DMX 1500W STROBE NE
Contents
1. input and output 3XLR connector Control signal cable must connect to the corresponding 3 pin XLR connector when outputting 1 earth 2 3 Or exchange solder 2 and 3 the length of the signal cable should within 100m prevent the interference of other appliance because of the over long signal cable 2 Setting of the IP code This light must be controlled by DMX512 All the light of this model must be set a digital start IP code easy for corresponding light and corresponding control signal have function This digital start address is the frequency phase code the start of the light is obey to the digital control signal which sent by the console This light has 2 digital control2. frequency phase at present The address range is 1 512 Channel 2 off brightness adjustment CUO Channel 1 Flash speed ADDRESS ee deke e fo DMX 1500W STROBE fofofofofofolo o o Pon fsfefa el se ae oe 125 256 s12 NE 026 Setting of function Function 1 2 9 10 DMX512 ADDRESS OFF Dae USER MANUAL aca OFF NO USE ON Light control iia ON NO USE ON Light control Trl ray LUET SLLTTT Ty Technology Parameter 1 Voltage AC 220V 10 50 60Hz 2 Rated Power 1800W 3 Fuse 15A 4 Lamp 1500W 5 Size 520x225x320mm 6 NW 4Kg 7 GW 4 6Kg Guangzhou Yinhe Lighting amp Sound Equipment Factory Index 1 Introduction 2 Warning 3 Operation 4 Parameter 5 Maintenance Introduction 1500W digital strobe this light has 3 work methods DMX receive automatic and controller control Suit use in any entertainment place Features Use 1500W high quality flash tube high brightness DMX 51 2control 2 DMX channels brightness flash speed DIP function and address selection switch Warning 1 Please read this brochure carefully before your operation Please obey the operation index and keep it well 2 It suit use indoor the light should be placed at the aeration place to avoid short circuit by the moisture and rain 3 Please power off when cleaning the light 4 Never install the light close to the hot place to avoid increase the
3. temperature of the light to damage the light 5 Never jam the airy hole make sure the aeration and cooling well 6 Light must connect to the power which have the earth line the power supply should be accordance with the rated voltage of the light 7 Never insert the irrelative goods to avoid the goods touch the high voltage part to lead the part short circuit and fire or shock accident influence the normal work of the light 8 You must ask the professional for maintenance if you meet some problem Operation Stand alone operation Set the DIP 10 at ON DIP 1 at OFF connect to the power adjusting the 2 button of the brightness and speed to the suitable position Controller operation Connect the signal cable according to the following diagram set the DIP 10 and DIP tat the ON position at the same time Connect to the power adjusting the brightness of the light then you can use the controller adjust the flash speed of the light Various strobes connect in a line up to a synchronous effect DMX controller operation Connect the signal cable according to the following diagram set the DIP 1 at ON set the DIP 10 at OFF set the IP code connect to the power then use the controller adjust the flash speed and brightness of the light Various strobes connect in a line up to a synchronous effect DMX controller OUT DMX 1 Connection of DMX 512 Controller have output DMX512 signal standard Connect via the
Download Pdf Manuals
Related Search