Blazing oak logs
Contents
1. pins on left side of grate See Figure 3 Left Base Log 3 Figure 3 Installing Left Base Log Pins 3 4 Place right top log 4 on two pins located to the left of right base log See Figure 4 Right Top Log 4 Right Top Log 4 Zi Figure 4 Installing Right Top Log 4 a Yi f Ca Shr _ ars FA P S Log 1 2 70D0048 5 Place right end of left top log 5 on bottom center grate pin Rest the left end of left top log 5 on the left base log See Figure 5 Left Base Log 3 f io SQ Bottom Center Pin 6 Place right front log 6 on two pins on the right front of grate See Figure 6 70D0048 AN A ne X IREF a l eS a 4 RAN NN Figure 5 Installing Left Top Log 5 Right Front Log 6 Figure 6 Installing Right Front Log 6 NOTE 18 burner has two pins to install Left Top Log 5 Right Front Log Continued BLAZING OAK LOGS PARTS LIST Tom Description ay Bootie BOooL2s BOcL30_ Left Base Log 6 Right Front Log 1 70D0137 70D0047 70D0237 Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury WARNING MHH 70D0048 Rev 3 May 20062. BLAZING OAK LOGS BOCL18 BOCL24 and BOCL30 Installation Instructions This log set is for use only with the 18TPB 24TPB and 30TPB engine grate Do not handle these logs with your bare hands Always wear gloves to prevent skin irritation from ceramic fibers After handling the logs wash your hands gently with soap and water to remove any traces of fibers The positioning of the logs is critical to the safe and clean operation of this heater Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance Never add additional logs or embellishments such as pine cones vermiculite or rock wool to the heater Only use the logs and TPB RW rock wool supplied with the unit Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury g Z Z lt Right Base Log 1 INSTALLING BLAZING OAK LOGS ON BURNER 1 Place right base log 1 on two pins located on the right side of the grate See Figure 1 Figure 1 Installing Right Base Log 1 Rear Log 2 2 Place rear log 2 on two pins on back of grate allowing the right end of the rear log to rest on top of the right top Pins log See Figure 2 oy bi Right Base Log 1 Continued Figure 2 Installing Rear Log 2 MHH 70D0048 Rev 3 May 2006 3 Place left base log 3 on two
Download Pdf Manuals
Related Search