Owner`s Manual
Contents
1. X Dimplex 2 4KW CERAMIC HEATER WITH ELECTRONIC CONTROLS DHCER24E User Manual Please read the instructions carefully before using the product and keep this user manual for future reference 1 PRODUCT FEATURES 2 4kW heat output Choice of heat settings Double overheat protection Tip over safety protection Oscillating function Electronic climate control LED temperature display Remote control 12 month warranty 2 SAFETY WARNINGS e Please operate the heater on a dry even surface e This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety e Disconnect the heater from mains when not in use or cleaning e Do not operate the appliance with a damaged cord or plug If the power supply cord is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard e It is not recommended to use an extension cord or power board on this appliance e Do not immerse cord plug or any part of the appliance in water or any other liquid e Do not place the heater on or near any other source of heat e WARNING do not cover the heater This may cause the unit to overheat e A fire may occur if the heater is covered with or touches flamma2. back of the unit to turn it on You will hear 2 beeps which indicates the unit is in standby mode 2 Once in standby mode the power button needs to be pressed to start the heater This is the only button that works under standby mode Press it a second time to switch it off Touch Sensor Panel e Press the On Off button to turn the unit On Off e Press the Swing button to start or stop oscillation The oscillation indicator light will illuminate when the swing function is activated The oscillation indicator light will be turned off when in fixed operation e Press the Temp Timer button to set your desired temperature You can increase or decrease temperature by pressing the or button The temperature range is from 15 C to 35 C and in increments of 1 C e Press the Temp Timer button a second time to set the timer This will tell the heater how long you want the unit to operate before shutting off automatically The timer range is from 1 12 hours and in increments of 1 hour e Press the Heater button to set the unit on low or high heat The low heat indicator light will illuminate when the Heater button is pressed once The high heat indicator light will illuminate when the Heater button is pressed twice Remote Control e Press the button to turn the unit On Off e Press the button to start or stop oscillation The oscillation indicator light will illuminate when the
3. ble material including curtains drapes bedding etc When in operation KEEP THE HEATER AWAY FROM SUCH MATERIALS e Do not use the heater in the immediate surroundings of bathtubs showers washing stands or swimming pools e Do not use the heater outdoors e When the heater is turned on for the first time it may release a slight harmless odor This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again e Do not operate the heater in areas where flammable liquids are stored e Do not operate the heater in close proximity to curtains or other combustible materials Keep any combustible materials at least 1 0m away from the heater 3 ASSEMBLY INSTRUCTION Base Heater Body Heater Body Base Fixing Mut Base Fixing Nut ity Open the packaging take the unit out and unscrew the base fixing nut Insert the base into the bottom of the unit and screw on the base fixing nut Turn the unit upright and place it on a flat or even surface before use 4 PARTS DESCRIPTION 1 Touch Sensor Panel 2 Display Window 3 Front Cover 4 Base 5 Inlet 6 Power Switch Touch sensor panel TEMP TIMER HEATER SWING ON OFF Display window oa wig 3 eS AE B H v D U Hj 5 OPERATING INSTRUCTIONS First connect the power cord to the correct power supply 220 240V SOHz 10 amps 1 Press the power button at the
4. swing function is activated The oscillation indicator light will be turned off when in fixed operation e Press the Set button to set your desired temperature You can increase or decrease temperature by pressing the or button The temperature range is from 15 C to 35 C and in increments of 1 C e Press the Set button a second time to set the timer This will tell the heater how long you want the unit to operate before shutting off automatically The timer range is from 1 12 hours and in increments of 1 hour e Press the oD button to set the unit on low or high heat The low heat indicator light will illuminate when the Heater button is pressed once The high heat indicator light will illuminate when the Heater button is pressed twice Remote Control Battery 1 To remove the battery open the groove at the bottom of the remote press buckle inwards to pull out the groove 2 Put battery CR2032 into the groove with flat side to the back of the remote 3 Push groove back into the remote 6 CLEANING AND MAINTENANCE Make sure the power switch is turned off and the plug is disconnected from the socket before cleaning or maintenance Otherwise it may cause an electric shock 1 Cleaning the unit s surface Clean the surface with a damp cloth or add some detergent Do not use corrosive detergent or solvent to clean such as Petrol Turpentine etc Do not wash the unit directl
5. y with water 7 SPECIFICATION Product name 2 4kW Ceramic Heater w Electronic Controls Toner beeen sie es DISPOSAL Do not dispose this product as unsorted municipal waste Collection of such waste is required to be disposed of separately A Glen Dimplex Australia Pty Ltd Glen Dimplex Australasia Ltd Unit 1 21 Lionel Road 38 Harris Road Mount Waverley VIC 3149 East Tamaki Auckland Phone 1300 556 816 Phone 09 274 8265 Fax 1800 058 900 Fax 09 274 8472 Email sales glendimplex com au Email sales glendimplex co nz 10
Download Pdf Manuals
Related Search