Home

IGS PHOTON500 user manual

image

Contents

1. R OUTPUT PHOTONS COMP LO PEAK BYPASS MODE OUTPUT GRBAR Very fast LED indicator showing the compression level in the range from O to 20dB PEAK Controls the gain of the side chain circuit OUTPUT 12 pole stepped makeup gain RATIO Allows to adjust the compressor ratio 2 1 4 1 or 12 1 HPF Sidechain Hi Pass filter Flat 60 120Hz MODE Advanced compression curve modeling like SLAM BYPASS Hard wired bypass PHOTON 500 main functions and technical specification 500 series mono module All stepped manipulators Precise LED bar scale KKK XS Carnhill output transformer 3 year warranty Operating Level 4dBu Maximum Input 20 dBu Maximum Output 22 dBu Max Gain Reduction 20 dB Maximum Gain 30 dB HPF OFF 60 120 Hz Input impedance 10 kOhm Output Impedance 600 Ohm Frequency response 8Hz to 20kHz 0 1dB Noise level dBA 99dB THD N Q0dBu 0 5 Power consumption 2 5 Watts Shipping weight 0 7kg Dimensions H 13 3cm x W 3 8 cm x D 15 8cm Troubleshooting My unit doesn t light up LED bar is dark Make sure that the signal source is properly connected to the module Adjust the input level using the Peak Reduction knob insufficient input level might cause that the signal level is below the compressor threshold level Make sure that the IN BYPASS switch is in IN position The signal plays thru but th
2. e16 e18 20 u 222 PEAKREDUCTION RATIO 2 1 IN e e 12 1 BYPASS FLAT LONDON 1 2 3 4 5 6 7 8 9 60 A e 0Hz Ne YORK 22 GR OUTPUT PHOTON O RA g PHOTON 500 USER S MANUAL IGS Audio Igor Sobczyk 3 Maja 76d 41 400 Mys owice Poland e mail igs o2 pl ph 48 601 597 592 www igsaudio com Please read all of the following instructions and save them or later reference before attempting to connect this unit to the Power DC Supply COVERS DO NOT remove the covers or try to repair the module on your own Refer servicing to qualified personnel only MOISTURE DO NOT expose the unit to rain or moisture If the unit should become so exposed TURN OFF the device immediately HEAT ALWAYS site the unit away from sources of heat including direct sunlight and ensure adequate ventilation around the unit Ak ere AVIS A RISK OF ELECTRICAL SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE TO REDUCE THE RISK OF ELECTRICAL SHOCK DO NOT REMOVE TOP OR BOTTOM COVER REFER SERVICING TO QUALIFIED SERVICE PERSONNEL Copyright 2014 All rights reserved The information in this document is subject to change without notice IGS Audio makes no warranty of any kind with respect to the material in this document and shall not be liable for errors contained herein or for incidental or consequ
3. ential damages related to the use of the material Manual revision 1 0 may 2014 R IGS Thank you for buying this IGS Audio product Please read the information provided below very carefully before using your IGS unit Unpacking Your PHOTON 500 has been carefully and meticulously tested and inspected before dispatch Please check for any signs of transit damage If any signs of mishandling are found please notify the carrier and your dealer immediately Your PHOTON 500 packing should contain an PHOTON 500 with IGS Audio tag packed in ESD bag and this manual with the Warranty and RoHS CE WEEE Declaration attached Compatibility and Power The PHOTON 500 module is designed to be installed into an API 500 Series compatible rack and cannot function stand alone requiring the power source supplied by the rack system The current consumption of the PHOTON 500 is rated at 120 miliamperes per slot Please check with the rack manufacturer that the design can meet this rating Mounting WARNING Never plug or unplug any 500 series module with the power supply switched on You may destroy your unit permanently The dimensions of all IGS Audio 500 series modules are compatible with API standard When plugging your new unit to the 500 series rack no unnecessary force is needed However please be careful and do not rush while pushing the unit into the rack sockets to avoid damaging of the connectors and or the PCBs of either the unit
4. ere is no change in signal when i turn the knobs Please check the IN BYPASS it should be set to In No signal plays thru the unit regardless the settings at the front panel Please check the cables connecting the rack and or the Power Supply Warranty This device is declared to be free from defects in material and workmanship for a period of three years Any device found defective within three years from the delivery date and returned to the factory will be repaired adjusted or replaced and sent to the customer with no charge The customer always pays the shipping cost to us This warranty does not cover expendable items such as tubes or fuses If the defect has been caused by a misuse or abnormal operation conditions the repair will be billed at a nominal cost The product should be returned in its original package if this is possible or packed in sucha way that it is not damaged during the shipment We are not to be held responsible for any damages during the shipment All units shall always be packed in a box with foam support All 500 series modules need to be secured in ESD bag and protected with foam We will charge the customer 20 VAT if the packing material needs to be replaced If we find that the product works perfectly the customer will be invoiced 50 VAT to cover our costs of examination and handling plus the cost for returning the product to the customer www igsaudio com
5. or the rack After the unit is placed in the rack use the screws provided with your 500 series rack unit to make sure that the unit is safely placed When removing the unit from the rack unscrew the front panel from the rack and use your fingers to pull it out gently Do not use any sharp objects i e knives or screwdrivers to prize it IGS AUDIO PHOTON 500 Optical Compressor The PHOTON 500 is an optical compressor based on technology from the 60 s first used in the UREI LA 2A limiter and later in the LA4 As an homage to these legendary products we packed this technology in a 500 series module The PHOTON 500 uses an opto coupler which introduces negative feedback in the audio path taking care of gain reduction being the basics of all compression The PHOTON 500 has an electronically balanced input with 2520 compatible op amp in the gain stage The output is balanced by a Carnhill transformer Typical usage Good for compressing instruments guitar bass mono synth Great vocal compressor Work well with single drum tracks and samples Great all around compressor Block diagram BAL TO amp UNBAL PHOTOCELL TIME CONSTANT pep Ban BALANCED OUTPUT BALANCED INPUT PHOTON 500 BLOCK DIAGRAM GR BAR 0 238 PEAK REDUCTION t lt n u O RATIO 2 1 IN RATIO Pa 12 1 BYPASS FLAT LONDON 7 60 f O gt 120Hz NEW YORK HPF G

Download Pdf Manuals

image

Related Search

Related Contents

移乗台 CH-30  Samsung UE32H4000AW 32" HD-ready Black LED TV    professional abs molded loudspeak professional abs molded  MC200系列矢量型变频器  ® MT800-2 EVP EU  CG-VSVV02A、CG-VSVV04A 取扱説明書    CDX-GT212 - Sony Europe    

Copyright © All rights reserved.
Failed to retrieve file