digital agile audio/video modulator skymod1 installation
Contents
1. Release the button and disconnect the power Reconnect the power and you are ready to channel select 4 To change output channel range to UHF 14 39 and CATV 91 135 Disconnect power and then depress the button Reconnect the power and 02 will appear Release the button and disconnect the power Reconnect the power and you are ready to channel select 5 To change output channel range to UHF 21 69 Disconnect power and then depress both the and buttons Reconnect the power and 03 will appear Release the and buttons and disconnect power Reconnect the power and you are ready to channel select 6 To change output channel range to factory UHF 14 78 Disconnect power and then depress the SELECT button Reconnect the power and 00 will appear Release the SELECT button and disconnect power Reconnect the power and you are ready to channel select SKYMOD1 Audio Video Modulator Specifications Output Frequency Range Output Channels Video Frequency Response Aural Intercarriers Stability Video Input IMP RF Output IMP Audio Input IMP Frequency Accuracy Stability Video Input Level Audio THD Output Level Video MOD Index Dual Sideband Audio Visual Carrier Ratio Size Weight Power Requirement 470 860 MHZ UHF Ch 14 78 CATV Ultra Ch 65 135 1db 4 5 MHz w n 3KHz 75 Ohm gt 10K Ohm PLL Crystal Stabilized 5KHz 1Vp p 0 4 10 dBmV 70 10 15dB 95Lx75Wx26H m m 3 3 4Lx3Wx1H inches 4 oz2. 110 120 VAC 60Hz
3. DIGITAL AGILE AUDIO VIDEO MODULATOR SKYMOD1 INSTALLATION INSTRUCTIONS I Modulator Installation 1 Insert the male RCA connector from the video source into the SKYMOD1 RCA jack 2 Insert the 3 5mm miniature plug from the audio source into the SKYMOD1 audio input Mini jack 3 Connect F to F connecting cable from RF output F Female connector on SKYMOD 1 to one output port of a splitter 4 Connect cable from Off Air or CATV line or any other RF signal source to other port of splitter Connect input of splitter to TV RF Input Plug the provided 12 VDC 100 mA power supply into the power line and SKYMOD1 power jack On This completes the installation of SKYMOD1 modulator Off Aur Signal or CATY Line WOR 2 Way a 1 ac ft Spiltericombiner Adaptor j u Satolile Receiver Il Channel Programming Steps Step1 Using Paper clip or ball point pen press and hold select Step2 Release button and press channel button up or down while LED is flashing When LED stops flashing channel selection is complete LED Flashes Note 1 While doing the channel selection process if power goes off the last channel memory will malfunction even though LED will be flashing The SKYMOD1 output channel has been factory preset for UHF channels 14 thru 78 To change output channel range to CATV 65 135 Disconnect power and then depress the ON button Reconnect the power and 01 will appear
Download Pdf Manuals
Related Search