Kenroy Home 32398ORB Installation Guide
Contents
1. LESS EFFICIENT REPEATED CHARGE AND DISCHARGE CYCLES THE CAPACITY OF THE BATTERIES MAY REDUCE OVER TIME IF YOU FIND THAT THE BATTERIES APPEAR LESS EFFICIENT TRY TO BOOST CHARGE IT TO DO THIS TURN OFF THE LED LIGHT USE THE TRANSFORMER THE BATIERIES FOR 4 5 WE RECOMMEND THAT YOU DO THIS OCCASIONALLY TO HELP PROLONG THE LIFE OF BATIERIES IF YOUR STILL DOES NOT WORK WELL AFTER THIS BOOST CHARGE YOU SHOULD REPLACE THE BATTERIES AFTER THE BATTERIES USED FOR 12 18 MONTHS IT MAY HAVE REACHED IT S SERVICE LIFE YOU SHOULD REPLACE THE BATTERY 323980RB INSTRUCTIONS2. ECTOR INTO THE INPUT JACK IN BOTTOM OF THE SOLAR DISC 2 PLUG THE TRANSFORMER INTO A SOCKET AND TURN ON AT SWITCH YOUR LAMP IS READY FOR USE 3 IF YOUR LED LIGHT DOES NOT WORK CHECK THE CONNECTOR IS INSERTED INTO THE INPUT JACK 4 IF THE LED LIGHT STILL DOES NOT WORK PLEASE CONTACT YOUR DISTRIBUTOR OR PLACE OF PURCHASE IF OPTIONAL TRANSFORMER IS DESIRED PLEASE SEE INSTUCTIONS 5 BELOW 1 ALTHOUGH THERE MAY BE SOME INITIAL CHARGE IN BATTERIES WE RECOMMEND FULLY CHARGING FIRST USE TURN OFF THE LED LIGHT AND LEAVE THE SOLAR DISC IN GOOD SUNLIGHT FOR 22 HOURS TO ENSURE THE FULLY CHARGED THE OTHER IS USE THE TRANSFORMER TO CHARGE THE BATTERIES FOR 4 HOURS BEFORE FIRST USE 2 THE FULL RUN TIME OF THE LED LIGHT IS 6 HOURS WHEN THE BATTERIES ARE FULLY CHARGED 3 TO GET BEST PERFORMANCE FROM THE SOLAR DISC IN THE SUNSHINE PLEASE MAKE SURE THAT YOU PERIODICALLY CLEAN THE TOP SURFACE OF THE SOLAR DISC DO NOT USE A CHEMICAL SOLVENT 4 TURN ON THE LED LIGHT AT SWITCH YOUR LAMP IS READY FOR USE 5 IF YOUR LED LIGHT DOES NOT CHECK THE SOLAR DISC 15 RECEIVING SUNLIGHT DIRECTLY AND NOT IN SHADOW 6 IF THE LED LIGHT STILL DOES NOT WORK PLEASE CONTACT YOUR DISTRIBUTOR OR PLACE OF PURCHASE CLEANING THE SHADE WASH THE SHADE WITH A SOFT BRUSH AND MILD DETERGENT SUCH AS DISHWASHING SOAP AND THEN THOROUGHLY RINSED BATTERY INFORMATIONS
3. MODEL 525980 BOX 2 TWIGS ASSEMBLY DISC SOLARDISCPORT REPLACEMENT PART SHADE 32398SHORB REPLACEMENT PART IPPLE POLE TwIGS ASSEMBLY OWER POLE BASE SOLARDISCTRANS AVAILABLE 5 323985 SOLARDISCPORT SOLAR DISC SOLARDISCBATT TWO BATTERIES SOLARDISCTRANS TRANSFORMER 03 2014 ASSEMBLY 5 READ AND 5 THESE 5 READ INSTRUCTIONS ALL THE WAY THROUGH PRIOR TO ASSEMBLY THIS LAMP SHOULD TAKE APPROXIMATELY 5 MINUTES TO ASSEMBLE MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED UNPACK THE LAMP YOU SHOULD HAVE THE FOLLOWING PARTS IN THE PACKAGE SOLAR DISC SHADE FINIAL TIWGS ASSEMBLY UPPER POLE LOWER POLE BASE AND TRANSFORMER TO PROTECT THE FINISH PLACE ALL PARTS ON A SOFT SURFACE ASSEMBLE THE LAMP 1 SCREW THE LOWER POLE TO TOP OF THE BASE 2 SCREW THE UPPER POLE TO TOP OF THE LOWER POLE 3 SCREW THE TWIGS ASSEMBLY TO TOP OF THE UPPER POLE 4 PLACE THE SHADE OVER THE NIPPLE ON TOP OF THE TWIGS ASSEMBLY AND SECURE WITH THE FINIAL 5 PLACE THE SOLAR DISC INTO THE SOLAR DISC HOLDER IF OPTIONAL TRANSFORMER IS BEING USED PLEASE SEE INSTUCTIONS AS BELOW 1 INSERT THE CONN
Download Pdf Manuals
Related Search