ENER271 user guide
Contents
1. end Technical Information e Voltage 12V DC e IP20 Suitable for bathrooms Moisture amp water resistant e LED roll 240 e LED colour warm white 3000K e Wattage 19 2W roll e LED type SMD3528 e Beam angle 120 e Working temperature 20 to 75 Contents e 4m LED strip roll IP65 with adhesive tape e 1 x mains AC adapter delivering 12V DC to the strip e 3 x pre wired connector sets e 1x dimmer unit Model No ENER271 www energenie4u co uk Energenie is a trading name of Sandal plc Claremont House Deans Court Bicester Oxon OX26 6BW CE X Made in China2. your switch is my command ENERGEN E 2 Custom Fit LED Lighting complete kit for DIY installation 4m with 3x connector sets dimmer amp driver The LED strip may be cut up into 4 separate segments and connected in series to the power supply using the pre wired connector sets 1 Setting up Connect the LED strip to the dimmer and then connect the dimmer to the AC adapter as shown below Then plug the driver into a mains power source The LED strip will illuminate TT Di AC adaptor Fotos ee E a 2 Using the dimmer There are 3 buttons on the dimmer e Flash 5 flash modes press to choose from slow to fast Dim 8 dimming levels press to choose from dim to bright e Cancel exit Flash mode by pressing the Cancel button 3 Cutting and connecting the LED strip e Measure out each section and cut carefully by the cutting mark on the strip with sharp scissors Cut as close to the copper pads as possible to ensure better connectivity ee it e Carefully use a sharp knife to remove the protective gel from around the metal soldering joint e Insert the LED strip into the connector as shown below The cable contacts should sit centrally on the copper pads e The correct contacts need to be at the correct polarity This is marked on the strip with the markings and These need to be connected to the same markings on the cable connector e Close the connector lid and press firmly to seal Repeat at other
Download Pdf Manuals
Related Search