View - Industry Gear
Contents
1. INSTALLATION CAUTION For safe mounting read the following instructions carefully e Use suitable hook clamps for hanging the lighting effect e Use a safety wire with a breaking strain of more than double the lighting effect e Do not look directly into the light source e Make sure the lighting effect has suitable ventilation as per the instructions below e This lighting effect is intended for indoor use only to avoid electrical shock keep away from rain and moisture e Keep unit out of reach from children NOTE Use washers and spring washers when attaching your hook clamp to the yoke 1 For installation of the hook clamps and safety wire This lighting effect must be 0 5m away from any flammable materials or any walls or ceilings 3 Do not block or inhibit the air flow from the ventilation vents Light Emotion has various hook clamps and safety wires suitable for your ST1500 Please contact your local dealer for more information MAINTENANCE amp PERIODIC CHECKS CAUTION Some maintenance and checks may require the product to be opened and should only be done by qualified persons Warranty may be void if damage has been caused by improper maintenance Perspex lenses should be wiped with a clean moist cloth to remove dust and residue only when unit is switched off and cool FUSE CAUTION Only use the correct fuse as specified on the rear panel of the lighting effect Disconnect the lighting effect from the m2. WWW LIGHTEMOTION COM AU 511500 1500w Strobe Light User s instruction manual This manual contains important information about the safe installation and use of this product Please read this instruction manual carefully before installing or operating Please keep these instructions in a safe place for future reference www lightemotion com au Congratulations on the purchase of your ST1500 by Light Emotion It is a 1500w Strobe with DMX function We are confident that you will be satisfied with your purchase We have prepared this manual to assist you with the operation of this item CONTENTS SECTION Page WHAT IS INCLUDED SAFETY INSTRUCIONTS 2 INSTALLATION MAINTENANCE amp PERIODIC CHECKS FUSE 3 POWER FEATURES SPECIFICATIONS 4 Please note that as part of our ongoing commitment to continuous improvement and product development the specifications in this manual are subject to change without notice Whilst every care has been taken in the preparation of this manual we reserve the right to change specifications in the course of product improvement WHAT IS INCLUDED CAUTION Do not use sharp objects whilst unpacking this product e 1x ST1500 e 1x Warranty card e 1x User manual Please note Some of the items above may be fitted to the product by the manufacturer SAFETY INSTRUCTIONS Please read these instructions carefully It includes important information about the installation usage and maintenance of this pro
3. XLR socket e Dip switch
4. ains before attempting to replace the fuse To replace the fuse please follow the following steps 1 Turn off unit and disconnect from mains 2 Remove the fuse holder cover with a screwdriver 3 Remove existing fuse 4 Fit new fuse 5 Refit the fuse holder Fuse 3AG 15A fast 250V POWER CAUTION This lighting effect is designed to operate at 230V 50Hz Power Consumption 1500W Fuse 3AG 15A fast 250V FEATURES ST1500 has power indicator red and DMX indicator orange at back panel The ST1500 can be operated in Manual dimmer control Sound active control and DMX control Manual control mode 1 Select dip switch all off 2 Connect ST1500 to main power supply Red indicator would be on 3 Adjust the strobe speed and brightness Sound active mode 1 Select dip switch 9 on and the rest are all off 2 Connect ST1500 to main power supply Red indicator would be on 3 Adjust sound sensitivity 2 Channel DMX control mode 1 Select dip switch 10 on use dip switch 1 to 9 to select DMX address 2 Connect DMX cable to DMX512 controller 3 Connect ST1500 to main power supply red and orange indicators would be on 4 Use DMX controller to adjust speed and brightness Channel 1 controls speed and channel 2 controls the dimmer SPECIFICATIONS e Weight 4 5kgs e Size 550x290x200mm e Voltage AC230V 50Hz e Power consumption 1500W e 3PIN female DMX XLR socket and 3PIN male DMX
5. duct e Please keep this User Manual for future consultation If you sell the unit to another user be sure that they also receive this instruction booklet e Always make sure that you are connecting to the proper voltage and that the line voltage you are connecting to is not higher than that stated on the rear panel of the fixture e This product is intended for indoor use only To prevent risk of fire or shock do not expose fixture to rain or moisture e Make sure there are no flammable materials close to the unit while operating e The unit must be installed in a location with adequate ventilation at least 50cm from adjacent surface Be sure that no ventilation slots are blocked e Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse source e Secure fixture to fastening device using a safety chain Never carry the fixture solely by its head Use its carrying handles e In the event of serious operating problem stop using the unit immediately Never try to repair the unit by yourself Repairs carried out by unskilled people can lead to damage or malfunction Please contact the nearest authorised technical assistance center Always use the same type spare parts e Never connect the device to a dimmer pack e Make sure power cord is never crimped or damaged e Never disconnect power cord by pulling or tugging on the cord e Avoid direct eye exposure to the light source while it is on
Download Pdf Manuals
Related Search