AlternAting Pressure / low Air loss MAttress systeM user MAnuAl
Contents
1. 4 When the selected pres sure level is reached the low pressure indica tor will de illuminate and the normal pressure indicator green LED will automatically illuminate 5 Replace all sheets blankets and pillows on the bed PRESSURE ADJUSTMENT Generally a lighter patient will need a lower softer set ting while a heavier patient will need a higher firmer setting but pressure adjustment must ultimately be based on the patient s weight distribution A short stocky person may be the same weight as a tall thin person but their settings will not be the same The mattress should be firm enough to support the patient yet soft enough so the patient will sink down to eliminate pressure points Test the pressure by placing four fingers below the mattress under 750000 INS LAB RevA08 11 the patient s buttock area your fingers should just fit If the fiit is too loose decrease the setting If your fingers do not fit well increase the setting two notches firmer Wait ten minutes and then check again You should only have to ad just this setting one time per patient Please consult your physician for an appropriate setting QUICK DISCONNECT Pull the power plug from the wall connector to disconnect the device quickly TRANSPORT CAP In case of power failure or transport Disconnect the quick connector and cap the mattress with the transport cap to slow deflation CPR FUNCTION 4 If CPR must be performed on the2. N WARNING Never operate this product if a it has a damaged cord or plug b itis not working properly c it has been dropped or damaged d it has been dropped into water Return the product to your Graham Field equipment provider 4 750000 INS LAB RevA08 N WARNING Keep the cord away from heated surfaces N WARNING Never block the air openings of this product or place it on a soft surface such as a bed or couch where the openings may be blocked Keep the air opening free of lint hair and other similar particles N WARNING Never drop or insert any object into any opening or hose N WARNING Do not use this product in the presence of flammable anesthesia or where oxygen or nitrous oxide is being administered N WARNING Connect this product only to a properly grounded power outlet N WARNING Maximum patient weight capacity for this product is 350 Ib 159 kg CAUTION A Caution The pump can be used only with the accom panying mattress Do not use it for any other purpose 750000 INS LAB RevA08 EQUIPMENT SYMBOLS Attention Consult accompanying documents this manual Indicates that this product is according to the degree of protection against electric shock for type BF equipment Functional earth for UL only n Class II for UL only Disposal of Electrical amp Electronic Equipment WEEE Do not treat this product as household waste For more detailed information with regard to returning an
3. patient while the mattress is in use to immediately deflate the mattress either 1 Pull the CPR valves from the mattress in the location of the arrow shown at right or VW connector 2 Disconnect the quick connector from the pump in the location of the arrow shown at right MAINTENANCE CLEANING Perform the following cleaning procedures before use Pump Wipe the pump with a clean damp cloth and mild detergent and keep it away from dust Air dry 12 750000 INS LAB RevA08 A Caution Do not use corrosive or powdered cleansers to clean the pump A Caution Do not immerse or soak the pump A Caution Do not clean with phenolic products Mattress Wipe the mattress unit with a clean damp cloth and mild detergent The mattress may also be cleaned us ing a 1076 solution of sodium hypochlorite bleach diluted in water Air dry all parts thoroughly before use A Caution Do not clean with phenolic products A Caution After cleaning air dry the mattress without direct exposure to sunlight GENERAL MAINTENANCE 1 Check main power cord and plug for abrasion or exces sive wear 2 Check mattress cover for signs of wear or damage En sure mattress cover and tubes are connected correctly 3 Check airflow from the air hose connector The airflow should alternate between each connector every half cycle time if it s in alternating mode 4 Checkthe air hoses for any kink or break For replace ment
