BANK ANGLE SENSOR SWITCH KIT - Harley
Contents
1. cMOTOR HARLEY DAVIDSON WY J04539 INSTRUCTIONS REV 2008 09 19 BANK ANGLE SENSOR SWITCH KIT GENERAL Kit Number 88115 09 Models This kit must be installed on 2009 and later FL Touring Models being fitted with a TLE or TLE Ultra Sidecar Kit This kit can also be used as a replacement on those same models already equipped with a TLE or TLE Ultra Sidecar Kit Early 2009 models may not have the correct battery box for the sidecar installation The battery box must have the inscription Sidecar Tip Sensor molded into the right front side of the battery box Additional Parts Required Early 2009 FL Touring models will require the Battery Tray Kit 66281 09A to use the Bank Angle Sensor when installing the TLE or TLE Ultra Sidecar Kit Following installation of the Bank Angle Sensor Switch the DIGITAL TECHNICIAN II and Data Link must be used to program the security module TSM TSSM HFSM for sidecar with gravity activated bank angle sensor application WARNING Failure to properly configure the TSM TSSM HFSM can cause engine to shutdown which could lead to loss of control and death or serious injury 00581b If the security module is not configured and calibrated after the sidecar and bank angle sensor has been installed the motor cycle will operate in solo mode and the engine may shut down when the vehicle takes a sharp corner Additionally the turn signals may cancel prematurely when navigating r2. ht front corner of the battery tray with the screw from the kit Refer to the Service Manual and follow the instructions given to install the right side cover tucking any excess wires under the cover Install the main fuse left side cover and saddlebag per the instructions in the Service Manual 1 of2 NOTES If the Bank Angle Switch is actuated by tilting the ignition circuit is disabled The Bank Angle Switch may be reset by turning the ignition switch OFF for five seconds then ON Whenever the sidecar is removed the Bank Angle Switch kit should be removed and the security module should be switched back to solo vehicle operation by a Harley Davidson dealer Instructions for installing or removing the Bank Angle Switch Kit and procedures for configuring the security module are given in the Sidecar Service Manual Part Number 99485 xx SERVICE PARTS is05389 TUL LM 5 A Figure 2 Service Parts Bank Angle Sensor Switch Kit Table 1 Service Parts Table Item Description Quantity Part Number 1 Switch bank angle sensor 32495 98 2 Harness bank angle sensor 88104 09 3 Screw self tapping 4790 Items mentioned in text but not included in kit A Battery tray J04539 2of2
3. ough condi tions i e potholes bumps etc Kit Contents See Figure 2 and Table 1 INSTALLATION NOTE If equipped with the optional Harley Davidson Smart Security System verify that the security status lamp in the soeedometer face is not flashing security system disarmed before pro ceeding WARNING To prevent accidental vehicle start up which could cause death or serious injury remove main fuse before pro ceeding 00251b J04539 is05804 1 Battery tray 2 Bank angle sensor sidecar tip sensor location Figure 1 Battery Tray for Bank Angle Sensor See Figure 1 Remove the right side cover If the battery tray 1 does not have the inscription Sidecar Tip Sensor as shown in Figure 1 you must purchase and install the Battery Tray Kit 66281 09A before installing the sidecar Remove the left side saddlebag according to the instruc tions in the Service Manual Remove the left side cover and disconnect the main fuse Where you removed the right side cover disconnect the gray twelve way socket housing from the security module Plug it into the twelve way pin housing on the bank angle sensor harness from the kit Plug the gray twelve way socket housing from the bank angle sensor harness into the security module Plug the three way socket housing from the bank angle sensor harness into the bank angle sensor switch Install the bank angle sensor switch to the rig
Download Pdf Manuals
Related Search