RX610 Group Connection Example
Contents
1. ZUD F35 10 0072 Rev 1 3e Created by Renesas Electronics Corporation MCU Tool Product Marketing RX610 Group Connection Example Department The following is a connection example for the RX Family RX610 Group and E1 E20 emulator 14pin Pull up and pull down resistance values are provided for reference only Please perform an evaluation on your system to confirm actual values Although this connection example has been confirmed on paper it is the user s responsibility to perform an evaluation on the user system to determine applicability Renesas assumes no responsibility for determining the applicability of this example on the user system eThis connection example is for using the Flash Development ToolKit with E1 E20 as a flash programmer When you use E1 or E20 as a debugger please refer to the connection example in the E1 E20 Emulator Additional Document for User s Manual prepared for each MCU group You can download the E1 E20 Emulator Additional Document for User s Manual from the following URLs http www renesas com el http www renesas com e20 El ROEOOOO1O0KCEOO E20 ROEOOO200KCTOO R5F56108 R5F56107 R5F56106 R5F56104 Connector manufacturer and model name ae 2514 6002 3M Limited eee T connector recommended for overseas use 2 Open connector buffer 1 2 ZUD F35 10 0072 Flash Development ToolKit Settings Select ElaDirect Communications Port or Use this page to select your desir2. ed communications Select E20aDir ect port interface All settings may be changed after the project is created Pin Setting Select port Pin Settings Select an Interface type to connect to the target device with Normally this will be Direct Connection or simply left blank Please set the pin values for connection Select Interface i05 lod o3 w2 i0 Pin Outputs E E w W ORS Set Reset pin as low when disconnecting Pin Setting F High p goy W ORT WARNING Incorrect settings could damage vour hardware E1 E20 14pin Connector Cancel Pin 2 4 Pin 14 am Pin 13 E1 Pin Name Flash Development ToolKit Settings Pin 1 1 Make sure pins 2 8 12 13 and 14 are connected 2 Set unused pins to NC Non Connect
Download Pdf Manuals
Related Search