Samsung AW0510D User Manual
Contents
1. Check to see whether the air filter is clogged with dust or contaminated with foreign substances Clean the air filter Check to see whether there is any direct sunlight facing the air conditioner Block the sunlight with a sunshade Check to see whether there is any electric device generating heat Do not use the air conditioner together with any heating device Technical Specifications Model Cooling Capacity BTU h Power Supply AWOS00 5000 115V 60Hz AW0500A Design and specifications are subject to change without notice E 11 Installation o 55 9 22 to 91 5cm 36 32 7 12 7 8 min Before installation please read the INSTALLATION instructions then follow the procedures in order after considering the installation area and drain hose CAUTION The manufacturer does not assume responsibility for accident or injury caused by an incorrectly installed air conditioner If you are unsure about installation contact an installation specialist Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any defects such as scratches Be sure to check the power supply Refer to the specifications on the label attached to the unit Installation instructions 1 Electrical Requirements For personal safety This appliance must be properly grounded Do not under any circumstances cut or remove the third gr2. Top support channel Window filler panel Right Screw 4X10 Adhesive seal strip Window filler panel Left Window bracket Window gasket 1 Install the top support channel with three Type B screws provided Top support channel Note The screw holes are larger gauge on the channel and smaller on the cabinet The top support channel is L shaped The high side of the channel must always face inwards 2 Assemble the window brackets on the cabinet 2 1 Loosen the lower screw slightly on each side of the cabinet and install the Type C window bracket 2 2 Tighten the screws securing the brackets Window bracket Type 3 Attach the window filler panels to the unit 3 1 Slide the window filler panels and their frames into the channels on the top and bottom of the cabinet 3 2 Assemble the window filler panels to the cabinet using six Type B screws E 13 Installation Cont 4 Attach the seal strip to the window 4 1 Cut the adhesive backed foam seal strip gasket to the window width 4 2 Remove the backing from the seal strip and attach the strip to the underside of the bottom window 5 Install the drain plug The unit does not require any separate drain system However a separate drain plug can be installed if needed Rubber Cap Cooling capacity Noise D
3. 3 To control the direction of the air flow refer to page 7 Ventilating Your Room the air in your room is stale you can ventilate the room using the Fan feature 1 If you wish to discharge stale air push the ventilation switch on the front of the unit to the right and open position Result The air inside the room circulates and stale air is discharged outside SS tn Otherwise push the ventilation switch to the left and closed position lt Result The air simply circulates inside the room 2 Turn the SELECTOR and set it to FAN or LOW FAN position Low Result The air conditioner starts up in fan mode 7 I Note fan turns rapidly LOW FAN The fan turns slowly ti You can change modes at any time MED Cool Selector 3 To control the direction of the air flow refer to the section below Adjusting the Air Flow Direction Horizontally The air flow direction blades can be adjusted to improve the efficiency of the air conditioner 1 The side by side air direction louvers are together and are controlled by a lever They regulate air discharge to the right left or to the centre 7 E 8 Power Failure power failure occurs set the SELECTOR to OFF When the power comes back on wait five minutes before turn
4. 4 Description of Each Component Air inlet Outside Air outlet Air inlet Inside Air Filter Inside Ventilation Switch Air flow direction adjustable lever Power plug Be sure to check the voltage MED Cool before installation Thermostat Selector Thermostat control Selector Getting Started You have just purchased a Samsung window type room air conditioner which should be installed following your Owner s Instructions Your Owner s Instructions contain much valuable information on using your air conditioner Please take the time to read them as they will help you take full advantage of the unit s features E 5 Cooling Your Room Off Fan Cool 2 25 2 8 Selector 270 030 81 F 73 5 6 7 230780 1 4 3 8 270 290 0 i Ee xX Thermostat You must select the COOL mode if you wish to adjust the Cooling temperature Fan speed when Cooling 1 Turn SELECTOR and set it to COOL MED COOL or LOW COOL Result The air conditioner starts up in cool mode Note You can change modes at any time 2 the THERMOSTAT control to the desired position Possible temperatures Can be set between 18 C 64 F and 29 C 84 F Result The air conditioner starts cooling if the room temperature is higher than the selected temperature