4. please contact your GF equipment provider Fuse replacement tool needed small screwariver 1 If you suspect a blown fuse discon nect the plug from the wall outlet immediately 2 Usea small screwdriver to remove the cover of the fuse holder fuse lo cations are shown in picture at right 3 Insert a new fuse of the correct rating T1A 250V VDE approved 4 Replace the fuse holder cover 750000 INS LAB RevA08 13 Air filter replacement 1 Remove the air filter plate locat ed at rear of pump filter location shown in picture at right 2 Remove the filter The filter is reusable if not torn and can be washed gently with a mild de tergent and water Dry the filter before use 3 Replace the air filter regularly if it is gray torn or the environment is dirty STORAGE 1 Lay the mattress out flat and upside down 2 Roll from the head end toward the foot end 3 stretch the foot end strap around the rolled mattress to prevent unrolling 4 Store mattress and pump in a dust free environment with no exposure to direct sunlight A Caution Do not fold crease or stack mattress SPECIFICATIONS Pump Specification Power Supply 120V System AC 120V 60 Hz Note see rating label on product Fuse Rating T1A 250V Mirimput 4LPM Dimensions L x W x H 9 8 x 5 3 x 3 7 25 x 13 5 x 9 5 cm Weight A4Ib i 8kg 14 750000 INS LAB RevA08 Specifications continue
5. LLIIVIEX ER an A Graham Field Brand AltaDyne 750000 ALTERNATING PRESSURE LOW AIR LOSS MATTRESS SYSTEM USER MANUAL Important Do not operate the Mattress System without first reading and understanding this manual Save this manual for future use 750000 INS LAB RevA08 CONTENTS INITRODUGTION 3 INTENDED USE OF THIS DEVICE rine sra cin in paran kun uua pua a 3 IMPORTANT SAFETY PRECAUTIONS creer 3 Bj ijc ll P 4 WARNING cosas c annenin 4 CAUTION a oar M S 5 EQUIPMENT SYMBOLS sissien E ARERR 6 PRODUCT DESCRIPTION siinse 17 PUMP AND MATTRESS SYSTEM eene rrennnnnnnnn 7 POMP ERON ge 7 PUMP REAR ce sti cs tee nese Ea 8 PUMP TOP PANEL orisa ee aE 8 INSTALLATION scierie E 9 UNPACKING osteitis siccatate anaa a an ano a i 9 PUMP AND MATTRESS INSTALLATION eeessss 9 OPERATION e nnn 11 PRESSURE ADJUSTMENT eeeeeeeeeeeeeeeeennn nnne nnn nnn 11 QUICK DISCONNEGC Fcc ee trates ae a i racdiicenrad dated 12 TRANSPORT CBP Licinia ro cosa aua EE 12 GPR FUNCTION 2iiacs eecseccuxscensnFaHcEezusuk eva ExPc suduba ed vncu nC cau uiu inira dx EE dE uass 12 Jd agz rece 12 EJ CO lcm c 12 GENERAL MAINTENAN
6. QGE icacun nds kara usan sium Fax ana canus ku vicaria u un uis 13 FUSE REPLACEMENT iixinis cusa GEuxU nan FEE VR E EKE MR KHR UE u ERRARE FRE RH EE uu 13 AIR FILTER REPLACEMENT iccecconsesasekazerecusug zurckwec cups ai rcr uda 14 STORAGE cm c 14 OIG qiiem OM 14 WARRANTY tS 15 GF Graham Field Lumex and AltaDyne are registered trademarks of GF Health Products Inc GF Health Products Inc is not responsible for typographical errors Packaging warranties specifications and products are subject to change without notice 2 750000 INS LAB RevA08 INTRODUCTION Use this manual for set up and operation of the Alternating Pressure Low Air Loss Mattress System Read all instruc tions before using the mattress system Save this manual for future reference INTENDED USE OF THIS DEVICE The intended use of the Alternating Pressure Low Air Loss Mattress System is e Thetreatment of pressure ulcers while optimizing user comfort e Pain management as prescribed by a physician e As described above in either a homecare or long term care setting IMPORTANT SAFETY PRECAUTIONS The safety statements presented in this chapter refer to the basic safety information that should be observed by those using the Alternating Pressure Low Air Loss Mat tress System There are additional safety statements in other chapters or sections which may be the same as or similar to t
7. d Pump Specification Temperature Operation 50 F to 104 F 10 C to 40 C Storage 5 F to 122 F 15 C to 50 C Shipping 5 F to 158 F 15 C to 70 C Operation 10 to 90 non condensing Storage 10 to 90 non condensing Shipping 10 to 90 non condensing Classification Class Il Type BF IPXO Applied Part Air Mattress Not suitable for use in the presence of a flammable anesthetic mixture No AP or APG protection Mattress Specification Model 8 mattress 0000000 78 7 x 35 4 x 8 200 x 90 x 20 3 cm Weight 21bqooy O WARRANTY GF Health Products Inc warrants the Lumex AltaDyne 150000 Alternating Pressure Low Air Loss Mattress Sys tem for a period of twelve months for defects in workman ship and materials During the warranty period defective items will be repaired or replaced at GF Health Products option at no charge 750000 INS LAB RevA08 15 USA Corporate Headquarters Graham Field Health Products 2935 Northeast Parkway Atlanta Georgia 30360 telephone 800 347 5678 770 447 1609 fax 800 726 0601 678 291 3232 www grahamfield com 750000 INS LAB RevA08 2008 GF Health Products Inc
