Operating Instructions and Illustrations for Abrasive Belt Grinder
Contents
1. Operating Instructions and Illustrations for Abrasive Belt Grinder Regulatory Screw Operation Holder a Motor AINE ScTuw Plastic Wheel Surface l ad Matar Ring Bc a Sai teh F Tc EAS Molor llalder m 5 ZES 5 7 DS j i a 2 F T o z 2 5 G 7 oz u Inspect if the voltage is conforming and if abrasive belt and screws are loose before doing the operations as follow e Connect with main supply turn on the power to see if abrasive belt runs in parallel if abrasive belt deviates in running regulate the abrasive ring belt to the position as adequate with regulatory screw under running status before starting operation 2 To place the grinding base flatly unfasten the fixing screw on the motor rings before pulling down the grinding base to flat or to the desired grinding angle then fasten the fixing screw adequately over fastening may result breaking of screw or crack of rings 3 To replace abrasive ring belt pull up the fastening wrench to unfasten the abrasive ring belt pull down the wrench again when the abrasive ring is belt replaced 4 To replace rubber wheel grab the wheel manually before removing the 5 8 fixing nut left threaded nut unfasten it clockwise with a jerk of rubber wheel with 26m m socket fasten the nut again after the rubber wheel is replaced fasten it counter clockwise with a jerk X Clear the dust on the grinder on a r2. egular basis to assure the normal operations of driving and belt tension BHn mechanism Do not use porous socket extension wire or operate several machines in the same socket to avoid damage of motor due to the low voltage Do not overload the grinder to prevent damage to the motor due to speed down of motor and rise of voltage
Download Pdf Manuals
Related Search