Chrome Efi Coil Cover Kit Instruction Sheet - Harley
Contents
1. Service Parts Chrome EFI Coil Cover Kit 1 of2 Please dispose of materials responsibly Table 1 Service Parts Chrome EFI Coil Cover Kit Item Description Quantity Part Number 1 Cover coil front Not Sold Separately 2 Cover coil rear Not Sold Separately 3 Spacer coil cover 2 74650 04 4 Screw flat head chrome 2 74649 04 5 Allen wrench 5 32 inch Not Sold Separately 6 Wear pad Not Sold Separately J03082 2 of 22. cMOTOR HARLEY DAVIDSON WY J03082 INSTRUCTIONS REV 2004 02 20 CHROME EFI COIL COVER KIT GENERAL Kit Number 74616 04 Models This kit fits EFI fuel injected versions of 2001 and later Softail and 2004 and later Dyna model motorcycles Additional Parts Required NOTE A Service Manual for your model motorcycle is available from your Harley Davidson Dealer Kit Contents See Figure 1 and Table 1 INSTALLATION AWARNING To prevent accidental vehicle start up which could cause death or serious injury disconnect negative battery cable before proceeding 00048a 1 Refer to the Owner s Manual and follow the instructions given to remove the seat and disconnect the negative battery cable Retain all seat mounting hardware 2 Note the position of each spark plug wire in the ignition coil then disconnect the two wires If there is an existing coil cover remove and discard the coil cover mounting screws and spacers Remove and discard the coil cover 3 Detach connector 83B from the back side of the coil Remove the two coil mounting screws and set aside 4 See Figure 1 Position the rear coil cover 2 to the back side of the coil with the electrical connector protruding through the large opening 5 Assemble the coil and rear cover to the motorcycle with the two screws removed in Step 3 Adjust the cover to center the coil towers in the notches in the side of the cover Tighten the
3. screws to 50 in Ibs 5 6 Nm 6 Obtain the front coil cover 1 two spacers 3 and two chrome flat head screws 4 from the kit 7 For Dyna models only Also obtain the wear pad 6 from the kit Peel the liner from the adhesive backing of the wear pad and position the pad to the side of the front coil cover as shown on the side closest to the electrical box 8 For ALL models Insert the screws through the mounting holes in the cover face and place the spacers counter J03082 Many Harley Davidson Parts amp Accessories are made of plastics and metals which can be recycled sunk end first over the screw threads inside the front cover 9 Install the cover over the coil so the coil towers fit into the notches in the side of the cover Line up the chrome screws with the threaded holes in the rear cover and fasten securely with the Allen wrench from the kit 10 Connect the spark plug wires through the holes in the side of the coil cover onto the correct coil terminals 11 Re attach connector 83B to the back side of the coil 12 Refer to the Owner s Manual and follow the instructions given to re attach the negative battery cable and install the seat INIA NIN After installing seat pull upward on seat to be sure it is locked in position While riding a loose seat can shift causing loss of control which could result in death or serious injury 00070b SERVICE PARTS is02134 Figure 1
Download Pdf Manuals
Related Search