USER MANUAL OF WIRELESS OUTDOOR SIREN
Contents
1. USER MANUAL OF WIRELESS OUTDOOR SIREN 1 Control Panel Programming Specific programming pls refer to manual of the control panel Wireless ID number of this siren please see at the back of battery cover 2 Indication Of Wireless Siren 1 Please charge the battery at least 24 hours when first used This siren has circuits protection to resist overcharge and over discharge 2 The siren was programmed by control panel only receiving order from control panel it can start working 3 When powered on and turn the BAT switch to ON the siren is in self check status two LEDs flash fast atthe same time Press anti tamper switch LEDs will flash 5 times slowly and then flash alternately 4 In standby status the siren alerts when it is moved away 5 LEDs are always on when in trouble Such as low battery or the DAT switch was not ON or the AC power supply is lost 3 e Setting of Wireless Siren 1 Choose the alarm type by Type switch pls refer to installation diagram Type switch supports 4 alarm types as follow 1 2 Alarm types OFF OFF Buzzer sounds LEDs flash continuously alarm Factory default ON OFF Buzzer doesn t sound LEDs flash OFF ON Buzzer sounds LEDs do not flash ON ON Buzzer sounds LEDs flash discontinuously alarm 2 Choose the alarm time by Time switch pls refer to the diagram of installation Time switch supports 4 alarm time as follow 12. 2 Alarm time ON ON 1 minute OFF OFF 5 minutes Factory default OFF ON 15 minutes ON OFF 30 minutes gt The specification of the siren Power adapter 100 240V 50 60Hz Wireless working range 120 meters open space Stand by current lt 45mA Battery fully charged Rechargeable Battery 7 2V 600mAh nicel hydrogen cell Buzzer time Programmed via control panel 30 minutes at most SPL gt 105dB 30cm Installation place Indoor and Outdoor IP55 Battery standby time gt 8hrs fully charged Working temperature 20 C 55 C Frequency 433 MHz 868MHz Dimension 280 188 70mm Notice Sound of siren and types of flash are a little different with external power supply and backup battery 5 Installation Diagram 1 Take off the installation base as below gt ee 0 E l Back Shell i Front Shell mO P 2 Open the back cover connect the wire and set up the function then close the back cover Y 0 ir hia A WV 7 SY k l IF o f Anti tamper P Switch j Lo A G j Lamp housg oe res iD J berish 4 ireless ID number is here t 4 pa A l bam Ths oi instalation base U 3 Fix
3. the installation base on wall by screws 4 Hold the siren and slid it down to the installation base Glide J 5 Then fix siren and installation base by screw 6 Finish Notice Please install the siren at the place beyond people s touch
Download Pdf Manuals
Related Search