Installation Manual
Contents
1. t he devicei s unable tor egister onto the network Please ensure the sim card isi nserted correctly And that the sim card is valid and activated In case there is a pin on the device please ensure that the pin is removed this can be done when a sim card is inserted in a phone by accessing the security menu means that the device is able to geta current GPS location means that the device is unable to get a current GPS fix Please check the antenna location and ensure that it has a clear view of the sky RED LED YELLOW LED GREEN LED fleetfinder Ai Further explanation of the LED functionality is described below Power indicator When the unit is powered on using main power the led will be permanently on When the main poweris cut the unit will switch to backup battery mode the led will flash until the backup battery runs out of power Troubleshooting Check that you have a valid 12V or 24V source connected to the device The RED wire should be connected to the positive terminal and the Black wire should be connected to the Ground terminal If there is power applied to these wires please check the inline fuse GSM GPRS indicator The yellow LED will flash when the device is connected to the tracking server with a valid GPRS connection It will stay on continually when it is in sms mode only or when the GSM is present but invalid APN username and password have been set Troubleshooting Ifthe YELL2. OW lightis noton atall please ensure the GSM antenna is connected and that the sim card is properly inserted with the gold terminals facing the circuit board Please ensure the terminals are clean and the sim card clips into place appropriately If this fails please put the sim card into a phone and make sure that it is registered and that you are able to senda message from the phone Please ensure the sim pin on the sim card has been disabled this can be done in the security settings in a mobile phone If the yellow lightis on but not flashing please ensure that you have the correct APN username and password set for the network The APNis usually different for each network provider and can be found by calling the telecommunications provider some telecommunications providers require a username and password to be declared please ensure that you have these details The APN username and password can be set only from the primary defined phone number please refer to the Users Manual for setting primary identity The primary phone needs to send commands for setting the APN username and password these commands can be found in the command list in the users manual GPS indicator This LED will stay on when there is a valid GPS fix When there is no GPS reception the led will not be lit Troubleshooting Please ensure that the GPS antenna gold connector is connected and that it is mounted in a suitable spot with clear view of the sky
3. The vehicle must be outside to be able to get a GPS fix fleetfinder Fuel Calibrator Connections Red Connect to Fuel sense wire Connect to fleetfinder Black Connect to GND Troubleshooting Note The input voltage range is 0 3 3V max If the Voltage is above 3 3V please use J1 to reduce the voltage to max 3 3V Most Fuel tanks work on a 180 Ohm signals and this can be measured on the output wire ofthe Fueltankin relevance to a GND With this device the maxinum voltage is 1 7V and this is when the signal is at 180 Ohm To measure the voltage range please use a Multimeter with the Voltage setting Connect the Black lead to the Black wire and the RED lead to the White wire On a full tank the Voltage should be 0 01V approx and on an empty tank the Voltage should be 1 7V approx fleetfinder Fuel Sensor Map Fuel Gauge CAR U max U min AD Input White A Fleetminde Calibrator Fuel Tank 0 3 3V Black GND Fuel Meter
4. be located as far away from other electronic devices as possible Eg Radio ECU Please note If the unit is close to the radio it may get GSM signal feedback through the stereo system The wiring has to be close to a power supply otherwise the wires may need to be extended Suggested installation locations include under the dash but away from the stereo or the ECU or in the Boot away from speakers or any other electronic equipment Please ensure that the unit is kept away from a moist and dusty environment Fit the GPS GSM antenna in a suitable location Keeping in mind that the Antenna needs a clear view of the sky and can t be obstructed by metal e A good location is far under the dash next to heater vents or on the rear parcel shelf for stealth hide the GPS antenna Make sure that the cable does not get crimped during installation e Make sure there is enough cable length to reach the unit Connect the purple connector from the GPS antenna to the purple connector on the unit making sure it is secured Connect the GSM antenna to the unit The blue connector on the unit is reserved for the GSM antenna Install a suitable place for the Panic switch In most cases the switch is located on the kick panel Please ensure the location will avoid accidental triggering Run the Black wire to a good ground location e Usually the car body is an earth so a good metal bracket is suitable Test the eart
5. fleetfinder Lat LL Installation Manual Australia 1300 1 fleet 35338 Outside Australia 61 8 9383 7833 Website www fleetminder com au Tracking URL http tracking fleetminder com au fleetfinder These instructions are to be followed Step by Step by ONLY a gualified installer iF Parts should include 2 f leetfinder Installation Manual Before commencing installation please insure that all the parts are in the box supplied If the parts are not there please do not commence installation as this will mean revisiting the install more than once 1 x fleetfinder Gold unit 1 1 x GPS GSM antenna 2 1 x fleetfinder GOLD Screen 3 1 x Screen interface cable 4 1 x Wiring harness 5 1 x Screen stand mount 6 1 x Screen charger 7 1 x owner s manual 8 1 x Help switch 9 1 x Diagnostic LED 10 1 x Temp sensor cable 11 1 x Fuel sensor cable 12 1 x RFID scanner 13 2 x RFID cards 14 1 x Backup battery 15 Insert the SIM card in the SIM card slot at the bottom of the unit Make sure to secure the cover with the provided screw The SIM card should have gold terminals connected to gold contacts of the unit If using the Online tracking feature the SIM card must be GPRS enabled Contact the SIM card provider for details f leetfinder Find a suitable location for the Device e For installation and troubleshooting the 3 LED indicators should be visible Keeping in mind that the unit should
