E2190-2_透明ポリカ安全防護板取扱説明書
Contents
1. In case of dirty on the surface wash it with water after the work If it cannot be cleaned wipe it with soft cloth moistened with water or neutral detergent diluted two hundred times with water Neat liquid should not be used surface would be affected Alkali detergent and hard cloth must not be used It makes crack and scratch Packing Case Transparent PC Protection Board should be stored in the shade after disassembly and put it into the Packing Case If there are any issues you have noticed or have any requests please contact distributor or CONSEC 733 0833 4 6 8 TEL 082 277 5451 FAX 082 278 6389 M2. Transparent PC Protection Board must be securely fixed with Connection Pipe In addition to prevent falling over the PC Protection Board by gust of wind it needs to do fall down preventing measures with fixing to ex Scaffolding by wire or annealing wire DO NOT use except our Wire Saw Machine 5 DO NOT use and store in high temperature place or with solvent and paint because the surface of Transparent PC Protection Board is affected or created crack 6 DO NOT hammer or apply the impact to prevent the breakage 7
3. When carrying Transparent PC Protection Board DO NOT put anything on the board to prevent brakeage by vibration and so on 5 Estimated usable period is 5 years after beginning of use DO NOT use over 5 years Purchase new one in case of breakage or damage 00 with impact even in the life period A CAUTION Truss Head Small Screw is tightened properly considering Transparent Polycarbonate thermal shrinkage If too much tightening torque is applied on the screw Transparent Polycarbonate possibly breaks 5 Precautions for storage WARNING 1 200
4. TRANSPARENT PC PROTECTION BOARD INSTRUCTION MANUAL 1 Before use TRANSPARENT PC PROTECTION BOARD is used for working with Wire Saw Please read instruction manual for TRANSPARENT PC PROTECTION BOARD and Wire Saw carefully And please use it properly according to the Warnings and Cautions 2 Content of Packing 2 2 Transparent PC Connection Pipe M8 x 35 4 Protection Board M8 4 1 Wing Nut M8 Connecting Fitting Sleeve Wing Bolt M8X35 3 Assembling Method Set up Transparent PC Protection Board with sticker face on worker s side Connecting Fitting It is used for connecting Transparent PC Protection Board side
5. Precautions for use Safety Net With Frame i me PC Protection Board should be set up in front of worker WARNING H 1 Wire Saw and Cutting Object must be surrounded by Safety Net With Frame or other protective equipment to ensure the safety in case of wire flying due to the breakage If the protection measures is not proper it is caused fatal accident and quite danger Transparent PC Protection Board WARNNG 2 Worker must operate the Wire Saw machine out of surrounded zone by Safety Protection Board or Safety Net Transparent PC Protection Board must be set up in front of the operator 3
6. ain office 4 6 8 Shoko Center Nish ku Hiroshima 733 0833 Japan International Department 1 7 5 1 Sakaimachi Naka ku Hiroshima 730 0853 Japan Phone 81 82 297 3231 Fax 81 82 297 3230 CONS CONSEC CORPORATION 2 E2190 2
7. by side Transparent Polycarbonate Truss Small Screw Procedure for assembly 1 Insert bottom of Transparent PC Protection Board into Protection Board Stand Wing Nut Sleeve Wing Bolt Connection Pipe Fix the Connection Pipe with using Sleeve Wing Bolt and Wing Nut after inserting the Connection Pipe as figure shown USE START DATE 2 YJ i M Insert upper Transparent PC Protection Board with 6 Please surely write USE START sticker being same face as bottom board and fix Protection Board 1 0 Stand Ostion DATE by oil base ball point pen with using Sleeve Wing Bolt and Wing Nut Pp 4
Download Pdf Manuals
Related Search