Howe Ice Flaker Warranty Registration
Contents
1. cq Howe Ice Flaker Warranty Registration It is Howe Corporation s requirement that the refrigeration contractor insert the following information when installing Howe Flake Ice Equipment Once completed please fax this document to Customer Service at Howe Corporation at fax number 773 235 0269 Any questions please call 773 235 0200 Howe Ice Flaker Model Serial Name of Ultimate User Refrigeration Company Name Address City St Zip Phone Technician s name PRINT Installation Date Refrigerant check one R 404a R 22 R 507 Other Ice Machine Connected to Rack Condensing Unit Location of EPR Valve check or list one below At Rack At Ice Flaker List other location EPR Valve Model Heat Exchanger installed Yes No Are there bubbles in the sight glass Yes No Water level in distribution pan 2 full Check ball valve Yes No Suction pressure of Flaker s evaporator measured at Schrader valve on suction line at outlet of evaporator PSIG Note The Howe Flaker s TXV adjustment needs to be made while looking at the evaporator s freezing surface through the opening at the top of the ice flaker barrel When TXV is adjusted properly the freezing surface should be uniformly covered by one continuous sheet of ice from the top of the evaporator all the way to the bottom Often times TX V must be opened for proper adjustment After TXV is adjusted per factory setting place a check mark on the photo below whic2. h most closely resembles the look of the sheet of ice on the Ice Flaker s evaporator Improperly adjusted Properly adjusted L Check here L Or check here Once TXV is adjusted determine the superheat setting of the evaporator Degrees F Refer to Quick Step Guide and or Installation amp Service Manual for recommended factory settings Superheat doesn t necessarily indicate the TXV is adjusted correctly However it can confirm TXV is not adjusted correctly After proper adjustment referenced on the Quick Step Guide draw arrow on dial indicating the approximate Hi Amperage Overload setting I5 OFF DELAY After proper adjustment referenced on the Quick i re dg Step Guide draw arrow on dial indicating the approximate Off Delay Timer setting Condensing unit settings for split systems Low Pressure Control Condenser Fan Switch es vas Dai eu CUT OUT IS turin A LESS DIFFERENTIAL CLOSES ON RISE OF PRESSURE Cut in setting Lbs Differential setting Pressure Refer to Quick Step Guide and or Installation amp Service Manual for recommended factory settings
Download Pdf Manuals
Related Search