6. h is solid using a Multimeter e Make sure it does not change state when the IGN is turned on or when the lights are turned on Some vehicles change state from ground to 12V on some wires when the lights are turned on P2 fleetfi nder COLE 8 Run the YELLOW wire to an IGN trigger if online tracking is reguired e If online tracking is required Input 1 is reserved for IGN trigger e Run the YELLOW wire to an IGN trigger which has to be 12V or 24V Can be found on the ignition switch Note Use IGN wire that does not drop from 12V under crank condition 9 Connect other Inputs and Outputs to their desired triggers before connect ing the Red wire to 12V or 24V Please refer to the wiring diagram for further wiring colours e The outputs are all Negative Triggers GND and are rated to 300mA max In most cases relays will have to be used for the Outputs e Suggested Outputs are Door Unlock Flash Lights Disable Starter Motor Input 1 and 3 are both Positive trigger 12V or 24V and Input 2 is Negative GND trigger e Suggested inputs are Input 1 IGN Input 2 ALARM Input 3 Park Lights Using the Screen connection loom connect the red plug to the RED port on the fleetfinder GOLD device picture Then Attach the silver mini USB port to the port on the screen picture making sure it is secured and will not get disconnected 10 Connect the RED wire to 12V or 24V 11 Connect the Wiring harness to t
7. he device to turn the fleetfinder GOLD ON e Watch the LED s on the side of the unit to see the state of the device Please refer to the LED state explanation form for reference Note The YELLOW and GREEN LED s will not be on until the system goes to full working mode normally 30 seconds after power on Please refer to page 6 for more information 12 To test that the device is working correctly move the vehicle outside ensuring that the GPS antenna has a clear view of the sky P3 fleetfinde Lat 3 CI For Online tracking the LED indicator should show RED ON YELLOW FLASHING GREEN ON e For GSM SMS tracking the LED indicators should show RED ON YELLOW ON Green ON Once the power is connected to the fleetfinder GOLD device the RED LED should light up on the screen indicating there is a solid connection Turn the screen ON using the switch at the top left of the device pictured The GREEN LED will light up indicating the screen is powered on For testing of the device monitor the symbols displayed at the top left of the screen pictured The explanation of the symbols is below Will be empty when there is no connection with the GOLD device Will be Yellow indicating FULL when there is a solid connection from the screen to the main device Will be gray when there is no connection between the main device il and the screen ESF Will be lit up when there is a good connectio
8. n between the screen and the main device There is a bar graph showing the signal strength for GSM Will be gray when there is no connection between the main device S and the screen or there is no GPRS network available le Will be lit up orange when there is a connection to the servers through the GPRS network Will be gray when there is no connection between the main device a and the screen or there is no GPS signal GP Will be lit up Blue when the device has a solid GPS signal and will indicate the amount of satellites that the GPS antenna can communicate with YALYVLS e e E ggl e e ou ij 42219 109 Jepuyjooy Woy M Karp 18 AFCIZL3 125511 mdu1 ayy AHMIS 10d INO NY GAA SAM 43193NNO9 LON EIN LA 19651 UORIUB Moie Spil Tue esind 4109 Jepuyjeey Buisn WI 100 1011235 21549 Joel 9sind I indino wunne ebueIO LIN HONOYHL TIIM HOLOW YALYVIS spiAOl Tue _ esind L INAINC WWOCE ABID ndino WWwOOE ong 21049 Ju 77 esind AN9 106611 7 ndu umoig g M INO wunne uai ej49 June 7 esind 21949 ju9 e7 77 esind 439195 UOHeEHIAEN 709 pup G INAINO vunn odp 9 INAINO vunn PaN AHUM ej49 Tue esind See Arc 10 ACL A M ND WWOOE MOJA Umo 8
9. oF OF sail YOSNAS 9 IWNOILdO Li etoijsfehotojt EE agavad GYVS GI 402 1109 AKA NA el JaPUL INJINI cay USD BULIAMM l mz R JOPULj 29 fleetfinder 13 Start tracking e On line Tracking If online tracking was ordered with the device it should already be set up to start monitoring the location Refer to your service agreement which will include your username password and the software link The following LED conditions described below determine the unit operation On solid state On solid state state unit powered by main power RED LED Flashing Flashing On but not flashing YELLOW LED GREEN LED unit operating under backup battery check vehicle power supply jon E there is no power to the unit check fuse and jon eei of the red and black wires means unit isr egisteredo n the network and connected to the tracking Server means the unit is registered on the network but not connected via GPRS check APN username and password refer network p roviderf ort he APN username and password APN setting correct but still not flashing means that there is no credit on the account if pre paid is used ort he accounti s disabled check w ith network provider t o ensure the billi s upto date Te troubleshoot remove the sim card from the device and put it ina phone Try to send a message If the problem persists p lease call your F leetminder means
Download Pdf Manuals
Related Search