OPERATING INSTRUCTIONS Slide Badge Machine L R T
Contents
1. and remove your finished badge I nsert wire pin If you ve loaded the next badge already just go back to Step 3 and repeat e gt Lower dies slide to right and left2. Badger Makes Badges 78 Bathurst St O BadgeBee soba as RO C p Ph 03 6231 2197 Ee ES Slide Badge Machine mT 03 6231 3158 Spex OPERATING INSTRUCTIONS for 25mm wire pin Badges _ Please call us if you experience Remove the sticky tape from the Right Die any problems R It is just to stop the plastic ring falling out during transport PLEASE APPLY STICKY TAPE PRIOR TO RETURNING THE MACHINE _ Make sure that the Lower Dies L and R can slide freely to the left and right Slide the bottom dies all the way to the left so you can access the Left Die L _ Place the metal front curved side up so it sits in the groove Place your pre cut artwork on top picture side up The top of the picture should be at the back of the die Place a clear plastic circle over the top Slide the bottom dies all the way to the right so Lis under the Top Die T and you can access the Right Die R Push the handle down to crimp the badge parts in L You don t need to use a lot of pressure Place a pin back in R with the pin side down Also the pin should be closer to the back of the die than the front Slide the bottom dies all the way to the left so R is under T Push the handle down again to crimp the badge together Again not a lot of pressure is needed For added efficiency at this point you can load new metal art and clear into L to begin a new badge Slide the bottom dies all the way to the right
Download Pdf Manuals
Related Search