Home
Husky H4870 Instructions / Assembly
Contents
1. Operation 1 Operating the sander 2 Installing the sanding pad This Dual Action Sander is designed to operate on 90 PSIG WARNING Disconnect the tool from the air source before Lower pressure below 90 PSIG will reduce performance servicing or changing any accessories of the tool CAUTION Higher air pressure over 90 PSIG raises WARNING Always use the sanding discs with the rated A the performance of the tool beyond its rated capacity oi iHi and could cause serious damage to the tool and the Use the spanner wrench C to loosen the bearing seat from user the sander A Lock the drive spindle in place before attaching the sanding pad B Rotate the spindle lock until the spindle lock engages with the drive spindle Hand tighten the sanding pad B in a clockwise direction Bo 3 Removing the sanding pad 4 Sanding surfaces WARNING Disconnect the tool from the air source before WARNING You must wear ANSI approved eye protection servicing or changing any accessories AN during the operation failure to follow this may result in serious injury or damage to the operator Use the open spanner wrench C to secure the bearing seat then use your hand to loosen and remove the sanding pad B Connect the air source and run the tool WARNING Hearing protection is strongly recommended A protective
2. respirator is recommended Do not operate the tool with the spindle locked or the sander will stall when pressure is applied to the pad Always use the correct grit practical for the sanding operation
Download Pdf Manuals
Related Search
Related Contents
放射温度計 「サークルサーモ」 User manual DEGA NSx-yL III LCD Westinghouse A19 Specification Sheet Setup and User Guide for Vexve AM40 Heating and Cooling Liquid Fence HG-70261 Instructions / Assembly HP Photosmart C4280 REQUISITOS ESENCIALES DE SEGURIDAD National Instruments NI-FBUS User's Manual RIF 1769-DPM RCA J13805CL User's Manual Copyright © All rights reserved.
Failed to retrieve file