Introduction - Vari-Lite
Contents
1. 400W VL2202 luminaire and VL2402 luminaire 700W If the power selection setting and the luminaire type setting jumper J11 do not correspond the luminaire will not operate properly How Software Checks Jumper Positions The luminaire software checks the jumper position and if it is incorrect for the luminaire type then the WRNG SW PROG message will appear This message indicates an incorrect combination of jumper setting and software The luminaire will not calibrate in this condition BULLETIN No S2K 015 VARIAELITIE scctnicat bute oer Jumper Configuration To configure jumper Determine which type luminaire the MCB is to be installed in and configure jumper according to Figure 2 Note If luminaire will not calibrate or operate after MCB replacement check jumper setting and download new software R31 e i mte x L ov TXO om m E e moore seccce T U4 x ULL Bie i Main Controller Board Component Side VL2201 VL2202 VL2402 VL2416 Figure 2 MCB Jumper Configuration 16 JUL 01 BULLETIN No S2K 015 VARISKELITE sectnicat vuneun bi This page intentionally blank 16 JUL 01 BULLETIN No S2K 0152. VARI KLTE technical bulletin regen at SuBJECT VL2000 MCB Jumper Settings SERIES 2000 DISTRIBUTION Service Centers End Users STATUS Routine Introduction dint Purpose When installing a new Main Controller PCB Assembly MCB the jumper at J11 must be configured according to the luminaire type This technical bulletin provides guidelines for setting this jumper For additional information on the Main Controller PCB Assembly replacement refer to the appropriate Series 2000 service manual 16 JUL 01 BULLETIN No S2K 015 VARI Procedures 16 JUL 01 Identifying MCB Jumpers The Main Controller Board MCB contains two blue jumpers Programming Jumper J1 For Vari Lite engineering use The jumper at J1 is necessary and must be in the correct position in order for the luminaire to operate Do not change the configuration of jumper J1 Figure 1 ee Power Supply Jumper at J11 woe ie Connection Figure 1 Jumper Locations on MCB Luminaire Type Jumper J11 The jumper at J11 configures the luminaire type between VL220X and VL2402 luminaires For VL220X or VL241X luminaires it is fitted to non active pins This inactive setting is the default or shipping configuration For VL2402 luminaires it is fitted to the active pins Power Supply Connection J2 The power supply connection at J2 sets the luminaire type according to the power supply output VL2416 luminaire 1200W VL2201 luminaire
Download Pdf Manuals
Related Search