Home
DAN9RC - Daniela Appliances
Contents
1. DANIRC TELESCOPIC HOOD USER S MANUAL INSTRUCTIONS FOR INSTALLATION AND USE For original parts amp reliable service Table of Contents e From the Manufacturer e Specifications e SAFETY Read this first e Vent System Requirements e Ducted vs Re circulating e Description of Parts e Instruction for Use e Technical Information e Installation e Cleaning amp Maintenance e Troubleshooting e Schematic Diagram 4 9 6 Schematic Diagram AC220V 240V 50Hz K2 Light Switch J Microswitch 15 Troubleshooting Symptoms Does not function Poor airflow Motor running but no airflow Motor cuts after a few minutes Charcoal filters not installed Strong cooking smell Oil dripping onto stove 14 Possible Cause Check that the plug is connected Check that the main switch is turned on Clean the filters and replace Charcoal grease filters Replace charcoal filters with clogged new sets Butterfly valve jammed No electrical supply Aluminum filters grease Contact technician High temperature safety device activated The kitchen is not sufficiently The hood must be at least 65cm from stove The hood is installed too near the cooking stove In re circulating mode charcoal filters must be Aluminum grease filter Wash the aluminium grease Aluminum grease filter Wash the aluminium grease saturated filters Whirring sound Foreign ob
2. A Automatic i High To achieve better extraction we recommend switching on the extractor a few minutes before starting to cook 3 5 minutes so that the air flow is continuous and stable when extracting fumes Likewise keep the extractor switched on for a few minutes when cooking is complete to allow all fumes and odors to be expelled
3. care to disconnect the mains beforehand and that the lamp to be replaces are not hot The maximum lamp power is 3W 13 Cleaning amp Maintenance Before carrying out any cleaning or maintenance activities ensure that the appliances is disconnected from the mains and follow the safety Instructions Filter Cleaning To withdraw the filters from their locations release the anchoring points Clean the filter either putting in the dishwasher refer to notes or leaving it standing in hot water to simplify the removal of grease or if wished by means of special sprays protecting the non metallic parts Once clean leave it to dry Notes cleaning in the dishwasher with aggressive detergents may blacken the surface of metallic parts without this affecting its gas retaining properties The filter must be cleaned at least once a month depending on how often the appliances is used It must be remembered that grease is deposited in the extractor when cooking whether it is switched on or not Cleaning the appliances body The use of 40 C approx soapy water is recommended A cloth moistened in this water is used for cleaning the extractor paying special attention to the grids and dry it using a lint free cloth Note Never use metallic scouring pads or abrasive products that could damage the surface Do not use scrapers with metallic surfaces such as knives scissors etc 12 SAFETY Read this First Continued e
4. with earth that is correct for your location e Check that the voltage in your area is correct before plugging in e The electrical connection of this appliance must be connected to earth Green amp yellow EARTH Blue NEUTRAL Brown LIVE e Multiple plugs and extension cables must not be used Overload is dangerous and may cause a fire e Ensure that the power supply chord is free from any heat source or sharp objects e The appliance should be switched off and the electrical supply disconnected before any cleaning or maintenance work can be carried out e This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Cleaning amp Maintenance continued Activated charcoal filter To install the charcoal filter the motor anchorage is made to coincide with the anchor points of the activated charcoal filter inserting and locking into place The carbon filter lasts from three to six months depending on the particular conditions of use The activated carbon filter can neither be exhausted it must be changed Once it is exhausted it must be changed Changing Lamp Remove the filter support to access the lamp Take
5. If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard There is a fire risk if cleaning is not carried out in according with the instructions The hood use four hob element at most Vent System Requirements Determine which venting method is best for your application Vented non recirculating system must be terminate to the outside Ductwork can extend either through the wall or the roof Do not terminate the vent system in an attic or other enclosed area The length of the ductwork and the number of elbows should be kept to a minimum to provide efficient performance The size of the ductwork should be uniform Do not install two elbows together Use duct tape to seal all joints in the ductwork system Use caulking to seal exterior wall or floor opening around the cap Make sure there is proper clearance within the wall or floor for exhaust duct before making cutouts Do not cut a joist or stud unless absolutely necessary If a joist or stud must be cut then a supporting frame must be constructed Ducted vs Re circulating Your cooker hood can be configured to operate in the ducted or re circulating mode Depending on model A DUCTED MODE VENTED MODE e Inthe ducted mode cooking fumes are vented outdoors through suitable connection of 125mm diameter In this mode only the aluminum filters are installed 415 Installation To fi
6. ject in contact with Contact technician From the Manufacturer e This appliance and it s packaging are produced by processes that minimize waste and respect the environment e Please help us to continue the protection of the environment by disposing of the packaging in a correct manner e Safety e Please do not allow young children to play with the plastic bag packaging e Before disposing of any old appliances be sure to cut off the power chord so that others will not be endangered by a defective electric appliance Input 240V 50Hz Absorption e 2 motor version 2 X 85W e 1 motor version 1 X 85W Lamps 2 X 1 5W Total Power e 2 motor version 173W e 1 motor version 88W External Dimensions e 60cm version i 600x280x180mm e 90cm version l 900x280x180mm SAFETY Read this First e Do not connect the appliance if there are obvious signs of transportation damage e Read this user manual thoroughly before attempting to use this appliance e installation and repair should be attempted only by qualified technical personnel e It is dangerous to modify any part of this appliance e The manufacturer declines all responsibility in case of failure to adopt proper safety measures e Ensure the location in which this appliance is installed has good permanent ventilation e The distance between the bench top to the lower part of the hood must not be at less than 65 cm or higher than 75 cm e Use an electrical connector
7. x the extractor to the kitchen unit The lower part of the extractor must be located at a minimum height of 60cm above the hob for electric cookers and 65cm for gas cookers If the instructions of a gas cooker indicate a greater distance these must be observed When the extractor is working at the same time as other non electrical cooking equipment the outlet air pressure must not exceed 4 Pa To achieve optimum performance the length of the outlet hose should not exceed 4 meters or include more than two 90 angles elbows Although venting to the outside is recommended activated carbon filters may be used which allow the gas to be returned to the kitchen through the outlet pipe Ducted vs Re circulating Continued Technical Information B RE CIRCULATING MODE Depending on model Dimensions Width 600 900 mm Depth 280mm Height 180mm e Fumes are filtered for grease and odors through the aluminum grease filters and the charcoal filters respectively and re introduced into the kitchen environment In re circulating mode both the aluminum grease DAN9RC filters and the charcoal filters must be installed Mao ZE 10 Description of Parts Instructions for Use Extractable Group By pressing the button shown in the below you will be able to control the functions of the extractor Motor Control 4 __ Filters r Light Speed YY ON og O Off O off
Download Pdf Manuals
Related Search
Related Contents
NEC NP43 AIRE ACONDICIONADO (INSTALACIÓN) Graco 312888D User's Manual Radiation Safety Manual - University of Mississippi Medical Center 2U-RAIL 取扱説明書 Télécharger le mode d`emploi Request to Transfer Software License S6161-1L-FSE-010 - Equipment Catalog Copyright © All rights reserved.
Failed to retrieve file