II 999C3-Xxxxx P42K 130503 Cargo Area Protector
Contents
1. side flaps 20 Apply pressure to shaded areas as shown to secure hook and loop fasteners A ly pply pressure to shaded areas 7 Na do lt Il A Kal EW lt MUT 21 When protector is removed from vehicle 2 round hook loop discs remain attached to load floor carpet Note Do not remove adapters after they have been properly installed Protector permanent attachment points my Page 7 of 7 999C3 XxxxxII Rev 5 3 20132. GENUINE PARTS INSTALLATION INSTRUCTIONS DESCRIPTION Cargo Area Protector APPLICATION Pathfinder PART NUMBER 999C3 XZ100 Black 999C3 XZ101 Beige 999C3 X2002 Chocolate KIT CONTENTS part Description Cargo Area Protector Hook and Loop Adapter comes attached to underside of protector Hinge Assy Installation Instruction Replacement Template TOOLS REQUIRED e 3 Phillips Screw Driver e 4mm 5 32 Allen Head Socket Driver PRE INSTALLATION WARNINGS CAUTIONS CRITICAL STEPS and NOTES e Dealer Installation Recommended Instructions may refer to Service Manual Note Protector is equipped with very aggressive hook fasteners on underside Do not place protector in the cargo area without due care Hook fastener will affix itself to ANY carpet surface Use care when placing into vehicle A WARNING Protector is designed to transport normal cargo contents Flammable or dangerous materials should not be transported in your vehicle at any time Page 1 of 7 999C3 XxxxxII Rev 5 3 2013 INSTALLATION PROCEDURE 1 Fold down headrests and 3rd row seats 2 Lift up cargo bin lid to upright position 3 Loosen and remove 2 passenger side hinge screws with phillips screw driver Keep screws for later use 4 Repeat for driver side Page 2 of 7 999C3 XxxxxII Rev 5 3 2013 INSTALLATION PROCEDURE 5 Lay cargo bin lid on back of 3rd row seats 6 Loosen and remove 2 passenger side hinge screws wit
3. h 4mm allen head socket driver Keep screws for later use Discard hinge 7 Repeat for driver side Page 3 of 7 999C3 XxxxxII Rev 5 3 2013 INSTALLATION PROCEDURE Fig 6 8 Remove new molded hinge assembly from packaging and orient hinge as shown in Fig 6 Attaches to lid 9 Align passenger side molded hinge assembly with holes on bottom of cargo bin lid 10 Tighten 2 hinge screws with 4mm allen head socket driver to 1 5 2 0 Nm 1 1 1 5 Ib ft 11 Repeat for driver side Page 4 of 7 999C3 XxxxxII Rev 5 3 2013 INSTALLATION PROCEDURE 12 Place cargo bin lid in upright position aligning lower hinge holes with vehicle holes 13 Tighten 2 passenger side hinge screws with phillips screw driver to 1 5 2 0 Nm 1 1 1 5 Ib ft 14 Repeat for driver side 15 Ensure both molded hinge assemblies are attached with specified torque Page 5 of 7 999C3 XxxxxII Rev 5 3 2013 INSTALLATION PROCEDURE 16 Close cargo bin lid Note e Protector is equipped with aggressive hook fastener on underside e Use care when placing into vehicle 17 Fold up protector s side flaps and cover underside hook and loop adapters with fingers z 18 Place protector into cargo area carefully aligning th protector s center opening with vehicle load floor latch Page 6 of 7 999C3 XxxxxII Rev 5 3 2013 INSTALLATION PROCEDURE 19 Once aligned remove fingers from underside hook and loop adapters Fold down
Download Pdf Manuals
Related Search