WPB Series Wireless Push Button User Guide
Contents
1. the 16 IS intend to encode the data of 1 remote transmitter will be replaced by the 16 There will be no influence if the data is re encode E Reset the unit to delete all the remote transmitter coding data Press Learning Key constantly LED on for approximately 8 sec until the LED off which means all the data in the receiver has been deleted completely E Battery 1 The voltage of a new battery is about 12 6V that is allowed to transmit data and work perfectly about 10 000 cycles and 13 000 cycles most 2 Low battery indication Copyright All Rights Reserved P MU WPB Ver B Publish 2013 01 08 Page 1 2 Diagram A WPB to be used as door access control Power sinay Timer delay setting aa 1 second Bll 3 seconds Lia 5 seconds 10 seconds Learning LED Learning Key Setting Press Learning Key Then press the button of remote transmitter Clearing Press Learning key constantly for The clearing status approximaterly 8 Sec in the receiver Until LED is off Diagram B Associate with proximity reader or keypad Controller Copyright All Rights Reserved P MU WPB Ver B Publish 2013 01 08 Page 2 22. WPB Series Wireless Push Button User Guide TX Specifications RF Hopping Code Controller RX Remote Transmitter TX Power 12 24 VDC Input 12 VDC battery Currentdraw Pull n 50mA 12 VDC oeng 20mA 12 VDC Transmitting 433 KHZ Pull in 70mA 24 VDC Holding 40mA 24 VDC frequency Output 1 relay N O COM N C The brightness of LED is LED indicator based on the capacity of Relay Rating 3A 120 VAC 3A 24 VDC the dry battery The receiver RX starts beeping when the Transmitting Max 50 60M battery is lower than 7 VDC distance Buzzer indicator Green LED gt Power Embedded Red LED gt Receive amp input modules Timer setting 1 3 5 10 seconds oe Max 13 000 cycles The quantity of ic The Lowest Not lower than 7V for the battery the remote pas voltage of the remote transmitter transmitter applied PB contact can connect Request to Exit Button which is the same function as the remote transmitter LED indicator Hopping Code IC Operating indication E Encoding the remote transmitter Press Learning Key gt then press the button of the remote transmitter gt remote transmitter data encoded When encoding if the button of the remote transmitter is pressed constantly it will not only be encoded but also implement to open the door To encode other remote transmitter please do the operation again Attention there are 15 remote transmitters data can be encoded into to the receiver if
Download Pdf Manuals
Related Search