Soft Lower Kit Instruction Sheet - Harley
Contents
1. Buckle Soft lower Highway Footrest Zipper AONT Figure 1 Soft Lower 1of2 Please dispose of materials responsibly is07247 1 Fender 2 Amber reflector location Figure 2 Amber Reflectors J05589 2 of 22. MOTOR HARLEY DAVIDSON WY J05589 INSTRUCTIONS REV 2012 02 15 SOFT LOWER KIT GENERAL Kit Numbers 57100210 57100211 57100212 Models For model fitment information see the P amp A Retail Catalog or the Parts and Accessories section of www harley davidson com English only Additional Parts Required WARNING The rider s safety depends upon the correct installation of this kit Use the appropriate service manual procedures If the procedure is not within your capabilities or you do not have the correct tools have a Harley Davidson dealer perform the installation Improper installation of this kit could result in death or serious injury 00333a NOTES All models require a model specific engine guard e Soft Lowers are not compatible with Mustache or Nostalgic style engine guards This instruction sheet references Service Manual informa tion A Service Manual for your model motorcycle is required for this installation and is available from a Harley Davidson Dealer Kit Contents Table 1 Kit Contents Description Quantity Part Number Soft lower right side 1 Soft lower left side 1 Not sold separately Amber reflectors kit 57100210 only 2 59256 84A Not sold separately INSTALLATION 1 See Figure 1 Locate soft lower 2 for left side Bar and Shield should face forward and opening in soft lower should be on right side 2 Slip soft lower on left side
3. of engine guard 3 Zipper 4 on the outer edge of the soft lower allows the soft lower to fit over highway footrest 3 NOTE Position strap to provide clearance to hot engine components J05589 Many Harley Davidson Parts amp Accessories are made of plastics and metals which can be recycled 4 Place the wide attaching strap around the frame downtube do not put strap over clutch cable 5 Slip buckle 1 on attaching strap onto mating buckle halve attached to back side of soft lower Latch will snap into locked position when buckle is properly closed 6 Adjust the fit by lifting the hook and loop attached strap on rear of the soft lower and changing length as required 7 Repeat procedure for right side of vehicle 8 If soft lowers cover amber reflectors mounted on frame down tubes install reflectors included in kit a See Figure 2 Clean areas on both sides of fender 1 where amber reflectors are to be mounted b Remove backing paper from rear of reflector and place reflectors in position 2 WARNING Federal Motor Vehicle Safety Standard FMVSS 108 requires motorcycles to be equipped with rear and side reflectors Be sure rear and side reflectors are properly mounted Poor visibility of rider to other motorists can result in death or serious injury 00336b NOTE To remove soft lowers press latch with thumb and forefinger and gently pull buckle apart Slide soft lower off engine guard is07246
Download Pdf Manuals
Related Search