwatches wherever you want Note The operation temperature isfrom 10 C 50 C 6 TROUBLE SHOOTING Please read thisuser s manual carefully before using the Wireless Surveillance System If youstill have difficulties to usethe Wireless Surveillance System consult the followingsyndrome which willguide you tosolve most common problems Interference in the Image and Sound Move your Wireless Camera or Receiverslowly to finda best reception position e Shorten the distance between your Cameraand Receiver Check if thereis any interference radio frequency source near your Receiver source such asmicrowave oven orothers 2 4 GHz electronic products Switch channels ofboth Camera andReceiver to anotherchannel e g from CH1 to CH3 No Pictures or Sound e Check the DCadaptors rightly connected Power ON OFF switchin right position Check all thecables well andrightly connected Checkthe channelsof wireless cameraand receiver atthe same one Receiver can not work properly when connecting with PC Make sure thesurveillance system workproperly if connecting with TV e Check all thecables well andrightly connected when connecting with PC Check PCI capturecard and software driver installed correctly H
5. mera One unit of Wall Mounting Bracket The wall mounting bracket is usedto bolster up the Wireless Camera onthe wall Two units of Power Adaptor Two poweradaptors supply 9V 300mA DC power to the Wireless Camera andthe Receiver One unit of Tripod The tripod isused to bolsterup the Wireless Camera One unit of RCA SCART Cable 2RCA o phone plug The RCA SCART cable is usedto connect the Receiver to yourA V displays SCAR fo phone pig A V displays computermonitor converted card required powered speakers TV monitor etc One unitof Ceiling Mounting Optional The ceiling mountingbracket is usedto bolster H up the Wireless Camera Sd Note If any accessories listed aboveare missing please contact the sales representative where you purchase the Wireless Surveillance System 3 CONTROLS Wireless Camera Front 1 Lens 2 Microphone Bottom 4 3 Channel Rubber Lo T 4 TripodScrew Nut ALA Ceiling Mounting Screw Nut t A 4 ES 5 Power Cable w 6 Power Indication LED 4 7 Wall Mounting Slide 6 3 Top 8 Ceiling MountingScrew Nut Receiver Front amp Side 1 Power Switch 2 Channel Selector 3 AV Connector 4 Adaptor Connector 5 Power Indication LED 4 SYSTEM INSTALLATION k Wireless Camera Fasten the Mounting Bracket on the wall or ceiling must underthe roof Slide the Wireless Camera i
6. nto the Wall Mounting Bracket Connect Wireless Camerawith the attached adaptor and plugthe adaptor intothe power outlet F su NX Combine the Tripod and Wireless Camera to assist parents intaking care ofthe baby ss Y fe T Two waysto combine the Ceiling Mounting Bracketand Wireless Camera Ceiling Mounting Bracketis selected 1 Screw the ceiling mounting 2 Screw the ceilingmounting bracket into screwnut on topof bracket into screwnut on bottom the wireless camera of the wireless camera Receiver Phone plug to2RCA SCART connecting with TV Connect Receiver by phone plug to TV with RCA Cable Plug Receiver intothe power outletwith attached adaptor Phone plug to2RCA connecting with PC Connect Receiver by phone plug to PCI PCI Capture Card Capture Card ofPC with RCACable Plug Receiver intothe power outletwith 1 y attached adaptor 5 OPERATION 1 Turn onthe Wireless Cameraand Receiver 2 The power indicationLED on Wireless Camera and Receiverwill light up 3 Turn on A V display 4 Check the channelof Receiver tobe same as Camera setup to 1 originally gt e E F Re Switch the Receiver s Channel Selector to CH 1 Image will showon A V display if thechannel of Wireless Camera and Receiver is atthe same one O f imagesor sound display switch theReceiver s Channel Selector to CH2 3 or4 and checkthe images again O If switch
7. ow to adjust the Channel Selector of Wireless Camera e Use a toolto open the channel rubber Switch inside selectorby the toolto adjust thechannel you wantto set Warning Changes or modificationsto this unitnot expressly approvedby the party responsible for compliance could void theuser authority tooperate the equipment This device complies with Part 15of the FCC Rules Operation issubject to the following two conditions 1 this device may not cause harmful interference and 2 this devicemust accept anyinterference received includinginterference that may cause undesiredoperation The user manualor instruction manualfor an intentionalor unintentional radiator shall caution theuser that changesor modifications notexpressly approved bythe party responsible for compliance could voidthe user s authorityto operate the equipment Version 1 2
8. the type of power source indicated on the marking label If you are not sure ofthe type or power supply to your home consult your product dealer or local Power Company For products intended to operate from battery power or other sources refer to the operating instruction 10 Power supply cord should be routed so that they are not likely to be walked on or pinched by items placed upon or against them paying particular attention to cords at plugs or other sources refer to the operating instructions 11 For added protection for this product during a lightning storm or itis left unattended and unused for long periods of time unplug it from the wall outlet and disconnect cable system This will prevent damage to the product due to lightning and powerline surges 12 Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electronic shock Never spill liquid of any kind on the product 13 Do not overload wall outlets extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock 14 Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions e When the power supply cord or plug is damaged e If liquid have been spilled or objects have fallen into the products e If the product does not operate normally by following the operating instruc
9. tions adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore this product to its normal operation e the products has been dropped or damaged in any way e When the product exhibits a distinct change in performance this indicates a need for service 15 When replacement parts are required be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part Unauthorized substitutions may result in fire electric shock or other hazards 16 Upon completion of any service or repair to this product ask the service technician to perform safety checks to determine that the product is in proper operating condition 17 The product should be situated away from heat sources such as radiators heat registers stoves or other products including amplifiers that produce heat 1 INTRODUCTION Overview The Wireless Surveillance System with CMOS CCD Images and four channels available isjust as yourbaby sitter home camp guard and company monitoring Easyto install unequalled quality and reliability make you havedelighted and securelife Features Weather Proof Antenna embedded 4 channels selectable Easy installation Applications Baby Medicalcare monitor Range up to300 feet L O S H
Download Pdf Manuals
Related Search