Remote Wireless
Contents
1. BATTERY REPLACEMENT INSTRUCTIONS Base Unit Transmitter 1 Locate battery compartment on bottom side of Base Unit 2 Carefully remove battery cover 3 Carefully load 2 AAA batteries not included 4 Replace battery cover BASE UNIT BOTTOM Battery Cover O ou TIMER INSTRUCTIONS Count Down Timer 1 Press MODE to select timer mode The upper display will show a small TIMER and 0 00 2 Press HR and MIN button to set the timer Press START STOP button to start countdown timer W will blink for every second 3 To stop countdown timer press START STOP button again The W becomes solid 4 Press CLEAR button to clear the setting back to 0 00 Count Up Timer 1 Press MODE to select timer mode The upper display will show a small TIMER and 0 00 2 Press START STOP button to start count up The will blink for every second 3 To stop count timer press START STOP button again The becomes solid 4 Frees CREAR button to clear the setting back to 0 00 LED Flashlight Instructions 1 Press and hold silver button on side of Handheld Unit for flashlight illumination while receiver switch is in the ON position 2 Release silver button to turn off TROUBLE SHOOTING Problem Cannot Make Meat Selection Solution May be in Timer Mode Check to make sure that the Handheld Unit is in Thermometer Mode by pressing MODE button No Data Link between Handheld Unit a2. e 8 This product is intended for use as a meat thermometer NOT INTENDED FOR USE AS AN EXTERNAL OVEN THERMOMETER 9 Keep Stainless Steel Probe Wire away from Children Remote Wireless nig Thermometer CVMH G353 USER S MANUAL REMOTE GRILL THERMOMETER General Use Instructions Grill or Oven Locate the battery compartments and load 2 AAA batteries not included into both Handheld Unit Receiver and Base Unit Transmitter Place Handheld unit in Base Unit cradle units should be in close proximity for establishing data link Place meat on grill or in oven Insert stainless steel meat probe into the thickest part of the meat Carefully replace close gril lid or oven door on heat resistant braided steel probe wire Plug probe wire into Base Unit Tur ON the Handheld Unit and Base Unit by locating both small ON OFF switches f Handheld Unit and Base Unit will establish data link automatically Registration is complete when the Handheld Unit beeps and the probe temperature appears where the was flashing Once link is established enter type of meat Beef Veal Lamb Pork Chicken Turkey by pressing meat button on Handheld Unit until desired meat is selected 10 Once meat type is selected set desired taste level Rare Medium Rare Medium Well Done by pressing taste button on Handheld Until until desired taste doneness level is selected 11 To set the desired internal meat tempera
3. nd Base Until Solution 1 Check to make sure that both units are turned ON while in close proximity to one another Solution 2 Check Batteries for replacement Problem Problem Flashlight will not work Solution 1 Make sure receiver switch is in the ON position and press flashlight button on the side of the Handheld Unit Solution 2 Check Batteries for replacement CLEANING INSTRUCTIONS 1 Hand was probe gently with soap and water 2 DO NOT immerse probe in water while cleaning 3 Dry immediately 4 DO NOT WASH Handheld Unit or Base Unit 5 NOT DISHWASHER SAFE HELPFUL HINTS 1 For best results make sure probe tip is inserted into the meat at least 1 inch 2 Do not allow the probe or probe wire to come in direct contact with flames If cooking with grill cover closed only use medium and low heat 3 Make sure that probe tip is inserted into the center of meat NOT poking through meat CAUTION 1 Caution Meat Probe and Wire are very hot while in use 2 Always use a heat resistant glove when handling meat probe or probe wire while in use DO NOT touch with bare hands 3 DO NOT expose Handheld Base Unit to direct heat or hot surfaces 4 NOT FOR USE IN MICROWAVE OVENS 5 DO NOT expose Base Unit Probe plug connector to water 6 DO NOT use Handheld Base Unit in the rain 7 Base Unit registers temperatures as low as 14 F and as high as 482 F A 482 F is exceeded probe wire may deteriorat
4. t will not work while receiver power is OFF Handheld Unit Base Unit Receiver Transmitter Receiver Cradle Power Indicator Light Ban Probe Wire Plug Connector BATTERY REPLACEMENT INSTRUCTIONS Handheld Unit Receiver 1 Locate battery compartment underneath belt clip on the backside of the Handheld Unit 2 Remove belt clip to access battery compartment 3 Carefully remove battery cover 4 Carefully load 2 AAA batteries not included 5 Replace battery cover and belt clip Receiver Back Battery a Belt Clip Cover
5. ture manually Press HR or MIN button to raise or lower the temperature value after meat selection is made 42 Grill or Cook until alarm sounds indicating that the desired taste doneness level is reached For the best results set count down count up timer and check meat periodically see timer instructions 13 Remove meat from gril or oven and allow to cool approx 5 min and serve so COMPONENTS Handheld Unit Receiver Base Unit Transmitter Stainless Steel Meat Probe and Head resistant Probe Wire Receiver Button Profiles 1 HR Button In timer mode press to set hour in thermometer mode press to increase the temperature value 2 CLEARIF C In timer mode when the timer count down count up process is stopped press to clear the timer reading In thermometer mode press to select temperature readings in Celsius or Fahrenheit 3 MIN In timer mode press to set minutes In thermometer mode press to decrease temperature value 4 MODE Press to select thermometer or timer mode 5 MEAT In thermometer mode press to select meat type BEEF VEAL LAMB PORK CHICKEN TURKEY 6 TASTE In thermometer mode press to select taste doneness level W DONE MEDIUM M RARE or RARE 7 START STOP Press to start or stop the timer count down or count up 8 ON OFF Switch on backside above clip turns receiver on and off 9 SILVER SIDE BUTTON Press to turn LED light on and off while receiver is ON LED ligh
Download Pdf Manuals
Related Search