USER GUIDE - Fisher Security
Contents
1. Your new code can be ANY four digit code you choose Two Bleeps from Sounder TO TEST BELLS 0 oc The system must be in Day before starting the test The external and internal sounders will operate for three seconds and then the strobe will operate for three seconds The system will then return to Day TO WALK TEST o om 0000 When you have completed the sequence shown on the left the internal sounder will emit a steady tone You can now test the operation of the Exit Entry zone Zones 1 2 and 3 Each time a zone is opened the internal sounder will emit a pulsing tone You cannot test the Tamper Circuits or the Panic Buttons without creating an alarm condition To stop walk test key in your access code Installer 495674 OCT 91 Issue 12. 9448 USER GUIDE TO FULL SET Key in your four digit user code The exit tone will start Leave premises via the designated exit door Tone will stop after preset time The alarm system will then be SET TO PART SET oT And Or ao Followed Your alarm system may have been installed to allow you to to have part of the premises set while other area s are off thereby allowing free access within the off area s and alarm protection in the set areas To set the system with area 2 and or 3 omitted proceed as shown Note that the exit tone is auto matically reduced by one third so as not to disturb sleeping occupants when part setting the system TO SWITCH OFF Enter via Go to designated control panel route FULL SET Enter by the designated entry door Entry tone will start Go to control panel and key in your four digit access code System will return to DAY PART SET To switch off the system when Part Set enter area entry tone will start go to control panel and key in your four digit access code System will return to DAY Note If you exceed half the programmed entry time the internal sounder will emit an internal alarm tone go to control panel and key in your access code to stop sounder and return system to Day IF A ZONE LIGHT ILLUMINATES WHILE SETTING Zone x Plus Interrupted Exit Tone Investigate cause and restart setting sequence If you are setting or part setting the system an
3. d the sounder emits an interrupted tone an open zone is indicated e g an open door etc The appropriate zone light will also be illuminated Check and eliminate cause then re enter code If fault persists call engineer If the Entry Exit light is illuminated you may have the exit door open while setting In this case leave the premises the open zone condition will automatically be cancelled when the door is closed More Overleaf USER GUIDE 9448 USER GUIDE TO RESET AFTER AN ALARM Enter Go To Control Building Panel Zone Day e amp either Tamper Panic To reset system reset any panic buttons activated then Alarm when set When an alarm occurs with the system either Fully Set or Part Set go to control panel and key in your four digit access code The panel Day light and the light s associated with the alarm condition will be illuminated Reset system To reset the system key in your access code again The Day light only will be illuminated Tamper Alarm If you hear the internal sounder with the system off Day go to control panel The Tamper light will be illuminated Key in your access code to stop the sounder Call your alarm installer for service Panic Alarm Tocancela Panic Alarm first reset the panic button then key in your four digit access code TO CHANGE YOUR ACCESS CODE Gm ep G enter ES Old Four Digit code ap u a EE The New Four Digit Code ENTER Sam Dp Gy
Download Pdf Manuals
Related Search