8. d recycling this product please consult your local city office household waste disposal service or Graham Field Health Products equipment provider For U S and Canada only Medical Equipment Air Pump E228589 5 with respect to electrical shock fire and 53DG cus mechanical hazards only in accordance with UL60601 1 and CAN CSA C22 2 No 601 1 6 750000 INS LAB RevA08 PRODUCT DESCRIPTION PUMP AND MATTRESS SYSTEM foot end symbol ee Ry Jf mattress pump mattress pump connectors pump and mattress system Pump front N Oy quick connector 750000 INS LAB RevA08 Pump rear Pump top panel Ww function switch Power Normal Pressure Low Pressure main power switch 4 N Static N S J4 Alternating ON OFF M iow pressure indicator pressure adjustment knob Pressure adjust knob The pressure adjust knob controls the air pressure output Turn it clockwise to increase output pressure firmer turn it counter clockwise to de crease air output pressure softer Higher pressure output will better support the heavier weight user The setting is measured in kilograms kg Please consult your physician for an appropriate setting Normal pressure indicator The green normal pressure LED illuminates when the pressure inside the air mattress has reached the selected pressure setting Low pressure indicator The yellow low pr
9. er care giver and or doctor A Caution Place the device in a po sition where the user caregiver and or doctor can access it easily 5 Connect the mattress pump air hose quick connector ensure that the connector has clicked securely into place before continuing A Caution Ensure that the air hoses are not kinked or tucked under the mattress N WARNING Locate all cords so that they will not be stepped on tripped over or otherwise subjected to damage or stress N WARNING Do not use a household extension cord if the electrical cord does not reach the power outlet Use of an improper extension cord could result in fire and electric shock If an extension cord must be used use a three conductor cord with ground properly wired in good electrical condition and keep it as short as possible N WARNING Ensure that the local power voltage is appropriate for the pump unit 5 Plug the power cord into a properly grounded electrical outlet 10 750000 INS LAB RevA08 OPERATION 1 Turn the power switch 9 N OFF Power to the ON position 2 Adjust the pressure adjust knob to the maxi mum position Note Set the pressure adjust knob to the maximum position for the quickest inflation at set up the mattress can then be adjusted to the desired pressure 3 The pump will begin delivering air into the mattress While the mat tress is filling the low pressure indicator yellow LED will illuminate
10. essure LED illu minates when the pressure inside the air mattress is below the selected setting 8 750000 INS LAB RevA08 Static function switch Press the static function switch to suspend alternating function if needed the pressure inside the air tubes will then be adjusted to identical pressure Press the static function switch again to change back to al ternating mode The static function switch toggles between static and alternating modes Main power switch The main power switch toggles be tween ON and OFF When power is ON either the normal or low pressure indicator illuminates INSTALLATION UNPACKING 1 Before unpacking check for obvious damage to the car ton or its contents If damage is evident please notify the carrier and your Graham Field equipment provider 2 Remove all loose packing from the carton 3 Carefully remove all components from the carton 4 Inspect all components If damage is evident please notify the carrier and your Graham Field equipment provider PUMP AND MATTRESS INSTALLATION 1 Remove all sheets blankets and pillows from the bed 2 Place the mattress on top of the bed frame ensure that the foot end symbol faces up at foot end as shown at right 3 Fold open the wire hangers on the back of the pump as shown at right 4 Either hang the pump on the bed s foot end as shown at right or 750000 INS LAB RevA08 9 place the pump on a flat surface easily accessible to the us
11. he following or specific to the operations N DANGER Indicates an imminent hazard situation that if not avoided will result in death or serious injury N WARNING Indicates a potential hazard situation or unsafe practice that if not avoided could result in death or serious injury A Caution Indicates a potential hazard or unsafe prac tice that if not avoided could result in minor person al injury or product property damage Note Provides application recommendations or other useful information to ensure that you get the most from your product 750000 INS LAB RevA08 3 DANGER To reduce the risk of electrocution N DANGER Always unplug this product immediately after using N DANGER Do not use this product while bathing N DANGER Do not place or store this product where it can fall or be pulled into a tub or sink N DANGER Do not place this product in or drop into water or other liquid N DANGER Do not reach for a product that has fallen into water Unplug it immediately WARNING To reduce the risk of burns electrocution fire or personal injury WARNING Do not leave this product unattended when plugged in N WARNING Always use close supervision when this product is used by on or near children or those who require close supervision N WARNING Use this product only as intended and described in this manual Do not use attachments or accessories not recommended by Graham Field
Download Pdf Manuals
Related Search