Installation and Operating Instructions
Contents
1. The cable is already terminated to the internal wiring in the luminaire and is supplied ready for use All dimensions in mm unless stated otherwise Subject to change without prior notice 03 14 F H Papenmeier GmbH amp Co KG division Lumiglas Talweg 2 58239 Schwerte GERMANY phone 49 2304 205 0 fax 49 2304 205 206 info lumi papenmeier de www lumiglas de Lumiglas 0093 032 00 c CE Lumistar Luminaire Crescent Design ME e Fitting a new or different connecting cable Select a connecting cable which is suitable for the operating conditions The diameter of the cable should be the same as that of the cable gland Remove the reflector Insulate the cable ends Insert the cable through the cable gland into the lamp chamber and wire to the terminals or push on blades leading the protective earth along the housing wall Tighten the cable gland Re install the reflector It is easier to carry out the connection process if the fila ment lamp is first removed The user then has more space and damage to the lamp is prevented e Changing the lamp Caution Before opening the luminaire check that it is not too hot Disconnect the luminaire from the power supply Tip By loosening the cable gland slightly it is easier to work on the luminaire as the internal wiring then has more space Tighten again once the lamp has been replaced Open the cover and pull it out together with the ins2. Installation and Operating Instructions Lumistar Luminaire Crescent Design ME 65 ME 80 ME 100 ME 125 Stainless Steel For applications with a combined sight and light port Suitable for circular screw type sight glass fittings according to DIN 11851 or similar e Important please note If it is intended to retrofit the Lumistar Luminaire Crescent Design ME to an already existing screwed sight glass fitting the slotted cover nut should be ordered as well otherwise the existing one will need to be adapted accor dingly see bore diameter d 8 referred to in DIN 11851 Mechanical installation Caution Do not look into light danger of impaired eyesight Loosen the slotted cover nut on the screwed sight glass fitting Pass the slotted cover nut over the connecting cable and luminaire housing Make sure that the sight glass disk is correctly seated in the fitting Focus the luminaire by aligning the centring feature on the bead and the opening in the slotted cover nut see drawing Screw the slotted cover nut onto the weld on neck with the luminaire in position Centring point e Caution Do not establish the electrical connections until the mechanical installation has been completed e Electrical connection Lumistar Luminaires Crescent Design ME are works fitted with a 3 m cable tail Lapptherm 105 up to 90 C 194 F The cable is firmly connected to the luminaire by way of the cable gland
3. talled lamp holder and the defective filament lamp Remove the defective lamp Using a protective cloth to hold the new filament lamp insert it carefully into the 2 pin socket and push it into place Replace the cover with lamp holder and new filament lamp check that the cables are in the correct position before screwing on the cover Tighten the cable gland once the lamp has been replaced Reconnect the power supply P APENMEIER
Download Pdf Manuals
Related Search