Marantec 115702 Installation Guide
Contents
1. all the buttons you desire to use 5 Changing the Code on Transmitters Figure 4 The transmitter factory preset code can be changes as follows a Connect the programming connector into the lateral socket of the transmitter to change the code Short one of the outer pins of the programming connector with the middle pin Press and hold the respective channel button The light will blink rapidly for approx 5 sec Release the button after the light illuminates continuously Then remove the programming connector Figure 4 Code Changing Note For multi button transmitters be sure to carry out this procedure for all the buttons you desire to use FCC Certified This device complies with Port 15 of the FCC rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment 65895 2010 All rights reserved 2 10 ENG2. Transmitters Instructions continued 4 Multiple Transmitters Figure 3 Figure 3 Multiple Transmitters Code Transfer Each transmitter comes factory programmed with random codes 2 channel transmitters have 2 different random codes fig 3A Raui one per button 3 channel transmitters have 3 different random a lt a Tegneinitier with active Code codes and 4 channel transmitters have 4 different random Programming QS codes one per button Transmitters that are purchased Connector gh So separately as accessories have random codes that must be changed in order to match the code of the active transmitter which you are alredy using Below are instructions for transferring an active code from a button on one transmitter to a button of your choice on another transmitter new Transmitter Connect the transmitter with active code to the new transmitter using the programming connector fig 3A Press and hold the selected channel button on the transmitter with the active code fig 3B The light in the transmitter illuminates Press and hold the respective channel button on the new transmitter fig 3C The light in the transmitter initially starts blinking and then illuminates continuously after 1 2 sec Code transfer is completed u Programming connector can be removed and both transmitters can now be used to operate the same door Note For multi button transmitters be sure to carry out this procedure for
Download Pdf Manuals
Related Search