5. OWNER S INSTRUCTIONS AW0500 AWO0500A WINDOW TYPE ROOM AIR CONDITIONER Cool 60 68 00968 2 2 Safety Precautions The following safety precautions must be taken when using your air conditioner 1 The unit must be plugged into an independent circuit The air conditioner must be installed in accordance with national wiring regulations and safety regulations wherever applicable 2 Some installation locations may require installation of a short circuit breaker or grounding 3 Ifthe supply cord is damaged it must be replaced by a special cord or assembly available from the manufacturer or an authorized service centre 4 MAKE sure that the unit is correctly ventilated at all times do NOT place clothing or other materials over it 5 NEVER spill any kind of liquid into the unit Should this happen unplug the unit and contact an authorized service center 6 Do NOT insert anything between the air outlet blades because the inner fan may be damaged and could cause injury Keep children away from the unit 7 Do NOT place any obstacles in front of the unit 8 Users of this product are cautioned not to attempt repairs Instead they are requested to directly contact a designated service center or the outlet at which the product was purchased 9 Do not use an extension cord with this product 10 The appliance is not intended for use by young children without supervision young children sho
6. e cleanliness of the air conditioner Set the SELECTOR to LOW FAN and dry the inside of the air conditioner by operating it for 4 5 hours The service life of the air conditioner is lengthened when the dew formed on the heat exchanger is removed before storage Turn off the air conditioner and pull out the power plug 9 Solving Common Problems Before contacting an authorized service center perform the following simple checks They may save you the time and the expense of an unnecessary call Problem Explanation Solution The air conditioner Check for a power failure does not operate at all Check the voltage See the technical specifications Check the power plug for disconnection Check to see whether the SELECTOR is placed in the OFF position Set it to the desired position Check to see whether the room temperature is too low Refer to page 8 for details about temperature condition The air comes out smoothly Set the THERMOSTAT control to the desired position but cooling is not effective When the number on the THERMOSTAT control is high the room temperature may be too warm Check to see whether there is any open window or leakage of cool air to the outside Close the window and fill the gap Check to see whether there is any obstacle adversely affecting the flow of the air inside and outside the room Remove the obstacle or change the position of the air conditioner
7. ing the unit back on Temperature and Humidity Range The following table indicates the temperature and humidity ranges within which the air conditioner can be used If the air conditioner is used at Then Higher temperature The automatic protection feature may be triggered and the air conditioner stopped Lower temperature A water leakage or some other malfunction may happen if the heat exchanger freezes Mode Indoor Temperature Outdoor Temperature Indoor Humidity Cooling 21 C 70 F to 32 C 90 F 21 C 70 F to 43 C 110 F 80 or less approx approx If the unit is used for long periods at a high humidity level water may condense on and drip from the surface of the air conditioner Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time PORTANT When cleaning the air conditioner tum it off and pull out the power plug 1 the air filter handle pull it slightly forward and then pull it out to the right side 2 Remove the dust on the air filter using a vacuum cleaner and brush 3 Insert the air filter back into its original position 4 Wipe the surface of the unit with a neutral detergent and then wipe it again with dry cloth Be sure not to use benzene solvent or other chemical products Note Storing the unit for a long period of time Check th
8. is not included in the warranty All warranty repairs must be performed by a Samsung Authorized Service Centre Obligation of the Original Owner The original dated purchase receipt must be retained as proof of purchase and presented to the Authorized Service Centre before warranty services are rendered Exclusions of the Warranty This warranty does not cover damage due to accident fire flood and or other Acts of God misuse incorrect line voltage improper installation improper or unauthorized repairs commercial use or damages which occur in shipping Exterior and interior finish and plastic parts are not covered under this warranty Customer adjustments which are explained in the instruction manual are not covered under the terms of this warranty This warranty will automatically be voided for any unit found with a missing or altered serial number This warranty is valid only on products purchased and used in Canada SAMSUNG ELECTRONICS CANADA INC 7037 Financial Drive Mississauga Ontario L5N 6R3 Printed in Korea ELECTRONICS
9. ounding prong from the power cord We recommend that you do not use an extension cord an adapter plug with this appliance Do not change the plug on the power cord of this appliance Follow national electrical codes or local codes and ordinances 115V 230V 208V 230V 208V 230V 208V 15 AMP circuit 20 AMP circuit 15 AMP circuit 30 AMP circuit parallel type perpendicular type tandem type tandem type the electric supply provided does not meet the above specifications call a licensed electrician Aluminum house wiring may pose special problems consult a qualified electrician This unit requires a separate circuit serving only this appliance 12 i l Window Requirements Standard double hung window with actual opening width of 55 9cm 22 to 91 5cm 36 The installation will need to be modified for windows other than the standard double hung type Clear vertical opening of 32 7cm 12 7 8 minimum from bottom of sash to sill Install the air conditioner in a window where there will be enough Clearance around the cabinet to allow ample circulation of air through the unit Note All supporting parts should be secured to firm wood masonry or metal Window installation Tools needed Philips head screwdriver Ruler or tape measure Adjustable wrench Pencil Scissors Parts furnished Name of part Name of part Name of part Long wood screw 5X16
