602-021 1969-1982 and 1984-1996 Anti
Contents
1. three armrest mounting screws one on door pull two at bottom of armrest If equipped remove window crank handle on cars without power windows NOTE We recommend using our 602 063 Knob Removal Tool to prevent damage to door panel or knob mechanism This handy tool can be used on all horseshoe clipped interior handles Remove three door panel screws one on upper corner one on mid section one in lower carpeted corner Slowly lower door panel enough to expose anti rattle cushions using care not to damage electric door lock switch and mirror adjustment knob Important note the routing of the lock rod for door panel reinstallation Note location of existing anti rattle cushions Use a pencil or scribe to mark bolt location so new cushion can be installed in same location in elongated holes Remove the anti rattle cushion bolts then cushions Install new anti rattle cushions and bolts using alignment marks from Step 6 Carefully roll window up and down to check cushion alignment Adjust if necessary 0 Reinstall door panel and applicable hardware INSTALLATION FOR 1984 1996 CORVETTES Please consult Service Manual Mid America Motorworks 1 Mid America Place P 0 Box 1368 Effingham IL 62401 800 500 1500 Worldwide 217 540 4200 FAX 217 540 4800 www mamotorworks com mail mamotorworks com Copyright 2008 Mid America Motorworks2. miD AMERICA u MOTORWORKS Pursue your passion here Suggested Installation Instructions for 602 021 1969 1982 and 1984 1996 Anti Rattle Window Cushions Set of 4 NOTE As door panel removal is a tedious job you may want to consider replacing other worn or failing parts at this time such as window regulator gear or spring door panel locks switches handles trim pieces or mechanisms INSTALLATION FOR 1969 1977 CORVETTES 1 2 uw Remove screws at four corners of door panel Remove door lock knob and window crank handle on cars without power windows NOTE We recommend using our 602 063 Knob Removal Too to prevent damage to door panel or lock knob mechanism This handy tool can be used on all horseshoe clipped interior handles Remove door handle screw located in door handle opening then door handle Slowly lower door panel enough to expose existing rattle cushions Note location of existing anti rattle cushions Use a pencil or scribe to mark bolt location so new cushion can be installed in same location in elongated holes 6 Remove the anti rattle cushion bolts then the cushions 7 Install new anti rattle cushions and bolts using alignment marks from Step 5 8 9 Reinstall door panel and handles Carefully roll window up and down to check cushion alignment Adjust if necessary INSTALLATION FOR 1978 1982 CORVETTES 1 25 3 gt e OON Unscrew and remove door lock knob Remove the
Download Pdf Manuals
Related Search