10. rain system installed Decreased Decreased Without drain system installed Increased Increased 5 1 Remove the rubber cap inserted into the basepan 5 7 5 2 Fix the drain plug as shown in the figure and then connect the drain Rubber Cap hose You can use commercially available drain hose Drain Plug ct Drain Hose 6 Install the unit in the window 6 1 Place the air conditioner cabinet into the window with the top support channel positioned just in front of the bottom sash 6 2 Center the cabinet side to side in the window then pull the window down until it rests on the air conditioner just behind the mounting channel front flange on top of the cabinet 6 3 Make sure the cabinet maintains a slightly downward slant to the outside A 4 slant cabinet front to rear is desirable to help prevent water from entering the room 14 _ 7 Extend the window filler panels Type A screws 7 1 Secure the window brackets to the stool using the Type A screw at 7 each side ean aes 7 2 Secure the top mounting channel to the bottom sash with the Type A screw in the center 7 3 Extend the window filler panels into the window sash tracks on both sides When the window is pulled down the window should re
11. st on the unit just behind the window filler panel frames 7 4 Slide the window filler panels outward until they touch the sides of the window Secure the panels by putting four Type A screws through the mounting holes in the panels and driving them into the window stool and sash Window bracket C lt b screw 8 Install the window gasket Cut the foam window gasket to the window width and stuff it between the window and the glass to prevent air and insects from getting into the room 9 Check for air leaks and seal 10 Plug in the power switch the air conditioner turn the SELECTOR to COOL mode and check for unusual vibrations Note After several minutes the unit will be blowing out cold air If the unit is not cold please return it to the dealer E 15 Installation Cont Removal of the Front Grille If you need to remove the front grille for replacement follow the steps below 1 the air filter handle pull it slightly forward and then pull it out to the right side Note Remove the shipping tape before pulling out the air filter if necessary 2 Remove the screw below the control panel that holds the grille in place Remove two knobs on the lower right hand section by pulling them forward 3 Disassemble the front grille 3 1 Press both sides of the cabinet in the direction of the arrow as shown in the figure 3 2 Pull the lower par
12. t of the front grille slightly forward Note not pull bottom edge of grille toward you more than 7 6cm 3 Damage to the grille s two top tabs may occur 3 3 Grasp the grille at both sides near the bottom and carefully lift it straight up to disengage the grille s two top tabs from slots near the top of the cabinet 4 Reinstall the front grille 4 1 Fix the upper front grille 4 2 Slide one side of the lower part of the front grille slightly backward 4 3 Slide the other side backward 4 4 Reinstall the screw the air filter and the knobs E 16 17 YOUR SAMSUNG ROOM AIR CONDITIONER WARRANTY Limited Warranty to Original Purchaser Samsung will repair or replace at our option this product if found defective within the warranty period beginning from the original date of purchase This Samsung Product is warranted by SAMSUNG ELECTRONICS CANADA Inc against manufacturing defects in materials or workmanship for the period specified Labor 1 Year Carry in Limited 5 Years Compressor Warranty Within one year of purchase Samsung Electronics Canada Inc will provide a replacement compressor if it is found to be defective in material or workmanship During the existing four years second through fifth year Samsung Electronics Canada Inc will provide a replacement only without charge if it is found to be defective in material or workmanship Labor to install the compressor during these existing four years
13. uld be supervised to ensure that they do not play with the appliance 11 Because the rear of air conditioner is very sharp please put gloves on when carrying or installing the air conditioner 12 Never store or ship the air conditioner upside down or sideways to avoid damage to the compressor CAUTION The manufacturer does not assume responsibility for accidents or injury caused by an incorrectly installed air conditioner If you are unsure about installation contact an installation specialist Contents PREPARING YOUR AIR CONDITIONER Precautions ested abe 2 Description of Each Component 4 Getting Started 5 OPERATING YOUR AIR CONDITIONER Cooling YOUr ROOM aati anata 6 m Ventilating Your 7 m Adjusting the Air Flow Direction Horizontally 7 RECOMMENDATIONS FOR USE Power Failures ee i i ele 8 m Temperature and Humidity 8 Cleaning Your Air 9 Solving COMMON 10 Technical Specifications 11 ds a a le 12 E 3
Download Pdf Manuals
Related Search